Closet Maid Custom Closet Organizer S25TSの取扱説明書

ページ1に含まれる内容の要旨

Custom Closet Organizer
Organisateur de Garde-Robe Personnalisé
Organizador de Clóset Individualizado
®
Selectives S25TS, S16TS
13 14 15 16
12
10 11
9
6 7
8
3
2
4
4
5
5
5 5
1
1/4"
1
2 REQUIRED TOOLS
6mm
OUTILS NÉCESSAIRES
HERRAMIENTAS REQUERIDAS
2
USE AND CARE MODE D'EMPLOI USO Y CUIDADO
3
4
ETENTRETIEN
5
5
1
Use Custom Closet Organizer for creating organized closet space.
2
1 Use el Organizador de Clóset individualizado para crear un espacio organizado en su clóset.
Utiliser l’Organisateur de G

ページ2に含まれる内容の要旨

x24 1 SMALL ADJUSTABLE SHELF a. Align cam lock opening with hole opening. Install cam locks into holes in FIXED SHELF LARGE PETITE ÉTAGÈRE RÉGLABLE ÉTAGÈRE FIXE GRANDE each fixed shelf (Large) and each adjustable shelf (Small). Be sure all cam PEQUEÑA REPISA AJUSTABLE REPISA FIJA GRANDE locks are fully seated. Set adjustable shelves (Small) aside. a. Aligner l’ouverture du boulon à verrou avec l’ouverture du trou. Installer les After installing cams, boulons à verrou dans les trous de chaque

ページ3に含まれる内容の要旨

x2 x2 x2 x2 5 All units MUST be fastened to the wall. When stacking units, WARNING the unit on the bottom must be attached to the wall first before setting another unit on top. a. Place base unit inside closet (allow 0-48" on each side for hang rod). AVERTISSEMENT Use a level and adjust leveling feet to be sure base is square. SECURE BASE UNIT TO WALL b. Place L-bracket inside base as shown. Mark hole location on wall. Tous les modules DOIVENT être FIXER LA BASE AU MUR c. Use a 1/4" drill bit to

ページ4に含まれる内容の要旨

x6 7 a. Choose "double hang" and "long hang" side. a. 3/4” b. Measure and mark three rod bracket hole locations on units. (For ease in installation, 2” drill small pilot holes at marked locations.) Secure each rod bracket with two rod bracket screws. 2” a. Choisir le côté avec support double et celui avec support de suspension de LONG HANG DOUBLE HANG vêtements longs. SUSPENSION DOUBLE D’ARTICLES LONGS COLGADOR ALTO COLGADOR DOBLE b. Mesurer et marquer l’emplacement des supports de tige sur le