Schumacher Automatic /Maintainer SE-1-12Sの取扱説明書

ページ1に含まれる内容の要旨

SE-1-12S
Battery
1½ AMP
Charger
Battery Charger & Maintainer
Model:
For 12 Volt Batteries
Owner's Manual
Read Rules for Safe Operation and Instructions Carefully
Working in vicinity of a lead-acid battery is dangerous. Batteries generate explosive gases during normal
battery operation. For this reason, it is of utmost importance that each time before using your charger, you
read this manual and follow the instructions exactly.
WARNING: Handling the cord on this product or cords associated with a

ページ2に含まれる内容の要旨

PERSONAL PRECAUTIONS AND SAFETY 1. WARNING: Wear complete eye protection and clothing 5. Remove all personal metal items such as rings, bracelets, protection, when working with lead-acid batteries. necklaces, and watches when working with a lead-acid 2. Make sure someone is within range of your voice or close battery. A lead-acid battery can produce a short-circuit enough to come to your aid when you work with or near a current high enough to weld a ring (or the like) to metal, lead-acid battery

ページ3に含まれる内容の要旨

MOUNTING INSTRUCTION FENDER WELL Figure 1 illustrates the charger mounting brackets. Figure 2 illustrates surface mounting of the charger to the fender 12 VOLT well. If using the nut and bolt provided, drill two holes between BATTERY 3/16" and 1/4" in diameter. (For alignment of holes use one of the brackets as a template.) If the backside of the mounting surface is hard to reach, you may consider using two 1/2" sheet- metal screws instead of nut bolt, drill a pilot hole if required, drill holes

ページ4に含まれる内容の要旨

OPERATING INSTRUCTIONS Model SE-1-12S is intended for use with 12 volt battery sys- most vehicles, see item 5. If positive post is grounded to tems only. The charger contains an electronic control circuit which chassis, see item 6. safeguards against overcharging the battery. 5. For common negative grounded vehicle, connect positive (red) terminal from battery charger to positive (+) After reading and following the directions "Charging battery in ungrounded post of the battery. Connect negative