ページ1に含まれる内容の要旨
TFX-125BL
Shadow™ 125
USER MANUAL
th
Chauvet, 3000 N 29 Ct, Hollywood, FL 33020 U.S.A
(800) 762-1084 – (954) 929-1115
FAX (954) 929-5560
www.chauvetlighting.com
ページ2に含まれる内容の要旨
TABLE OF CONTENT TABLE OF CONTENT........................................................................................................................................................... 2 BEFORE YOU BEGIN........................................................................................................................................................... 3 WHAT IS INCLUDED ..............................................................................................................
ページ3に含まれる内容の要旨
BEFORE YOU BEGIN What is included TFX-125BL fixture H-125BL Blacklight bulb Power cord with plug Warranty Card & Manual Unpacking Instructions Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damaged from shipping or the carton itself shows signs of mishandling. Save the
ページ4に含まれる内容の要旨
INTRODUCTION Features • high-powered 125-watt blacklight cannon • long throw • easy lamp access • safety wire mesh • switch-selectable power settings 115V or 230V, (240V available) • no duty cycle! Product Overview Hanging bracket Tension knob Lamp wire mesh cover Product Overview TFX-125BL User Manual 4 Revision: 2004-11-02/11:32
ページ5に含まれる内容の要旨
SETUP Lamp You will need to install a lamp prior to the initial operation of the fixture. A bulb is included with your product. Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the unit to cool down! Always disconnect from main power prior to lamp replacement. Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp with alcohol and wipe it with a lint free cloth before installation. LAMP INSTALLATION Fi
ページ6に含まれる内容の要旨
Setup Mounting ORIENTATION This fixture may be mounted in any position provided there is adequate room for ventilation. RIGGING Figure 3 - Clamp Mount the fixture using, a suitable “C” or “O” type clamp. Adjust the angle of the fixture by loosening both knobs and tilting the fixture. After finding the desired position, retighten both knobs. • When selecting installation location, take into consideration lamp replacement access and routine maintenance. • Safety cables should alway
ページ7に含まれる内容の要旨
APPENDIX General Maintenance To maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usage and environment are contributing factors in determining frequency. As a general rule, fixtures should be cleaned at least twice a month. Dust build up reduces light output performance and can cause overheating. This can lead to reduced lamp life and increased mechanical wear. Be sure to power off fixture before conducting maintenance. Unplug fixture from power. Us
ページ8に含まれる内容の要旨
Appendix General Troubleshooting Applies to Dimmer Foggers Controller s& Symptom Solution(s) Lights & Snow s Chaser Auto shut off Check fan thermal switch reset Beam is very dim or not Clean optical system or replace lamp bright Check 220/110v switch for proper setting Breaker/Fuse keeps Check total load placed on device blowing Chase is too slow Check users manual for speed adjustment Device has no power Check for power on Mains. Check device’s fuse. (
ページ9に含まれる内容の要旨
Appendix Technical Specifications WEIGHT & DIMENSIONS Length............................................................................................................................. 216 mm (8.5 in) Width ............................................................................................................................... 254 mm (10 in) Height .............................................................................................................................. 254 m
