ページ10に含まれる内容の要旨
a. Hold blade control against upper handle. b. Pull starter rope out of the engine. Release blade control handle. c. Slip starter rope into rope guide. d. Tighten wing nut. 4. Insert post on cable ties into holes provided on the lower handle. Pull cable tie tight and trim excess. A Grass Catcher 1. Follow steps below to assemble the grass catcher (if needed). Make certain bag is turned right side out before assembling (warning label will be on the outside). a. Place bag over frame so that
ページ11に含まれる内容の要旨
Side Discharge Chute Adjustments To convert to side discharge, make sure grass catcher is off of the Cutting Height unit, the rear mulch plug is removed, and rear discharge door is closed. 1. The cutting height adjustment lever is located above the rear left wheel. See Fig. 3-8. 1. On the side of the mower, lift the mulching plug. 2. Slide chute hooks under hinge pin on mulching plug assembly. Lower mulching plug. See Fig. 3-7. Do not remove side mulching plug at any time, even when you are
ページ12に含まれる内容の要旨
Controls and Features 4 Drive Control Blade Control Recoil Starter Cutting Height Adjustment Lever Side Discharge Chute Mulch Plug Figure 4-1 Recoil Starter Blade Control The recoil starter is attached to the right upper handle. Stand The blade control is attached to the upper handle of the mower. behind the unit and pull the recoil starter rope to start the unit. Depress and squeeze it against the upper handle to operate the unit. Release it to stop engine and blade. Side Discharge Chute W
ページ13に含まれる内容の要旨
Operation 5 Starting Engine WARNING: Be sure no one other than the operator is standing near the lawn mower while starting engine or operating mower. Never run engine indoors or in enclosed, poorly ventilated areas. 1 Engine exhaust contains carbon monoxide, an odorless and deadly gas. Keep hands, feet, hair and loose clothing away from any moving parts on engine and lawn mower. 1. Standing behind the mower, squeeze and hold the blade control against upper handle. 2. Pull the recoil star
ページ14に含まれる内容の要旨
Maintenance & Adjustments 6 4. The transmission is pre-lubricated and sealed at the factory Maintenance and does not require lubrication. General Recommendations 5. Follow the Maintenance section in the engine manual for lubrication schedule and instruction for engine lubrication. • Always observe safety rules when performing any maintenance. Deck Care • The warranty on this lawn mower does not cover items that Clean underside of the mower deck after each use to prevent have been subjected
ページ15に含まれる内容の要旨
Replacing Rear Flap Adjustments 1. To remove rear flap, lift rear door, and remove screw on Drive Cable either side to remove from hole. See Fig. 6-2. Your unit is equipped with an adjustable drive cable to adjust 2. Remove screw and flap from opposite hole and replace the tension on the drive cable. You will need to adjust the drive with new flap in the opposite order and manner of cable if the mower does not propel itself with the drive control removal. engaged or if the mower’s wheels h
ページ16に含まれる内容の要旨
Service 7 5. Lubricate the engine crankshaft and the inner surface of Blade Care the blade adapter with light oil. Slide the blade adapter WARNING: When removing the cutting blade for onto the engine crankshaft. Place the blade on the adapter sharpening or replacement, protect your hands with such that the side of the blade marked “Bottom” (or with part number) faces the ground when the mower is in the a pair of heavy gloves or use a heavy rag to hold the operating position. Make sure that
ページ17に含まれる内容の要旨
c. Working from the rear of the mower, carefully Off-Season Storage remove belt from transmission pulley. See Fig. 7-3. The following steps should be taken to prepare your lawn mower d. Once belt is off transmission pulley, push down on for storage. deck baffle to access engine pulley and slide belt off • Clean and lubricate mower thoroughly as described in the this pulley and out from under the deck. See Fig. 7-3. lubrication instructions. • Do not use a pressure washer or garden hose to c
ページ18に含まれる内容の要旨
Troubleshooting 8 Problem Cause Remedy Engine Fails to start 1. Blade control disengaged. 1. Engage blade control. 2. Spark plug boot disconnected. 2. Connect wire to spark boot. 3. Fuel tank empty or stale fuel. 3. Fill tank with clean, fresh gasoline. 4. Engine not primed (if equipped with primer). 4. Prime engine as instructed in the Operation section. 5. Faulty spark plug. 5. Clean, adjust gap, or replace. 6. Blocked fuel line. 6. Clean fuel line. 7. Engine flooded. 7. Wait a few minutes to
ページ19に含まれる内容の要旨
Problem Cause Remedy Uneven cut 1. Wheels not positioned correctly. 1. Place all four wheels in same height position (if equipped with individual height adjusters). 2. Dull blade. 2. Sharpen or replace blade. Mower will not self propel 1. Belt not installed properly. 1. Check belt for proper pulley installation and movement. 2. Debris clogging drive operation. 2. Stop engine, disconnect spark plug boot, and clean out debris. 3. Damaged or worn belt. 3. Inspect and replace belt. Scetion 8 — t
ページ20に含まれる内容の要旨
Replacement Parts & Accessories 9 Component Part Number and Description 951-10292 Spark Plug 951-10298 Air Cleaner Kit 951-10300 Fuel Cap Assembly 951-10358A Fuel Filter 634-04346 Wheel (Front) 934-04348 Wheel (Rear) 731-04177 Side Discharge Chute 964-04066 Grass Bag Phone (877) 282-8684 for your nearest Cub Cadet Dealer to order replacement parts or a complete Parts Manual (have your full model number and serial number ready). Parts Manual downloads are also available
ページ1に含まれる内容の要旨
Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
Otraep Or ’s Mlauna
Self Propelled Mower — Model CC 550 SP
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL
BEFORE ATTEMPTING TO OPERATE THIS MACHINE.
FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
CUB CADET LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
Printed In USA Form No. 769-07549
(December 19, 2011)
ページ2に含まれる内容の要旨
To The Owner 1 Thank You Thank you for purchasing a Lawn Mower manufactured by If applicable, the power testing information used to establish Cub Cadet. It was carefully engineered to provide excellent the power rating of the engine equipped on this machine can be performance when properly operated and maintained. found at www.opei.org or the engine manufacturer’s web site. Please read this entire manual prior to operating the equipment. If you have any problems or questions concerning the
ページ3に含まれる内容の要旨
Important Safe Operation Practices 2 WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol. HEED ITS WARNING! CALIFORNIA PROPOSITION 65 WARNING: Engine Exhaust, some of its constituents, and certain v
ページ4に含まれる内容の要旨
12. A missing or damaged discharge cover can cause blade 27. When starting engine, pull cord slowly until resistance contact or thrown object injuries. is felt, then pull rapidly. Rapid retraction of starter cord (kickback) will pull hand and arm toward engine faster than 13. Many injuries occur as a result of the mower being pulled you can let go. Broken bones, fractures, bruises or sprains over the foot during a fall caused by slipping or tripping. could result. Do not hold on to the mow
ページ5に含まれる内容の要旨
3. Check the blade and engine mounting bolts at frequent Service intervals for proper tightness. Also, visually inspect blade for damage (e.g., bent, cracked, worn) Replace blade with Safe Handling Of Gasoline: the original equipment manufacture’s (O.E.M.) blade only, 1. To avoid personal injury or property damage use extreme listed in this manual. “Use of parts which do not meet the care in handling gasoline. Gasoline is extremely flammable original equipment specifications may lead to i
ページ6に含まれる内容の要旨
Notice Regarding Emissions Spark Arrestor Engines which are certified to comply with California and federal WARNING: This machine is equipped with an EPA emission regulations for SORE (Small Off Road Equipment) internal combustion engine and should not be used are certified to operate on regular unleaded gasoline, and on or near any unimproved forest-covered, brush may include the following emission control systems: Engine covered or grass-covered land unless the engine’s Modification (E
ページ7に含まれる内容の要旨
Safety Symbols This page depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Symbol Description READ THE OPERATOR’S MANUAL(S) Read, understand, and follow all instructions in the manual(s) before attempting to assemble and operate DANGER — ROTATING BLADES To reduce the risk of injury, keep hands and feet away. Do not operate unless discharge cover or grass catcher is in
ページ8に含まれる内容の要旨
8 Scetion 2 — i anmtport Seaf o tioepnra p rcatiec S 15° dashed line Slope Gauge 15° Slope 15° Slope (OK) (TOO STEEP) Figure 1 Figure 2 USE THIS SLOPE GAUGE TO DETERMINE IF A SLOPE IS TOO STEEP FOR SAFE OPERATION! To check the slope, proceed as follows: 1. Remove this page and fold along the dashed line. 2. Locate a vertical object on or behind the slope (e.g. a pole, building, fence, tree, etc.) 3. Align either side of the slope gauge with the object (See Figure 1 and Figure 2 ). 4. Adjust ga
ページ9に含まれる内容の要旨
Assembly & Set-Up 3 Contents of Carton • One Lawn Mower • One Grass Catcher • One Side Discharge Chute • One Lawn Mower Operator’s Manual • One Engine Operator’s Manual • One Bottle of Oil Assembly NOTE: This unit is shipped without gasoline or oil in the engine. Fill up gasoline and oil as instructed in the Engine Operation section of this manual BEFORE operating your mower. Handle 1. Remove any packing material which may be between upper and lower handles. a. Pull up and back on upper handl
