Dakota Digital LED Tail Lights LAT-NR101の取扱説明書

ページ1に含まれる内容の要旨

INSTALLATION INSTRUCTIONS
LAT-NR101
LED Tail Lights for 1967-68 RS Camaro.

MAN# 650195

Kit includes:


Installation: 67-68 RS Camaro

1. Remove the original bulb sockets from the housing.

2. Remove the tail light housing hardware so the housing can be taken out of the car. Remove
the housings from the vehicle carefully so the body gaskets are not damaged.

ページ2に含まれる内容の要旨

4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is recommended. 5. Remove the mounting plate from the bottom of the assembly; it is attached with two 3/8” 6-32 machine screws. 6. Pass the wires through the housing where the original bulb and socket where. 7. Feed the wires through the larger hole in the mounting plate and guide it to the bottom of the housing. The flat side of the mounting plate should be on the outside of the housing a

ページ3に含まれる内容の要旨

9. Screw the mounting plate into the mount using the two previously removed 3/8” #6 screws. This will secure the LED assembly into the housing. You are now ready for re-assembly. 10. Repeat the steps above for the second light. 11. Install the lens and reassemble the housing, insuring all gaskets are intact and in place. Install the housing back into the vehicle. You are now ready to wire the LED assembly into the vehicle harness. MAN# 650195

ページ4に含まれる内容の要旨

12. Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the wires from LED assembly to appropriate length once mounted, making sure wires are routed cleanly and securely. 13. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED assembly to the existing vehicle harness. Insert appropriate wire from vehicle harness and mating LED assembly wire into a connector and crimp following instructions below. *For the bes