Chief Manufacturing Pole Clamp Accessory FSA-1017の取扱説明書

ページ1に含まれる内容の要旨

INSTALLATION INSTRUCTIONS
Pole Clamp Accessory
Model: FSA-1017
The FSA-1017 Pole Clamp Accessory is used to provide
a means for attaching a desktop or wall mount to a
1 1/2" to 2" pole.
BEFORE YOU BEGIN
CAUTION!
To prevent damage to the Kit, which could affect or void the Factory warranty, and to the equipment that will be
attached to it, thoroughly study all instructions and illustrations before you begin the installation.
• If you have any questions about this installation, co

ページ2に含まれる内容の要旨

Model: FSA-1017 Installation Instructions INTRODUCTION TOOLS REQUIRED FOR INSTALLATION BHCS • 5/32" Hex Key (provided) INSPECT MOUNT BEFORE ASSEMBLY Carefully inspect components for shipping damage . If Flat Washer damage is apparent, call your carrier claims agent and do not continue with installation until the carrier has reviewed the damage.(see Figure 1) Nylon Washer Swing Arm Table 1: Parts Flat Washer Ref. Description QTY 10 CLAMP, Front, Pole Mount 1 Pivot Pin 20 CLAMP, Rear, Pole Mou

ページ3に含まれる内容の要旨

Installation Instructions Model: FSA-1017 NOTE: The following steps reuse hardware set aside 10. Secure pole mount rear (20) to pole mount front (10) and pole by tightening three BHCS (20) using 5/32" during existing mount preparation. hex key. 2. Place large Nylon washer into seat in pole mount front. (see Figure 4) 3. Slide pivot pin through large nylon washer and down Pole (30) into pole mount front. (see Figure 4) Pole Mount front (10) 4. Slide swing arm assembly down onto top of pivot

ページ4に含まれる内容の要旨

Model: FSA-1017 Installation Instructions 4