ページ1に含まれる内容の要旨
1/2” AIR IMPACT WRENCH
Model 95310
Assembly and Operating Instructions
Due to continuing improvements, actual product may differ slightly from the product described herein.
®
TO PREVENT SERIOUS INJURY,
READ AND UNDERSTAND ALL WARNINGS
AND INSTRUCTIONS BEFORE USE.
3491 Mission Oaks Blvd., Camarillo, CA 93011
© ®
Copyright 2006 by Harbor Freight Tools . All rights reserved. No
portion of this manual or any artwork contained herein may be repro-
duced in any shape or form without the express writt
ページ2に含まれる内容の要旨
Specifications Maximum Torque: 250 ft. lbs. Bolt Capacity: 5/8” 1/2” Square Drive Reversible Drive Air Requirements: 5 CFM @ 90 PSI RPM: 7,000 1/4” NPT Air Inlet 3/8” Hose Size Standard Anvil Save This Manual You will need the manual for the safety warnings and precautions, assembly instructions, operating and maintenance procedures, parts list and diagram. Keep your invoice with this manual. Write the invoice number on the inside of the front cover. Keep the manual and invoice in a safe a
ページ3に含まれる内容の要旨
6. Use the right tool for the job. Do not attempt to force a small tool or attachment to do the work of a larger industrial tool. Do not use a tool for a purpose for which it was not intended. 7. Dress properly. Do not wear loose clothing or jewelry as they can be caught in moving parts. Protective, electrically non-conductive clothes and non-skid footwear are recommended when working. Wear restrictive hair covering to contain long hair. 8. Use eye and ear protection. Always wear ANSI appr
ページ4に含まれる内容の要旨
Unpacking When unpacking, check the parts diagram and part number listing on page 6 to make sure all parts are included. If any parts are missing or damaged, please call Harbor Freight Tools at the telephone number on the cover of this manual as soon as possible. Your Air Impact Wrench comes pre-assembled. To complete preparations for use, follow the steps shown on the following page. Part numbers shown below identify parts shown on the part number listing on page 6. Air Connection 1. Remove t
ページ5に含まれる内容の要旨
Loosening 1. Attach the correct size socket to the Anvil (8). 2. Set the compressor’s pressure regulator to 90 PSI. Do not set the compressor’s outlet regulator above 90 PSI. 3. Connect the Impact Wrench to the air compressor’s hose. If leaking is detected, disconnect the air hose and repair before use. 4. Place the socket over the nut to loosen. 5. Grip the Impact Wrench firmly. Press the Reverse Valve (44) in from the area above the Trigger (29) so that the Reverse Valve protrudes out the b
ページ6に含まれる内容の要旨
5. When the nut has been tightened, remove the Impact Wrench and socket. Do not over-tighten. 6. If available, check the recommended torque specifications for the nut. You should use a torque wrench to torque the nut after using the Impact Wrench. Maintenance The Impact Wrench is best operated with an airline oiler. If you are using the Impact Wrench without an airline oiler, perform the following maintenance: Disconnect the Impact Wrench from the
ページ7に含まれる内容の要旨
Parts Listing and Parts Diagram SKU 95310 For technical questions, please call 1-800-444-3353. Page 7
