ページ1に含まれる内容の要旨
7300, 8700 SERIES
MT170
®
INSTALLATION INSTRUCTIONS
THESE INSTRUCTIONS MUST BE
LEFT WITH HOMEOWNER
KITCHEN DECK FAUCETS
Single-Handle - for Eight-Inch Centers
Measurements
"FLOW-RATOR"
9" (229mm)
AERATOR
SPOUT
5-3/8" (137mm)
NOMINAL
7-1/2" (191mm)
(9" SPOUT)
NOMINAL
OPEN POSITION
7-1/8" (181mm)
NOMINAL
(12" SPOUT)
2-1/8"
1/2" STRAIGHT
(54mm)
DECK
PIPE THREAD
GASKET
MOUNTING
NUT/WASHER
TAILPIECE NUT
FOR 8" (203mm) CENTERS
DECK ESCUTCHEON
10" (254mm) X 2" (51mm) WIDE
(DECK GASKET IS ONLY
USED WI
ページ2に含まれる内容の要旨
Installation TO INSTALL FAUCET: Be sure sink or mounting surface is clean and dry. Place deck gasket on bottom of faucet and insert faucet supplies down through deck holes. Center deck gasket and faucet on sink. Tighten mounting nuts from below deck. Carefully trim excess deck gasket. Make connections to your hot and cold water supplies. TO INSTALL HOSE AND SPRAY: Place a bead of plumber's putty under the rim of the spray escutcheon. Install spray head escutcheon and tighten locknut by ha
ページ3に含まれる内容の要旨
HANDLE Disassembly COVER 1. Turn "OFF" both hot and cold water supplies. Turn faucet HANDLE SCREW on to relieve pressure and insure complete shut off.. Pull handle cap up and off (it snaps into place). Remove the HANDLE handle screw (illustration 1). ASSEMBLY HANDLE LEVER ILLUSTRATION 1 2. Push the cartridge stem down and then lift and tilt handle RETAINER lever and handle body off. PIVOT NUT CARTRIDGE EARS 3. Unscrew retainer pivot nut. ➤ 9" SPOUT 4. Lift and twist spout off. The diverter c
ページ4に含まれる内容の要旨
Consumer Information Faucets made of leaded brass alloys may contribute small amounts of lead to water that is allowed to stand in contact with the brass. The amount of lead contributed by any faucet is highest when the faucet is new. The following steps may reduce potential exposure to lead from faucets and other parts of the plumbing system: • Always run the water for a few seconds prior to use for drinking or cooking. • Use only cold water for drinking or cooking. • If you wish to flush the