ページ1に含まれる内容の要旨
Acer
Aspire M5400(G)
Service Guide
PRINTED IN TAIWAN
ページ2に含まれる内容の要旨
Revision History Please refer to the table below for the updates made on this service guide. Date Chapter Updates ii
ページ3に含まれる内容の要旨
Copyright Copyright © 2010 by Acer Incorporated. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of Acer Incorporated. iii
ページ4に含まれる内容の要旨
Disclaimer The information in this guide is subject to change without notice. Acer Incorporated makes no representations or warranties, either expressed or implied, with respect to the contents hereof and specifically disclaims any warranties of merchantability or fitness for any particular purpose. Any Acer Incorporated software described in this manual is sold or licensed "as is". Should the programs prove defective following their purchase, the buyer (and not Acer Incorporated, its dist
ページ5に含まれる内容の要旨
Conventions The following conventions are used in this manual: SCREEN Denotes actual messages that appear on screen. MESSAGES NOTE Gives additional information related to the current topic. WARNING Alerts you to any physical risk or system damage that might result from doing or not doing specific actions. CAUTION Gives precautionary measures to avoid possible hardware or software problems. IMPORTANT Reminds you to do specific actions relevant to the accomplishment of procedures. v
ページ6に含まれる内容の要旨
Service Guide Coverage This Service Guide provides you with all technical information relating to the BASIC CONFIGURATION decided for Acer's "global" product offering. To better fit local market requirements and enhance product competitiveness, your regional office MAY have decided to extend the functionality of a machine (e.g. add-on card, modem, or extra memory capability). These LOCALIZED FEATURES will NOT be covered in this generic service guide. In such cases, please contact your region
ページ7に含まれる内容の要旨
Table of Contents System Tour 1 Features 1 Block Diagram 4 System Components 5 Front Panel 5 Rear Panel 6 Hardware Specifications and Configurations 7 Power Management Function(ACPI support function) 11 System Utilities 12 CMOS Setup Utility 12 Entering CMOS setup 13 Navigating Through the Setup Utility 13 Setup Utility Menus 14 System Disassembly 27 Disassembly Requirements 27 Pre-disassembly Procedure 28 Removing the Side Panel 29 Removing the Heat Sink Fan Assembly 30 Removing the
ページ8に含まれる内容の要旨
Chapter 1 System Tour Features Below is a brief summary of the computer’s many feature: NOTE: The features listed in this section is for your reference only. The exact configuration of the system depends on the model purchased. Operating System • Microsoft Windows 7 Home Premium 64bit • Microsoft Windows 7 Home Premium 32bit • Microsoft Window 7 Home Basic 64bit • Microsoft Windows 7 Home Basic 32bit • Microsoft Windows 7 Starter 32bit • Microsoft Windows 7 Professional 32bit • Microsoft Wind
ページ9に含まれる内容の要旨
• Dual channel should be enabled always when plug-in 2 same memory size DDRIII memory module Hard disk drive • Support up to two SATA ports • 3.5" • Capacity and models are listed on AVLC Optical disk drive • Support one SATA 5.25" standard ODD • Support DVD-ROM, DVD-SuperMulti, BD-combo, BD-rewrite • Maximum ODD depth to 185mm with bezel • Models are listed on AVLC Graphics card • No mechanical retriction to support for double slot, full length graphics cards in the single PCIe X16 slot Vedio
ページ10に含まれる内容の要旨
LAN • Controller: Realtek 8111E Gigabit Ethernet controller • RJ-45 Back panel port with Link/Activity LEDs USB ports • Ports Quantity: 14 (should reserve more header for front DB) • 6 ports for rear port • On-board: 4 2*5 headers 4 ports for front daughter board 2 ports for internal card reader 2 ports for Daughter board (Aspire M5400/M3400 only) • Connector Pin: standard Intel FPIO pin definition Extension slot • Support one PCIe x 16 slot • Support two PCIe x 1 slots • Support one PCI slot
ページ11に含まれる内容の要旨
• 2 reserved 2-pin GPIO connector System BIOS • Size: 8Mbit • AMI Kernel with Acer skin/copyright Power supply • 300W/500W in stable mode (Acer Assign System Power Unit) • Support 82+ PSU for EnergyStar 5.0 complaint • Design for RS880P+SB810 series chipset compatible system • Voltage design should be covered +5V, +3.3V, +12V, +5VSB, -12V (attention to 12V output capability) • Demand for both PFC/Non-PFC solutions (two different quotations are needed) • PS2 style 4 Chapter 1
ページ12に含まれる内容の要旨
Block Diagram Chapter 1 5
ページ13に含まれる内容の要旨
System Components This section is a virtual tour of the system’s interior and exterior components. Front Panel 9 1 8 7 2 6 3 4 5 No. Component 1 USB 2.0 ports 2Acer logo 3 Optical drive button 4 Optical drive button (Removable HDD bay for AM551 bezel) 5 Removable HDD bay 6 Power button 7 16 in 1 Card Reader 8 Headphone/Speaker-out/line-out jack 9 Microphone-in jack 6 Chapter 1
ページ14に含まれる内容の要旨
Rear Panel 1 14 13 2 3 12 4 5 11 10 9 6 7 8 No. Component 1 Power connector 2 PS2 keyboard port 3 HDMI port 4VGA port 5 USB 2.0 ports 6Mic-in 7 Line-out 8 Expansion slot (graphics card and TV tuner card and Mode card) 9 Line-in 10 USB 2.0 ports 11 LAN connector 12 System FAN 13 PS2 mouse port 14 Fan aperture Chapter 1 7
ページ15に含まれる内容の要旨
Hardware Specifications and Configurations Processor Item Specification Processor Type Support AM3 6-core Thuban CPU (140W) Socket Type AMD Socket AM3 Minimum operating speed 0 MHz (If Stop CPU Clock in Sleep State in BIOS Setup is set to Enabled.) BIOS Item Specification BIOS code programer AMI Kernel with Acer skin BIOS version P01-A0 BIOS ROM type SPI ROM BIOS ROM size 8Mb Support protocol SMBIOS(DMI)2.4/DMI2.0 Device Boot Support Support BBS spec 1st priority: HDD 2nd priority: CD-ROM 3th
ページ16に含まれる内容の要旨
Memory Combinations Slot Memory Total Memory Slot 1 1MB,2GB,4GB 1G ~4GB Slot 2 1MB,2GB,4GB 1G ~4GB Slot 3 1MB,2GB,4GB 1G ~4GB Slot 4 1MB,2GB,4GB 1G ~4GB Maximum System Memory Supported 1G~16GB System Memory Item Specification Memory slot number 4 slot Support Memory size per socket 1GB/2GB/4GB Support memory type DDRIII Support memory interface DDRIII 1066/1333MHz Support memory voltage 1.5V Support memory module package 240-pin DDRIII Support to parity check feature Yes Support to error corre
ページ17に含まれる内容の要旨
SATA Interface Item Specification SATA controller RS880P Number of SATA channel SATA X 6 Support mode RAID/AHCI/IDE mode option USB Port Item Specification Universal HCI USB 2.0/1.1 USB Class Support legacy keyboard for legacy mode USB Connectors Quantity 6 back real ports 4 ports for front daughter board 4 ports reserved Environmental Requirements Item Specification Temperature Operating +5°C ~ +35°C Non-operating -20 ~ +60°C (Storage package) Humidity Operating 15% to 80% RH Non-operating 10
ページ18に含まれる内容の要旨
Power Management Function(ACPI support function) Device Standby Mode • Independent power management timer for hard disk drive devices(0-15 minutes,time step=1minute). • Hard Disk drive goes into Standby mode(for ATA standard interface). • Disable V-sync to control the VESA DPMS monitor. • Resume method:device activated (keyboard for DOS, keyboard &mouse for Windows. • Resume recovery time 3-5sec Global Standby Mode • Global power management timer(2-120minutes,time step=10minute). • Hard di
ページ19に含まれる内容の要旨
Chapter 2 System Utilities CMOS Setup Utility CMOS setup is a hardware configuration program built into the system ROM, called the complementary metal- oxide semiconductor (CMOS) Setup Utility. Since most systems are already properly configured and optimized, there is no need to run this utility. You will need to run this utility under the following conditions. • When changing the system configuration settings • When redefining the communication ports to prevent any conflicts • When modi
ページ20に含まれる内容の要旨
Entering CMOS setup 1. Turn on the server and the monitor. If the server is already turned on, close all open applications, then restart the server. 2. During POST, press Delete. If you fail to press Delete before POST is completed, you will need to restart the server. The Setup Main menu will be displayed showing the Setup’s menu bar. Use the left and right arrow keys to move between selections on the menu bar. Navigating Through the Setup Utility Use the following keys to move around t
