ページ1に含まれる内容の要旨
Vec010BD_Manual_042905 5/9/05 1:00 PM Page 8
VEC010BD
TWO YEAR LIMITED WARRANTY PROGRAM
This limited warranty program is the only one that applies to this product, and it sets forth all the
responsibilities of Vector Manufacturing, regarding this product. There is no other warranty, other than those
described herein.
This Vector Manufacturing product is warranted, to the original purchaser only, to be free of defects in
materials and workmanship for two years from the date of purchase without
ページ2に含まれる内容の要旨
Vec010BD_Manual_042905 5/9/05 1:00 PM Page ii CAUTIONS IMPORTANT SAFETY INSTRUCTIONS Use only the supplied cords/adapters for recharging this unit. Do not recharge for 1. When working with lead acid batteries, always make sure immediate assistance is available in case more than 3-4 hours maximum using 12 volt DC method. Recharge unit after each use. of accident or emergency. All on/off switches should be in the OFF position when the unit is charging or not in 2. Always use protective clothing
ページ3に含まれる内容の要旨
Vec010BD_Manual_042905 5/9/05 1:00 PM Page iv TABLE OF CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Battery Charge Status . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 12 Volt DC Accessory Outlet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ページ4に含まれる内容の要旨
Vec010BD_Manual_042905 5/9/05 1:00 PM Page 2 USING THE UNIT AS A JUMP-STARTER 12 VOLT DC PUSHBUTTON FOR This Jump-Starter is equipped with a safety Power Switch that only allows energy to ACCESSORY BATTERY STATUS flow when proper connections are made to battery and frame. Once the OUTLET CHECK connections are properly made, turn the switch ON to jump-start the vehicle. KEYLESS ON/OFF AC 1. Turn OFF vehicle ignition and all accessories (radio, A/C, lights, connected cell POWER SWITCH RECHARGI
ページ5に含まれる内容の要旨
Vec010BD_Manual_042905 5/9/05 1:00 PM Page 4 WARNINGS CARE AND MAINTENANCE • Jump-Starter Power Switch should be OFF prior to jump-starting. This product has a sealed lead acid battery that should be kept fully charged. • This power system is to be used ONLY on vehicles or boats with Recharge before first use, immediately after each use, and every 60 days if not 12 volt DC battery systems. used. Failure to do this may reduce the battery life dramatically. •Never touch red and black clamps tog
ページ6に含まれる内容の要旨
Vec010BD_Manual_042905 5/9/05 1:00 PM Page 6 Unlike the AC recharge method, DC recharge does NOT automatically activate the TROUBLESHOOTING “battery status” display and provide a taper charge. Battery status can still be Unit Fails to Jump-Start monitored by pressing the battery status level pushbutton. • Make sure unit’s power switch is in the ON position. WARNINGS • Check that Jump-Starter has a full charge. • DO NOT DC charge for more than 3-4 hours maximum. • Make sure a proper polarity c
