ページ1に含まれる内容の要旨
CT-5/CT-7 Compact Theater
O w n e r ’ s M a n u a l
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Introduction Congratulations on your purchase of RBH CT Series speakers! Your speakers are the result of many years of research and development dedicated to producing high quality products for home audio systems. This manual contains features, setup recommendations and specifications for the RBH CT Series speakers. We recommend you thoroughly read through the material contained in this manual before connecting your speakers. This will ensure you have a good understanding of how to setup you
ページ4に含まれる内容の要旨
Features At the heart of the RBH CT Series speakers are proprietary aluminum cone woofers and midrange drivers. Aluminum combines stiffness, low mass and self damping properties in a manner which allows virtually uncolored presentation of program material. A powerful magnet, extended voice coil and bumped back plate give the bass/ midrange divers high excursion capability. This ensures accurate dynamic reproduction. The drivers are shielded by a steel cup and additional magnet to cancel any
ページ5に含まれる内容の要旨
Attaching Speaker Wires When using a banana jack to attach speaker wires to the binding post terminals, insert the speaker wire into the banana jack. Next insert the banana jack into the hole provided in the top of the terminal, and then continue to tighten the nut until secure. Repeat for the other speaker wire(s) as necessary. If not using a banana jack, simply loosen the binding nut to allow the hole in the side of the terminal to become exposed. Strip ¼-inch of the insulation from the en
ページ6に含まれる内容の要旨
Room Setup Suggestions In order to obtain the best possible sound from your speaker system, it is impor- tant to determine where the speakers will sound best in your listening room. Room reflections from the floor, ceiling and side walls influence the balance, imaging and overall sonic quality at the listening position. Experiment with speaker placement to determine which location offers the best overall sound. As a general guide, use the room layout diagram and the following descriptions wh
ページ7に含まれる内容の要旨
Room Setup Suggestions NOTE: There are several different surround formats available. Dolby Pro-Logic, Pro-Logic II, Dolby Digital and DTS generally have a 5 speaker plus subwoofer requirement. Dolby Digital EX and DTS ES add a center rear speaker. Please consult your audio/video professional to determine which system is best for you and how many speakers you will require. 7
ページ8に含まれる内容の要旨
Specifications Model MM-4 C-4 Speaker Type Bookshelf Center/LCR (Left, Center or Right) Frequency Response: 100Hz – 20kHz ± dB 100Hz – 20kHz ± dB Sensitivity: 5dB (2. V @ 1M) dB (2. V @ 1M) Recommended Power: 10-100 Watts 10-120 Watts (1) ” (102mm) Aluminum (2) ” (102mm) Aluminum Woofer: Tweeter: (1) 1” (25mm) Soft Dome (1) 1” (25mm) Soft Dome Impedance: Ohms Ohms 000 Hz 000 Hz Crossover Frequencies: Dimensions: Width: 5” (1 mm) Width: 11¾” (29 mm) Height: 7¼” (127m
ページ9に含まれる内容の要旨
Troubleshooting Situation: Probable Cause: Solution: No sound from Speaker wire not connected Make sure wire is connected speakers at both the speaker and the amplifier observing proper polarity Speaker selector on amplifier is Activate proper selector on not on amplifier No sound from Balance control on receiver Place balance control in the one speaker or pre-amp is not centered center Speaker wire not securely Check all connections at connected amplifier and speakers Very little bass
ページ10に含まれる内容の要旨
10
ページ11に含まれる内容の要旨
ページ12に含まれる内容の要旨
TM Redefining the Way You Experience Sound. 2 M arshall Way, Layton, Utah • USA • 0 1 Toll Free: (00) 5 -2205 • Fax: (01) 5 -00 www.rbhsound.com It is RBH Sound policy to continuously incorporate improvements into our products; all specifications are subject to change without notice. Copyright © 2007 RBH Sound. All Rights Reserved.
