ページ1に含まれる内容の要旨
EL552.256-Q2
RITE EL D
The Definition of Quality
ISPLAY ICEB
TM
Operations Manual
ページ2に含まれる内容の要旨
Planar Systems, Inc. © 1998 and “The Definition of Quality” are registered trademarks and , and ColorBrite are trademarks of Planar Systems, Inc. This document is subject to change without notice. Planar provides this information as reference only, and does not imply any recommendation or endorsement of other vendor’s products. Document number OM410-00 October 1998 Description Date Revision Control ICEBrite, ICE Planar
ページ3に含まれる内容の要旨
Contents ................................ ................................ ................................ ................ 2 ................................ ................................ ................................ ................................ ................ 2 ................................ ................................ ................................ ................ 2 Mounting EL Displays ................................ ................................ .................
ページ4に含まれる内容の要旨
EL552.256-Q2 ♦ > 160 ° ♦ < ♦ ♦ ♦ ♦ ♦ Installing and Handling C AUTION : examine this assembly in a static-controlled area only. When shipping, use packing materials designed for protection of electrostatic-sensitive 2 EL552.256-Q2 Operations Manual (OM410-00) components. These components are electrostatic-sensitive. Unpack, assemble, and The display uses CMOS and power MOSFET devices. the display. Do not drop, bend or flex the display. Do not allow objects to strike the surface of 4-bit LCD-
ページ5に含まれる内容の要旨
CAUTION: To prevent injury in the event of glass breakage, the use of viewer side of the display. AC 3 EL552.256-Q2 Operations Manual (OM410-00) particles embedded in a re-used cloth. recommended to minimize the risk of inadvertently scratching the display with sparingly to a soft cloth, then wipe the display. Disposable cleaning cloths are Clean the display glass with mild, water-based detergents only. Apply the cleaner As with any glass or coated surface, care should be taken to minimize scrat
ページ6に含まれる内容の要旨
EL552.256-Q2 Specifications ° 1 V L t ≥ 0 1 t ≥ 0 1 V t ≥ 0 t ≥ 0 H 2 2 Figure 1 . Power Supply and Logic Signal Sequencing up sequence must be used and the minimum and maximum specifications in this manual should be met without exception. H L 4 EL552.256-Q2 Operations Manual (OM410-00) ) should be present whenever video input signals or logic supply voltage (V ). The All internal high voltages are generated from the display supply voltage (V Note: To ensure the long-term reliability of the disp
ページ7に含まれる内容の要旨
V H Table 1 . Video Input Voltage Requirements Min. Max. Units Maximum input voltage -- 5.5 V -0.3 0.9 V 3.7 5.0 V Low-level input current (IIL) -- -0.4 mA High-level input current (IIH) -- 10 μA Output high voltage (@ Ioh=0.4mA) 2.4 -- V -- 0.4 V All inputs are CMOS with 130 W series resistors, except VS, which is 1K W. -1630 -2630 -2030 Figure 2 & B 2 . Table 2 . Connector P0 Pinouts 1 V (+12V) 2 V (+12V) H H 3 V (+5V) 4 V (+5V) L L 5 6 2 1 7 Ground 8 Ground 9 10 Ground 11 12 Ground 13 14
ページ8に含まれる内容の要旨
EL552.256-Q2 INT. Default Jumper Setting Table 3 . Power Supply Input Voltages Name Min. Max. Units Input voltage: nom. = 12.0 V Input voltage: absolute max. VH max --- Input current: max. IH max --- A Input voltage: nom. = 5.0 V Input voltage: absolute max. VI max --- Input Current max IL max --- A Name Min. Max. Units Input voltage: nom. = 12.0 V Input voltage: absolute max. VH max --- Input current: max. IH max --- A Video Input Signals VS VS VS 6 EL552.256-Q2 Operations Manual (OM410-00) re
ページ9に含まれる内容の要旨
VS HS . 3 6 4 5 7 8 10 9 11 1 2 Figure 3 . Video Input Timing Diagram Table 4 Num Min. Max. Units 1 HS high time 20 2 20 3 20 4 20 5 tVIDhd 20 6 100 VCLK rise, fall time 15 7 15 8 VCLK high width tVCLKh 15 9 140 10 tVShd 140 11 12 32.5 256 Frame Rate 50 120 7 EL552.256-Q2 Operations Manual (OM410-00) Hz fVS tHS tVS VS period usec tHS HS period nsec nsec VS hold after HS nsec tVSsu VS setup to HS nsec nsec tVCLKl VCLK low width nsec tVCLKrf nsec tVCLK Video clock period nsec VID hold from VCLK ns
ページ10に含まれる内容の要旨
EL552.256-Q2 0 3 4 HS . EL Panel 5 1 9 2 6 3 7 4 8 Figure 4 . Pixel Location vs. Sequence of Data 8 EL552.256-Q2 Operations Manual (OM410-00) power up to enter normal operation. you turn the display on again, apply video signals in less than 2.5 seconds after reapplying power to allow the internal capacitors to completely discharge. When After the self-test, turn the display off and wait at least 15 seconds before 2.5 seconds from 3 pixels on/1 pixel off to 1 pixel on/3 pixels off. self-test sca
ページ11に含まれる内容の要旨
Table 5 . Optical Specifications Luminance L (areal), min 34.5 cd/m² screen center, 120 Hz frame rate L (areal), typ 50 cd/m² screen center, 120 Hz frame rate L (pixel), max 0.2 cd/m² 5 points: center plus four corners measured 1.0 ± Non-uniformity All pixels fully lit 26% the formula: LNU%=[1- (min_lum/max_lum)] x 100 Luminance Variation (Temperature) Maximum ± 15% Across operating temperature range Luminance Variation (Time) Maximum <10% 15,000 hours at 25 ° C ambient Minimum >160 ° Contrast R
ページ12に含まれる内容の要旨
EL552.256-Q2 Table 6 . Environmental Specifications Operating 0 to +65 °C -40 °C to +75 °C Temperature* Humidity Non-condensing to 93% RH max @40 ºC, per IEC 68-2-3 Altitude Tested per IEC 68-2-13 16,000 ft. (4.8 km) 58,000 ft. (17.7 km) Vibration (random) 2 (Operating/non- 0.02 g /Hz at 20-500 Hz for 30 minutes on each operating) axis, per IEC 68-2-36, test Fdb. Mechanical Shock Operating/non-operating 50 g with 11 ms duration, half sine wave, 3 shocks on each of 6 surfaces, per IEC 68-2-27, t
ページ13に含まれる内容の要旨
Table 7 . Mechanical Specifications Display External Dimensions 109.73 (4.32) w/o mounting tabs 98.68 (3.885) millimeters (inches) Width 176.78 (6.96) Depth* 16.26 (0.64) 19.05 (0.750) Width 50.8 (2.0) Length 133.35 (5.250) 262 grams (0.6 lbs.), nominal 9.33 grams (0.187 lbs.) Fill Factor 59.2% nominal Width 67.564 (2.660) 145.745 (5.738) millimeters (inches) Diagonal 6.33" Width 0.203 (0.008) 0.203 (0.008) millimeters (inches) Pixel Pitch Width 0.264 (0.0104) 0.264 (0.0104) millimeters (i
ページ14に含まれる内容の要旨
EL552.256-Q2 Figure 5 Note: 12 EL552.256-Q2 Operations Manual (OM410-00) Applications Engineering to request the actual drawing prior to beginning your design. The dimensions in this drawing are approximate. Please contact Planar . Display Dimensions Converter are in inches; millimeters in brackets. Some hidden lines are omitted for clarity. Dimensions of the display are in millimeters; inches are in brackets. Dimensions of the DC/DC
ページ15に含まれる内容の要旨
Ordering Information Part Number 996-0245-02 EL552.256-Q2 ICEBrite display, operating temperature range 0 to +65 ° C. EL552.256-Q2 NE 996-0245-03 mounting tabs removed. Support and Service For a Returned Material Authorization description of the problem, and mark the outside of the shipping container with the RMA number. with the model number(s) and serial number(s). When returning goods for repair, please include a brief number, please contact Planar Systems, Inc. RMA Procedure: integration o
ページ16に含まれる内容の要旨
P.O. Box 46 P.O. Box 4001 Olarinluoma 9 13950 Karl Braun Drive Tel. (503) 690-1100 Fax (503) 690-1493 Tel. +358-9-42 001 0 Tel. (503) 614-4111 Fax (503) 614-4101 sales@planar.com intlsales@planar.com Visit the Planar website at http://www.planar.com for Application Notes and other Operating Manuals 14 EL552.256-Q2 Operations Manual (OM410-00) OM410-00 tech_support@planar.com display_solutions@planar.com app_eng@planar.com Fax +358-9-422 143 Beaverton, OR 97076-4001 FIN-02201 Espoo, Finland Beave
