ページ1に含まれる内容の要旨
Safety • Assembly • Operation • Adjustments • Maintenance • Troubleshooting • Parts Lists • Warranty
OPERATOR’S MANUAL
21-inch Self-Propelled Mulching Mower — Model Series V560
IMPORTANT
READ SAFETY RULES AND INSTRUCTIONS CAREFULLY BEFORE OPERATION
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered, brush-
covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting appli
ページ2に含まれる内容の要旨
This Operator’s Manual is an important part of your new lawn mower. It will help you assemble, prepare, and maintain the unit for best performance. Please read and understand what it says. Table of Contents Slope Gauge........................................................ 3 Maintaining Your Lawn Mower ......................... 10 Safe Operation Practices ................................... 4 Troubleshooting ................................................ 12 Setup and Adjustment ...........
ページ3に含まれる内容の要旨
Use this page as a guide to determine slopes where you may not operate safely. Do not operate your lawn mower on such slopes. 1 Slope Gauge WARNING Do not mow on inclines with a slope in excess of 15 degrees (a rise of approximately 2-1/2 feet every 10 feet). Operate WALK-BEHIND mowers across the face of slopes, never up and down slopes. 3
ページ4に含まれる内容の要旨
WARNING: Engine Exhaust, some of its constituents, and certain vehicle compo- nents contain or emit chemicals known to State of California to cause cancer and birth defects or other reproductive harm. 2 DANGER: This machine was built to be operated according to the rules for safe operation in this manual. As with any type of power equipment, carelessness or error on the part of the operator can result in serious injury. This machine is capable of amputating hands and feet and throwing Safe
ページ5に含まれる内容の要旨
19. Shut the engine off and wait until the blade comes to a 6. Extinguish all cigarettes, cigars, pipes and other sources complete stop before removing the grass catcher or unclog- of ignition. ging the chute. 7. Never fuel machine indoor because flammable vapors will The cutting blade continues to rotate for a few seconds after accumulate in the area. the engine is shut off. Never place any part of the body in 8. Never remove gas cap or add fuel while engine is hot or 2 the blade area u
ページ6に含まれる内容の要旨
1. Remove any packing material which may be between upper and lower handles. a. Pull up and back on upper handle as shown in A Figure 3-1. Make certain the lower handle is seated 3 securely into the handle mounting brackets. b. Tighten star knobs securing upper handle to lower handle. Make sure that each carriage bolt is Setup and seated properly in the handle. 2. Locate hairpin clip on the weld pin on each side of Adju
ページ7に含まれる内容の要旨
5. Follow steps below to attach grass catcher: 6. If coverting to side discharge, make sure grass catcher is off unit and rear discharge door is closed. a. Lift rear discharge door. a. Lift mulching plug on the right side of mower. b. Place grass catcher on the pivot rod. Let go of discharge door so that it rests on the grass b. Slide two hooks of side discharge chute under 3 catcher. See Figure 3-5. the hinge pin on
ページ8に含まれる内容の要旨
Know Your Lawn Mower Blade Control 4 Drive Control Operating Your Lawn Recoil Starter Mower Cutting Height Adjustment Levers Mulching Plug WARNING The blade control mechanism is a safety device. Never Figure 4-1 attempt to bypass its Now that you have set up your lawn mower for opera- Cutting Height Adjustment Levers operations. tion, get aquainted with its controls and features. These One adjustment lever is located on each wheel and is are described below and illustrated on this pa
ページ9に含まれる内容の要旨
Starting Engine WARNING: Be sure no one other than the operator is standing near the lawn 2 mower while starting engine or operat- 4 ing mower. Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an odorless and deadly 1 gas. Keep hands, feet, hair and loose clothing away Operating 3 from any moving parts on engine and lawn mower. Your Lawn Follow the set of instructions pertaining to your unit. Refer to engine manual for help with
ページ10に含まれる内容の要旨
Lubrication • Lubricate pivot points on the blade control at least once a season with light oil. The blade control must operate freely in both directions. See Figure 5-1. 5 • Lubricate the wheels at least once a season with light oil (or motor oil). If wheels are removed for any reason, lubricate surface of the pivot arm and inner surface of the wheel with light oil. See Figure 5-1. Maintaining • Lubricate the torsion spring and pivot point on the rear discharge door and side discharge c
ページ11に含まれる内容の要旨
Blade Care WARNING: When removing cutting blade for sharpening or replacement, protect your hands with a pair of heavy 5 gloves or use a heavy rag to hold blade. 1. Disconnect spark plug wire from spark plug. Turn mower on its side making sure that the air filter and Maintaining the carburetor are up. 2. Remove bolt, blade bell support, blade, and blade Your Lawn adapter from the engine crankshaft. See Figure 5-3. 3. The blade can be sharpened with a file or on a grind- Mower ing wheel.
ページ12に含まれる内容の要旨
Problem Remedy Cause 1. Engage blade control. 1. Blade control disengaged. Engine fails to start 2. Spark plug wire disconnected. 2. Connect wire to spark plug. 6 3. Fuel tank empty or stale fuel. 3. Fill tank with clean, fresh gasoline. 4. Prime engine as instructed in “Operat- 4. Engine not primed (if equipped with ing Your Lawn Mower”. primer). 5. Clean, adjust gap, or replace. 5. Faulty spark plug. Trouble 6. Blocked fuel line. 6. Clean fuel line. 7. Engine flooded. 7. Wait a few minutes t
ページ13に含まれる内容の要旨
4. Coat mower’s cutting blade with chassis grease to Off-Season Storage prevent rusting. The following steps should be taken to prepare your lawn mower for storage. 5. Store mower in a dry, clean area. Do not store next 1. Clean and lubricate mower thoroughly as described in to corrosive materials, such as fertilizer. the lubrication instructions. When storing any type of power equipment in a poorly 2. We do not recommend the use of a pressure washer ventilated or metal storage shed, car
ページ14に含まれる内容の要旨
Model Series V560 10 9 8 7 35 12 4 17 3 32 1 33 37 6 26 11 30 17 5 2 31 34 17 26 29 28 16 27 19 13 14 17 15 25 Wheel Treads 24 23 22 21 17 20 18 Zag Tread Bar Tread 36 14
ページ15に含まれる内容の要旨
8 Ref. Part No. Description Ref. Part No. Description Parts List 1 750-04405 Slev. Spacer 1.8” Lg. 734-04082 Rear Wheel, 12 x 1.8, Bar 2 750-04404 Sleeve Spacer 9.10” Lg. 20 710-04531 Screw 1/4-20 x .390 3 710-0654A Self-Tapping Sems Screw 21 717-1762 Gear 14T RH FWD RH 4 787-01278 21” Deck 3 in 1 SP 717-1761 Gear 14T LH FWD LH 5 710-0599 TT Screw 1/4-20 x 0.5 22 715-0221 Dowel Pin 6 736-0270 Bell Washer 23 782-7551A Wheel Dust Cap 7 687-02055 Hinged Mulch Plug Assembly 24 716-0102 Snap Ring 8 1
ページ16に含まれる内容の要旨
Model Series V560 5 4 18 8 1 12 17 9 6 11 14 20 24 21 10 13 23 28 16 3 22 15 7 42 41 2 40 26 27 39 43 32 25 30 33 31 29 29 35 36 33 38 34 38 37 19 37 16
ページ17に含まれる内容の要旨
8 Parts List Ref. Part No. Description Ref. Part No. Description 1 746-04206A Variable Speed Cable 22 710-0703 Carriage Bolt 1/4-20 23 732-04090A Torsion Spring - RH 2 731-04150C Rear Baffle 21” Rd. 24 747-04588 Pivot Rod 3 710-1241 Screw 1/4-15 x 1.000 4 731-04859‡ Deluxe Bail Cover 25 731-05250 Transmission Cover (Gray) 5 747-1161A Blade Control 731-05020A Transmission Cover (Black) 26 710-1650 Shoulder Screw # 12 -24 6 749-04206 Upper Handle 27 787-01265A Belt Keeper Bracket 7 787-01258A Cabl
ページ18に含まれる内容の要旨
NOTES Use this page to make notes and write down important information. 18
ページ19に含まれる内容の要旨
NOTES Use this page to make notes and write down important information. 19
ページ20に含まれる内容の要旨
MANUFACTURER’S LIMITED WARRANTY FOR The limited warranty set forth below is given by MTD LLC with respect e. MTD does not extend any warranty for products sold or exported to new merchandise purchased and used in the United States, its outside of the United States, its possessions and territories, except possessions and territories. those sold through MTD’s authorized channels of export distribution. “MTD” warrants this product against defects in material and workman- f. Replacement parts tha
