ページ1に含まれる内容の要旨
Ergotron LX LCD/Notebook Arm
USA 1-800-888-8458
Europe +31 (0)33-45 45 600
Ergotron LX Ergotron LX Notebook Arm
� 13" (330 mm) height range � 13" (330 mm) height range
� Display tilts +5/-75° forward/back � Display tilts +5/-75° forward/back
� Display pans 180° right/left � Display pans 180° right/left
� Arm pivots 360° � Arm pivots 360°
� Arm extends/retracts display 24" (610 mm) with Extension � Arm extends/retracts display 24" (610 mm) with Extension
� Weight capacity adjusts to hold displa
ページ2に含まれる内容の要旨
DETERMINE PLACEMENT OF BASE ON WORK SURFACE. 1 A B Straight Confi guration Corner Confi guration - position base minimum 19" (483mm) from either edge 2 CLAMP OPTION 3 A ATTACH BASE GROMMET G OPTION B 4 888-45-040P-01 rev.H � 10/07 2 of 18
ページ3に含まれる内容の要旨
AB A 2 ATTACH BASE - Clamp 1 7/16" i ii EDGE MOUNT (one piece) ) TO OP/B P/BO OT TT TO OM MOUNT (two piece) a a b 7/16" cd b 5 888-45-040P-01 rev.H � 10/07 3 of 18
ページ4に含まれる内容の要旨
B 2 ATTACH BASE - Grommet AB C D 1x 1x 1x 1x 1 1x 2x 2 1x 7/16" a bc 7/16" d ef 5 888-45-040P-01 rev.H � 10/07 4 of 18
ページ5に含まれる内容の要旨
4 Mount Extension/Arm M NOTE: If attaching Arm directly to pole, without extension skip to Step 4. M Mount Extension/Arm 5 3 Mount Extension/Arm WARNING: * Desk Clamp Installations: The range of motion (side-to-side) for two Extensions/Arms on one pole * mounted with the Desk Clamp option is limited to A B 180º forward (over front of desk clamp base). MOUNT ONE MOUNT TWO EXTENSION/ARM EXTENSIONS/ARMS A A 2x 1 1x 1 180º 1x 2 >180º NOTE: Grommet Mount Insta
ページ6に含まれる内容の要旨
4 A B ATTACH DISPLAY ATTACH NOTEBOOK 8 AB C D 4x* 4x* 1x* 1 1x* #8-32 M4 x 10mm 1x* 2 4x* 3/32" 1x* 4mm 1x* For optimum ergonomic viewing, 3 M4 x 10mm set top of monitor screen 1 ″ below eye height of operator. * Quantity per Arm * A ATTACH LABEL A 4 For optimum ergonomic viewing, set top of monitor screen 1 ″ below eye height of operator. 888-45-040P-01 rev.H � 10/07 6 of 18
ページ7に含まれる内容の要旨
ATTACH DISPLAY 5 100 x 100mm 75 x 75mm A B 4x aa #8-32 4x M4 x 10 mm b 4x M4 x 10 mm 6 A B ATTACH ARM TO EXTENSION ATTACH ARM TO POLE 12 12 888-45-040P-01 rev.H � 10/07 7 of 18
ページ8に含まれる内容の要旨
ATTACH NOTEBOOK B 4 Ergotron's Notebook Tray is designed to attach to Ergotron Arms and Stands with a 75mm x 75mm hole pattern. If you are attaching the Tray to a non-Ergotron product, before proceeding with this installation, you should contact the manufacturer of that mounting solution. NOTE: After you have attached the Ergotron Notebook Tray and your notebook according to these Assembly Instructions, make sure that the Arm/Stand has been adjusted properly to support the weight of bot
ページ9に含まれる内容の要旨
5 A B ATTACH ARM TO EXTENSION ATTACH ARM TO POLE 4x M4 x 10 mm 6 ATTACH TRAY a 1x 1x M4 x 8 mm ATTACH PORTRAIT/LANDSCAPE ROTATION STOP SCREW b 2.5mm 12 888-45-040P-01 rev.H � 10/07 9 of 18
ページ10に含まれる内容の要旨
7 A B PLACE NOTEBOOK PLACE DOCKING STATION AND NOTEBOOK 11 2x PLACE NOTEBOOK Pads will help prevent notebook from slipping, but they A 7 will not hold all notebooks on the tray in all circum- stances. Use caution while tilting the tray, since some angles may cause the notebook to fall off resulting in equipment damage or personal injury. a 2x b c d 11 888-45-040P-01 rev.H � 10/07 10 of 18
ページ11に含まれる内容の要旨
PLACE DOCKING STATION AND NOTEBOOK 3x 2x B 7 e e a bc d 3x f gh i i A ATTACH CLIPS 8 1x 1x b 1x a 12 888-45-040P-01 rev.H � 10/07 11 of 18
ページ12に含まれる内容の要旨
ADJUST HEIGHT To change position of Arm on pole, remove Arm from pole, loosen Collar and raise or lower on pole, tighten Collar and replace Arm. 9 Display N No otebook A B ab c d e 2.5mm 2.5mm ROUTE CABLES Leave Slack in cable 10 888-45-040P-01 rev.H � 10/07 12 of 18
ページ13に含まれる内容の要旨
LIFT (up and down) a 11 Display Notebook +25˚ +25˚ a 13" 13" (330 mm) (330 mm) -25˚ -25˚ 4mm 11 11 11 RANGE OF MOTION This product is designed to adjust quickly and easily according to your needs – refer to following steps for adjustment. a a Lift – Up and down If it does not stay in place or move- ment is stiff, tension needs adjust- ment. Adjust until motion is equal. Adjust Lift – Up and down To increase tension - Turn Clockwise To decrease tension -
ページ14に含まれる内容の要旨
TILT (forward and backward) b - 75˚ Display Notebook +75˚ b -5˚ + 5˚ b Tilt – Forward and Backward b b If it does not stay in place or move- ment is stiff, tension needs adjust- ment. Adjust until motion is equal. Adjust Tilt – Forward and Back- ward To increase tension - Turn Clockwise To decrease tension - Turn Counterclockwise CAUTION DO NOT remove screw. Remov- ing screw may cause damage to equipment. 888-45-040P-01 rev.H � 10/07 14 of 18
ページ15に含まれる内容の要旨
SWING (side-to-side) c < 360˚ < 360˚ < 360˚ Display Notebook c < 360˚ 2.5mm C Arm Swing – Side-to-side C C If it does not stay in place or move- ment is stiff, tension needs adjust- ment. Adjust until motion is equal. Adjust Arm Swing – Side-to-side To increase tension - Turn Clockwise To decrease tension - Turn Counterclockwise PORTRAIT/LANDSCAPE d 90˚ 888-45-040P-01 rev.H � 10/07 15 of 18
ページ16に含まれる内容の要旨
Troubleshooting ? Symptom Probable Cause Solution Adjust Lift Tension needs adjustment. 13 Display lifts up and down too easily or with diffi culty. Exceeds weight capacity: Ergotron LX: USA 1-800-888-8458 7 - 20 lbs. (3.22 - 9.1 kg). Europe +31 (0)33-45 45 600 Ergotron LX Notebook Arm: 2.5 - 12 lbs. (1.13 - 5.4 kg). Adjust Tilt Display tilts forward and back Tension needs adjustment. 14 too easily or with diffi culty. Adjust Arm Swing Arm swings side-to-side too Tension needs adjustment
ページ17に含まれる内容の要旨
? 13 Ergotron LX: USA 1-800-888-8458 5 - 20 lbs. (2.27 - 9.1 kg). Europe +31 (0)33-45 45 600 Ergotron LX 2.5 - 12 lbs. (1.13 - 5.4 kg). 14 15 888-45-040P-01 rev.H � 10/07 17 of 18
ページ18に含まれる内容の要旨
888-45-040P-01 rev.H � 10/07 18 of 18
