ページ1に含まれる内容の要旨
™ ™
Alpha 100 and TT 10
Owner’s Manual
May 2013 190-01500-00_0B Printed in Taiwan
ページ2に含まれる内容の要旨
All rights reserved. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Garmin. Garmin reserves the right to change or improve its products and to make changes in the content of this manual without obligation to notify any person or organization of such changes or improvements. Go to www.garmin.com for current updates and supplemental information concerning the use of this product. ® ® ® Garmin , the Garmin logo, BlueChart , and City Na
ページ3に含まれる内容の要旨
Adding a Contact Using the ID................................................... 8 Table of Contents Sending a Message to Your Contacts....................................... 8 Tracking a Contact..................................................................... 8 Getting Started............................................................... 1 Finding Your Contact ID............................................................. 8 Setting Up the Alpha System......................................
ページ4に含まれる内容の要旨
Setting an Alarm...................................................................... 12 Using Optional Fitness Accessories............................... 17 Starting the Countdown Timer................................................. 12 TT 10 Battery Replacement Instructions ............................ 17 Opening the Stopwatch............................................................ 12 TT 10 Components ........................................................ 17 Satellite Page.............
ページ5に含まれる内容の要旨
TT 10 Dog Collar Device Getting Started WARNING See the Important Safety and Product Information guide in the product box for product warnings and other important information. Setting Up the Alpha System NOTICE Avoid using a high-powered radio (greater than 5 watts) in close proximity to the device. It may cause irreversible damage to the device. Before you can use the Alpha handheld device and the TT dog collar device, you must set up the devices. Install the battery in the handheld devic
ページ6に含まれる内容の要旨
4 Press the battery into place. 5 Replace the battery cover, and turn the D-ring clockwise. Charging the Handheld Device NOTICE 2 Plug the small end of the power cable into the mini-USB port To prevent corrosion, thoroughly dry the mini-USB port, the on the charging clip. Á weather cap, and the surrounding area before charging or connecting to a computer. 3 Plug the other end of the power cable into a power source. The status LED is solid red when the collar is charging. You should fully cha
ページ7に含まれる内容の要旨
Enter the name of the dog, and select > OK. 5 Dog Collar Device Setup Finding the Dog ID and Track and Train Codes You can share a dog’s track code so another person can view Methods to Add a Dog to a Handheld Device your dog’s location with the map and dog tracking compass. If you purchased the collar and the handheld device separately, Also, you can share a dog’s train code so another person can you must add the collar to the handheld device. You can add up track your dog and train (corr
ページ8に含まれる内容の要旨
Select a dog. 2 Select Show Info > > Change Dog Type. 3 4 Select a dog type. Changing the Dog ID Before you can change the dog ID, the collar must be turned on and within range of the handheld device. If you are experiencing interference from other collars or handheld devices in the area, you might need to change the ID for the dog. 1 Select Dog List. Select a dog. 2 Select Show Info. 3 If the strap is too long, cut off the excess, leaving at least 3 5 4 Select > Change ID. inches to spare
ページ9に含まれる内容の要旨
dog's status, such as running or on point (page 5). The color of Tracking Your Dog on the Map the pointer corresponds to the color of the dog track. Before you can track a dog or contact on the map, you must The dog tracking compass is most accurate when the dog is add them to the handheld device (page 3 and page 8). more than 30 ft. (9.1 m) away. When the dog is less than 30 ft. You can view the dog's location and other contacts' locations on (9.1 m) away, "Near" appears. the map. Select .
ページ10に含まれる内容の要旨
Select Setup > Location Alerts > Add Alert > Radius. Select Setup > Training > Training Buttons. 1 1 Select the unit of measurement. Select the area at the top of the screen directly below the 2 2 keys. 3 Enter the radius distance, and select . Select the intensity level for the keys. 3 Editing Location Alerts 4 If you are using traditional stimulation mode, select LOW, 1 Select Setup > Location Alerts. MED, or HI. Select an alert. 2 5 Select . Select an option: 3 In this mode, the left key pr
ページ11に含まれる内容の要旨
With plenty of repetition, consistency, patience, and a lot of Teaching your dog to come here is the most important praise, the dog should begin to obey these commands after command. The "here" command allows you to maintain control several lessons. Each dog learns at a different rate, and some of your dog and can be used to call your dog away from a dogs may take longer to learn these commands. After the dog potentially dangerous situation. This command must be taught demonstrates a basic u
ページ12に含まれる内容の要旨
dog as long as the key is held, for a maximum of 8 seconds. Reward the dog with praise as soon as the dog begins to 4 Your stimulations should typically be far shorter than 8 seconds. move toward you. Continuous stimulation can be useful when first starting training If the dog begins to veer away, press a training key briefly, 5 with your dog. and repeat the command to come "here." You can also train using a tone (T). When you select T for a key, the key press activates an audible tone inste
ページ13に含まれる内容の要旨
TIP: Select different light setting for each dog to help you Changing Your Contact ID identify the dogs in the field. If you are experiencing interference from other collars or handheld devices in the area, you might need to change the Turning On Rescue Mode contact ID for your handheld device. You can turn on rescue mode to conserve battery power at the Select Setup > Contacts > Pairing Setup > ID. 1 end of a long hunt or if your dog might get out of range. Select a contact ID that is not y
ページ14に含まれる内容の要旨
Select > Average Location. • To remove the point from the route, select Remove. 3 Move to the waypoint location. 4 Reversing a Route 5 Select Start. Select > Route Planner. 1 6 Follow the on-screen instructions. Select a route. 2 When the confidence status bar reaches 100%, select Save. 7 3 Select Reverse Route. For best results, collect 4 to 8 samples for the waypoint, waiting Viewing a Route on the Map at least 90 minutes between samples. 1 Select > Route Planner. Projecting a Waypoint Sel
ページ15に含まれる内容の要旨
Select TracBack. 2 Map The map page opens with your route marked with a magenta The blue triangle represents your location on the map. As you line. travel, the icon moves and leaves a track log (trail). Waypoint names and symbols appear on the map. When you are Navigate using the map (page 11) or the compass 3 navigating to a destination, your route is marked with a magenta (page 11). line on the map. Changing the Track Color When the map orientation is Track Up, objects on the map Selec
ページ16に含まれる内容の要旨
To open the trip computer, select > Trip Computer. Where To? Menu You can use the Where To? menu to find a destination to Resetting the Trip Computer navigate to. Not all Where To? categories are available in all For accurate trip information, reset the trip information before areas and maps. beginning a trip. Finding a Waypoint by Name Select > Trip Computer > > Reset > Reset Trip Data > Yes. Select > Where To? > Waypoints > > Spell Search. 1 Enter the name. 2 3 Select . Applications F
ページ17に含まれる内容の要旨
Dog Track On Map: Sets the length (duration in minutes or Satellite Page hours) of the dog track on the map. Reducing the duration of The satellite page shows your current location, GPS accuracy, the track shown can reduce the clutter on the map. satellite locations, and signal strength. Zoom Map To Dogs: Automatically zooms the map to show all Changing the Satellite View of the dogs' locations and your location unless you manually By default, the satellite view is with North at the top. Yo
ページ18に含まれる内容の要旨
Automotive Mode shows an automotive perspective with Time Settings the direction of travel at the top. Select Setup > Time. Guidance Text: Sets when the guidance text on the map is Time Format: Sets the device to show time in a 12-hour or 24- shown. hour format. Dashboard: Selects a dashboard to display on the map. Each Time Zone: Sets the time zone for the device. Automatic sets dashboard shows different information about your route or the time zone automatically based on your GPS position
ページ19に含まれる内容の要旨
Marine Alarm Setup: Sets alarms for when you exceed a TT 10 Dog Collar Device Specifications specified drift distance while anchored, when you are off Battery type Rechargeable, replaceable lithium-ion course by a specified distance, and when you enter water of Battery life 20 hours with a 2.5-second update rate; 40 a specific depth. hours with a 2-minute update rate Operating temperature From -4°F to 140°F (from -20°C to 60°C) range Device Information Charging temperature From 32°F to 113°F
ページ20に含まれる内容の要旨
Use the slider to adjust the backlight level. • GPX geocache files. Go to www.opencaching.com. 2 The device may feel warm when the backlight setting is high. • GPI custom POI files from the Garmin POI Loader. Go to www.garmin.com/products/poiloader. Adjusting the Backlight Timeout You can decrease the backlight timeout to maximize the battery Installing a Memory Card life. WARNING Select Setup > Display > Backlight Timeout. 1 Do not use a sharp object to remove user-replaceable batteries. 2 S
