ページ1に含まれる内容の要旨
CH-175
Color Bank™ 12
USER MANUAL
th
CHAUVET, 3000 N 29 Ct, Hollywood, FL 33020 U.S.A
(800) 762-1084 – (954) 929-1115
FAX (954) 929-5560
www.chauvetlighting.com
ページ2に含まれる内容の要旨
TABLE OF CONTENT BEFORE YOU BEGIN........................................................................................................................................................... 3 WHAT IS INCLUDED................................................................................................................................................................................ 3 UNPACKING INSTRUCTIONS ........................................................................................
ページ3に含まれる内容の要旨
BEFORE YOU BEGIN What is included 1 x CH-175 with hanging brackets and 3 color gels of the following colors; knobs yellow, red, blue & green Power cord with plug 12 x JCDR 50W 120V lamps Manual Warranty Card Unpacking Instructions Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts
ページ4に含まれる内容の要旨
INTRODUCTION The Color Bank 12 is a compact striplight also referred to as a borderlight. It is ideal for providing basic area washes for small stages yet small and lightweight enough for mobile applications. Other applications include cove, perimeter, merchandise, and wall wash illumination. Features • 12 color gel holders • 16 built-in programs for stand-alone operation • 4 channel chase (3 lamps per channel) • Light to sound and chase mode • Chase speed control • Sound sensitivity
ページ5に含まれる内容の要旨
SETUP Lamp You will need to install the lamps prior to the initial operation of the fixture. Twelve JCDR 50W 120V MR-16 halogen lamps are included. Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the unit to cool down! Always disconnect from main power prior to lamp replacement. Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp with alcohol and wipe it with a lint free cloth before installation. LA
ページ6に含まれる内容の要旨
Setup • All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0% to 100% switch. • Before applying power to a fixture, check that the source voltage matches the fixture’s requirement. • All fixtures must be connected to circuits with a suitable Earth Ground. Mounting It is important never to obstruct the fan or vents pathway. Mount the fixture Ha
ページ7に含まれる内容の要旨
OPERATING INSTRUCTIONS Foreword The user buttons on this fixture will become “HOT” to the touch after a few minutes of operation. It is important to set all manual settings within the first few minutes of operation while the unit is cool to warm. Operating Modes The CH-175 can be operated in three ways. • A stand-alone mode will listen to sound and run through 16 built in programs. • Master/Slave mode will allow linking of up to as many units you want in a synchronized light show to
ページ8に含まれる内容の要旨
MASTER/SLAVE SETTINGS 1) Connect the 5 pin plug cable to the LINK (Out) connector of the first fixture. 2) Connect the other end of the 5 pin cable coming from the first fixture to the LINK (In) connector on the next fixture as illustrated below. Daisy Chain Connection Optional Footswitch Controller Note! The CH-175 and CH-158 can also be linked together. CB-FS Color Bank Footswitch (Optional) CB-FS PEDALS PEDAL FUNCTION CB-FS FOOTSWITCH AUDIO/CHASE AUDIO: Activates Aud
ページ9に含まれる内容の要旨
APPENDIX General Maintenance To maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usage and environment are contributing factors in determining frequency. As a general rule, fixtures should be cleaned at least twice a month. Dust build up reduces light output performance and can cause overheating. This can lead to reduced lamp life and increased mechanical wear. Be sure to power off fixture before conducting maintenance. Unplug fixture from power. Us
ページ10に含まれる内容の要旨
Appendix General Troubleshooting Applies to Foggers Dimmers Symptom Solution(s) Lights & Snow Controllers & Chaser Auto shut off Check fan thermal switch reset Beam is very dim or not Clean optical system or replace lamp bright Check 220/110v switch for proper setting Breaker/Fuse keeps Check total load placed on device blowing Chase is too slow Check users manual for speed adjustment Device has no power Check for power on Mains. Check device’s fuse. (inter
ページ11に含まれる内容の要旨
Appendix Technical Specifications WEIGHT & DIMENSIONS Length........................................................................................................................... 140 mm (5.51 in) Width ........................................................................................................................ 1100 mm (43.31 in) Height ........................................................................................................................... 175 mm (6.89
