ページ1に含まれる内容の要旨
INSTALLATION & OPERATION
INSTRUCTIONS
ICW-3 WINDOW INTERCOM
9350-7686-000 Rev. H 08/2004
ページ2に含まれる内容の要旨
TRADEMARKS ® AudioCom is a registered trademark of Telex Communications. Names of other products mentioned herein are used for identifi- cation purposes only and may be trademarks and/or registered trademarks of their respective companies. WARRANTY INFORMATION Products are warranted by Telex Communications, Inc. to be free from defects in materials and workmanship for a period of one year from the date of sale. The sole obligation of Telex during the warranty period is to provide, without charge
ページ3に含まれる内容の要旨
UNPACKING & INSPECTION ICW-3 Package 1. IEC cord. 2. Switching power supply. 3 3. ICW-3 to power supply cord. 4. #6 screws 1” (3). 4 5. Adjustment screwdriver. 2 5 6. Customer assembly. 7. Operator assembly. 1 6 7 Figure 1 - ICW-3 system components. Unpack the equipment from the shipping case and inspect for missing or damaged components. You should have all of the items listed next to Figure 1. RECOMMENDED ITEMS 1. No. 1 Phillips screwdriver 2. Equipment for cutting/drilling hole(s) for mountin
ページ4に含まれる内容の要旨
Figure 2 - ICW-3 Assembly detail. INSTALLATION 1. Remove the two screws (one on each side) holding the mounting plate to the operator assembly. (See Figure 3) 2. Measure and identify the location where the intercom is to be mounted. 3. Attach the mounting template to the window (customer assembly side) being sure to center the appropriate guide in the location identified in step 2. Note: There are two guides provided on the last page of these instructions. Use either the single large hole, or mu
ページ5に含まれる内容の要旨
Figure 3 - Customer and operator assemblies. Figure 4 - Mounting template. Figure 5 - Customer side mounted. Figure 6 - Connecting customer and operator assemblies prior to final mounting. VOX CIRCUIT ADJUSTMENT Note: The unit is shipped from the factory with the VOX circuit pre-adjusted. Use this procedure only if you encounter a problem where the VOX circuit does not properly switch between the operator and customer when they are talking. In some situations, particularly when ambient noise lev
ページ6に含まれる内容の要旨
OPERATION Operator Side Connection for gooseneck microphone Loudspeaker is interrupted Controls volume of the when headphones are in use loudspeaker on the operator side. Rotate knob clockwise to increase volume Controls volume of the loudspeaker on the customer side. When the MUTE button Rotate knob clockwise is pushed in, the customer cannot to increase volume hear what the operator is saying VOX1 (outside) Circuit Adjustment (customer side) Microphone connector Headphone VOX2 (inside) Circuit
ページ7に含まれる内容の要旨
CUT HERE
ページ8に含まれる内容の要旨
