ページ1に含まれる内容の要旨
FE8171V FE8171V
3.1MP • 360º Surround View • WDR Enhanced • EN50155
Rev. 1.1a
ページ2に含まれる内容の要旨
VIVOTEK Table of Contents Overview4 Read Before Use .....................................................................................................................................5 Package Contents ......................................................
ページ3に含まれる内容の要旨
VIVOTEK Day/Night Settings ............................................................................................................................................... 78 Preference .......................................................................................................................................................... 79 Exposure ..............................................................................................................................................
ページ4に含まれる内容の要旨
VIVOTEK Overview VIVOTEK FE8171V is the first fisheye fixed dome network camera from VIVOTEK, featuring detailed 3.1MP-resolution sensor with superb image quality. Equipped with a fisheye lens for 180° panoramic view (wall mount) or 360° surround view (ceiling/floor/table mount) without blind spots, this camera is able to provide an 8X wider field of view than a standard VGA camera, significantly reducing the need for multiple camera installations. It is extremely suitable for monitoring o
ページ5に含まれる内容の要旨
VIVOTEK Read Before Use The use of surveillance devices may be prohibited by law in your country. The Network Camera is not only a high-performance web-ready camera but can also be part of a flexible surveillance system. It is the user’s responsibility to ensure that the operation of such devices is legal before installing this unit for its intended use. It is important to first verify that all contents received are complete according to the Package Contents listed below. Take note of the
ページ6に含まれる内容の要旨
VIVOTEK Physical Description Inner View Contacts for Internal Microphone (B) Lens Pin Header (J7) Spring Contacts (A) Align (B) to (A) when attaching the dome cover i Pin Header (J6) Ethernet 10/100 RJ45 Socket MicroSD/SDHC/SDXC Card Slot Reset Button 6 - User's Manual
ページ7に含まれる内容の要旨
VIVOTEK Outer View IP66-rated Vandal- proof Dome Cover Built-in Microphone Network Camera Model No: FE8171V IMPORTANT! Record the MAC MAC: 0002D1XXXXXX address under the camera base This device complies with part 15 of the FCC Rules. Operation is subject to before installing the camera. the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Pat. 6,
ページ8に含まれる内容の要旨
VIVOTEK DI/DO Diagram Please refer to the following illustration for the connection method. 12V PIN 1 Power+12V PIN 2 Digital output +12V PIN 3 Digital input PIN 4 Ground Hardware Reset Reset Button The reset button is used to reset the system or restore the factory default settings. Sometimes resetting the system can return the camera to normal operation. If the system problems remain after reset, press the reset button longer to restore the factory settings and install again. Reset: Press
ページ9に含まれる内容の要旨
VIVOTEK Hardware Installation Opening Dome Cover First, use the included T20 hex key stardriver to loosen the four screws and detach the dome cover from the camera base. Follow the steps below to install the camera either to a ceiling or a wall. Tamper-proof Screw Connect the supplied power & i IO cables if your switch does not support PoE. Rubber Stopper on the Hole for Power & IO Dome Cover Retainer Cables Rubber Seal Plug for RJ45 Ethernet Cable Dome Cover Retainer User's Manua
ページ10に含まれる内容の要旨
VIVOTEK Connecting RJ45 Ethernet Cable RJ45 Cable Dimension (unit: mm) NOTE: Recommended cable gauge: 24AWG (0.51 mm) This equipment is only to be connected to PoE networks Assembling Steps without routing to outside plant. 1 Rubber Seal 1. Drill a hole on the rubber seal plug and insert Plug an Ethernet cable through the opening. 2 2. Strip part of the sheath from the Ethernet ca- ble. 3 3. You will need an RJ45 crimping tool to attach the Ethernet wires to a connector. When done, o: w
ページ11に含まれる内容の要旨
VIVOTEK Ceiling/Wall Mount without Mounting Plate (Choose this mounting type if you would like to feed the cables form the bottom of the camera) 1. Attach the supplied alignment sticker for camera base to the ceiling/wall. 2. Using the three circles on the sticker, drill three pilot holes into the ceiling. Then hammer the three supplied plastic anchors into the holes. 3. Drill a cable hole on the ceiling/wall, and feed the cables through the hole. 4. Connect the Ethernet cable to the socket
ページ12に含まれる内容の要旨
VIVOTEK Ceiling/Wall Mount with Mounting Plate (Choose this mounting type if you would like to feed the cables form the side) 1. Attach the supplied alignment sticker for the supplied mounting plate to the ceiling/wall. 2. Using the three circles on the sticker, drill three holes into the ceiling. Then hammer the three supplied plastic anchors into the holes. 3. Arrange and feed the cables through the side of the mounting plate. 4. Secure the mounting plate to the ceiling/wall with three
ページ13に含まれる内容の要旨
PARTTION I LINK RECEIVE POWER COLLISION 1 2 3 4 5 VIVOTEK Network Deployment Setting up the Network Camera over the Internet There are several ways to set up the Network Camera over the Internet. The first way is to set up the Network Camera behind a router. The second way is to utilize a static IP. The third way is to use PPPoE. Internet connection via a router Before enabling the access to the Network Camera over the Internet, make sure you have a router and follow the steps below. 1.
ページ14に含まれる内容の要旨
PARTITION PARTITION LINK RECEIVE POWER COLLISION 1 2 3 4 5 LINK RECEIVE POWER COLLISION 1 2 3 4 5 VIVOTEK Internet connection with static IP Choose this connection type if you are required to use a static IP for the Network Camera. Please refer to LAN configuration on page 58 for details. Internet connection via PPPoE (Point-to-Point over Ethernet) Choose this connection type if you are connected to the Internet via a DSL Line. Please refer to PPPoE on page 49 for details. Set up the Network
ページ15に含まれる内容の要旨
PARTITION LINK RECEIVE POWER COLLISION 1 2 3 4 5 VIVOTEK General Connection (without PoE) 1. If you have external DI devices, make the connection from general I/O terminal block. 2. Ethernet, power and IO cables are user-supplied. Use a Category 5 Cross Cable when Network Camera is directly connected to PC. 3. Connect DC power cord to a DC Adapter, and then to a power outlet. Ethernet Switch 1 2 General I/O Terminal Block Power Cord Socket (Black) Microphone In (Pink) Audio Out (Green) +3V3
ページ16に含まれる内容の要旨
VIVOTEK Software Installation Installation Wizard 2 (IW2), free-bundled software included on the product CD, helps you set up your Network Camera on the LAN. IW2 1. Install IW2 under the Software Utility directory from the software CD. Double click the IW2 shortcut on your desktop to launch the program. Installation Wizard 2 2. The program will conduct an analysis of your network environment. After your network environment is analyzed, please click Next to continue the program. 3. T
ページ17に含まれる内容の要旨
VIVOTEK Ready to Use 1. A browser session with the Network Camera should prompt as shown below. 2. You should be able to see live video from your camera. You may also install the 32-channel recording software from the software CD in a deployment consisting of multiple cameras. For its installation details, please refer to its related documents. User's Manual - 17
ページ18に含まれる内容の要旨
VIVOTEK Accessing the Network Camera This chapter explains how to access the Network Camera through web browsers, RTSP players, 3GPP-compatible mobile devices, and VIVOTEK recording software. Using Web Browsers IMPORTANT! • Currently the Network Camera utilizes 32-bit ActiveX plugin You CAN NOT open a management/view session with the camera using a 64-bit IE browser • If you encounter this problem, try execute the Iexploreexe program from C:\Windows\ SysWOW64 A 32-bit version of IE
ページ19に含まれる内容の要旨
VIVOTEK NOTE: For Mozilla Firefox or Netscape users, your browser will use Quick Time to stream live video If you do not have Quick Time on your computer, please download Quick Time from Apple Inc's website, and then launch your web browser User's Manual - 19
ページ20に含まれる内容の要旨
VIVOTEK NOTE: 1 By default, your Network Camera is not password-protected T o prevent unauthorized access, it is highly recommended to configure a password for your camera later. For more information about how to enable password protection, please refer to Security on page 47 2 If you see a dialogue box indicating that your security settings prohibit running ActiveX Controls®, please enable ActiveX Controls for your browser ® To enable the ActiveX Controls for your browser: 1. C
