ページ13に含まれる内容の要旨
Beeps and LEDs— How Your System Talks to You Touchpads and interior sirens produce a variety of operating beeps to inform you of different sys- tem states and operations. Key Beeps A Key beep is the tone you hear when you press a button on an alphanumeric, fixed display, or handheld wireless touchpad. The sound confirms that the button was pressed adequately. Key Beeps can be turned on or off by the installer. Status Beeps Status beeps come from touchpads, sirens or speakers and are sounded wh
ページ14に含まれる内容の要旨
Basic System This section describes: Operations • What Happens in an Alarm Condition • Fire and Smoke Alarms • Preventing Accidental Alarms • Arming your System • Exit and Entry Delay Times • Bypassing Sensors • Using the Chime Feature • Basic Light Control • Basic Output Control • Checking the Status of Your System For instructions on using a phone to perform any of these functions, see “Using a Touchtone Phone to Operate Your System”. What Happens in an Alarm Condition • Speakers and touchpad
ページ15に含まれる内容の要旨
If the system goes into a fire alarm automatically: 1. Immediately exit the building. 2. Notify the fire department from a safe location (if system is not monitored). If you discover a fire emergency before the system goes into alarm automatically: 1. Press and hold both Fire button(s) for 2 seconds on the nearest touchpad or activate a manual fire pull. 2. Evacuate all occupants from the building. 3. Notify the fire department from a safe location (if system is not monitored). Warning! Do n
ページ16に含まれる内容の要旨
• Check the location of smoke detectors. Smoke detectors located too close to bathrooms and kitchens can trip from steam or smoke from cooking. • Take note of system beeps, voice announcements, and indicator lights which indicate the current system status. Aborting Accidental Alarms Your system can be set up to let you abort an accidental intrusion, Police or Auxiliary alarm. If the Dialer Abort feature is turned on, disarming the system within a specified time period will silence sirens and
ページ17に含まれる内容の要旨
Level 2—STAY Use this level to arm perimeter doors and windows only. Interior devices such as motion sensors remain off so you can stay inside the premises without setting off an alarm. If you wish, you can exit through a designated delay door after arming to Level 2—STAY. To arm to Level 2—STAY using a touchpad: 1. Close all protected perimeter doors and windows. 2. Press 2 at any touchpad. Touchpads display, “ENTER CODE.” Note 3. Enter your Access Code. Touchpads display, “Armed to STAY” a
ページ18に含まれる内容の要旨
Keychain Touchpad Arming Your installer can set up your keychain touchpad to arm the system in one of two ways: • Press the Lock button to arm the system directly to Level 3—AWAY with no Exit Delay. Using this method, you would not be able to arm to Level 2—STAY. • Press the Lock button once for each desired increase in arming level. For example: From Level 1 press the Lock button once to arm to Level 2, press it twice for Level 3, or press it three times to arm to Level 3 with Latchkey act
ページ19に含まれる内容の要旨
Auto STAY Arming Feature The Auto STAY Arming feature helps cut down on false alarms in the event that you arm the system to 3—AWAY, but fail to leave during the Exit Delay time. Here’s how it works: If you arm the system to Level 3—AWAY, and do not leave the premises within the Exit Delay time With feature turned on The system detects that no one opened and closed a delay door within the delay time. It assumes that someone is still inside and arms to 2—STAY to prevent a false alarm. If featu
ページ20に含まれる内容の要旨
3. At any touchpad, press # + CODE (# is labeled Bypass) 4. Touchpads display, “BYPASS SENSOR _ _,” or “ENTER SNSR _ _.” Enter the desired sen- sor number. 5. Touchpads display, “BYPASSED ZONES 01,” or “SENSOR 01 BYPASSED,” for example. 6. If the touchpad displays “INVALID,” or “FAILURE,” or if the touchpad sounds one long beep, make sure that you entered a valid sensor number. Smoke/heat sensors cannot be bypassed. 7. Bypass other sensors if desired, by repeating Step 3. 8. The bypassed doors
ページ1に含まれる内容の要旨
466-2183 Rev B
June 2005
GE Security
g
www.gesecurity.com
Part Numbers:
600-1021-95R
600-1022-95R
600-1040
600-1042
Concord 4 Series Security Systems
user guide
National Security Systems Inc (800)457-1999
ページ2に含まれる内容の要旨
Notices FCC Part 15 Information to the User Changes or modifications not expressly approved by GE Security can void the user’s authority to operate the equipment. FCC Part 15 Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy
ページ3に含まれる内容の要旨
Commands at a Glance Disarm the system. 1 + CODE Cancel an accidental alarm. CODE or 1 + CODE Arm to Level 2—STAY.* 2 + CODE Arm to Level 3—AWAY.* 3 + CODE Send a police alarm. Press and hold both POLICE buttons for 2 seconds. Send an auxiliary alarm. Press and hold both AUXILIARY buttons for 2 seconds. Send a fire alarm. Press and hold both FIRE buttons for 2 seconds. 8573G51A.D Arm system with No Delay.* 2 + CODE + 4 or 3 + CODE + 4 Arm system for Latchkey.* 2 + CODE + 6 or 3 + CODE + 6 By
ページ4に含まれる内容の要旨
0 Concord 4 Series Security Systems
ページ5に含まれる内容の要旨
Contents Commands at a Glance - 1 Getting to Know Your Security System 1 Panel .......................................................................................................................................... 1 Touchpads ................................................................................................................................. 1 Door/Window Sensors .............................................................................................................. 1 Motio
ページ6に含まれる内容の要旨
Checking the Status of Your System ........................................................................................... 11 Short System Status ................................................................................................................ 11 Full System Status ................................................................................................................... 11 Panic Alarms 11 Fire Panic Alarm ...............................................................
ページ7に含まれる内容の要旨
Example 1 of One Day Rollover .......................................................................................................21 Example 2 of One Day Rollover .......................................................................................................21 Multiple Day Rollover ............................................................................................................ 21 Example of Multiple Day Rollover .............................................................
ページ8に含まれる内容の要旨
Arming and Disarming Another Partition ............................................................................... 29 Programming Another Partition .............................................................................................. 29 Arming and Disarming Multiple Partitions at the Same Time .................................................... 29 Notes on Arming/Disarming Multiple Partitions from Alphanumeric and Fixed Display Touchpads ...........................................
ページ9に含まれる内容の要旨
Accidental Smoke and Fire Alarms ............................................................................................ 46 Dialer Abort ................................................................................................................................. 46 Doors and Delay Time Settings ................................................................................................... 46 System Features.............................................................................
ページ10に含まれる内容の要旨
x Installation Instructions
ページ11に含まれる内容の要旨
Getting to Know Your security system consists of different components. Each component plays a special role in system operation (Figure 1). Your Security System
, - - ! "
" " # " .
! "
ページ12に含まれる内容の要旨
Communicating Touchpads let you communicate with the system (Figure 2). with the System
, / , # / ! 0
, - - /
, - - " ! 1 ! " 2 # ! " *
$ % # . /
&
