ページ1に含まれる内容の要旨
MANUAL
EVT-PB1-H05Q
Video, Power and Data Balun
with Voltage Booster
The ENFORCER EVT-PB1-H05Q Video, Power and Data (VPD) Balun with Voltage Booster
combines the flexibility of a VPD Balun with the ability to boost insufficient voltage for use in CCTV
applications. Boosted DC power is regulated to provide stable power suitable for voltage sensitive
cameras.
Transmit video up to
ページ2に含まれる内容の要旨
ENFORCER Video, Power and Data Balun with Voltage Booster Specifications: EVT-PB1-H05Q Output voltage 5/12/24VDC selectable by jumper (default 12VDC) Input voltage Regulated output voltage Operating voltages 7~12VDC/VAC 12VDC 12~24VDC/VAC 24VDC Output current 500mA @ 5/12/24 VDC Voltage input LED Green indicator Voltage output LED Red 5/12VDC indicator Blue 24VDC Current protection PTC 500mA Range 2,000’ (610m) B/W, 1,300’ Color (400m) Video format RS170, NTSC, PAL, SEC
ページ3に含まれる内容の要旨
ENFORCER Video, Power and Data Balun with Voltage Booster Installation: 1. Run UTP cable to the camera where the VPD balun is being installed. 2. Remove the cover by simultaneously pressing down on the top cover, and lifting up on the side mounting tabs. This will release the tight seal between the top and bottom covers. 3. Set the desired output voltage using the selection jumper according to table 1 below. 4. Connect output wires from the power supply to the power input terminal bl
ページ4に含まれる内容の要旨
ENFORCER Video, Power and Data Balun with Voltage Booster Voltage Booster Efficiency Rate: The EVT-PB1-H05Q has a power efficiency rating of 85%. Under typical conditions, the booster will provide sufficient power to compensate for long cable runs. The following formulas can be used to determine if enough power is present at the power input of the voltage booster: 1. Calculate the amount of power measured in Watts: Voltage x Current = Power 2. For example, if the voltage is 12VD
