ページ1に含まれる内容の要旨
Camping Flashlight Camping Flashlight Camping Flashlight
Camping Flashlight Camping Flashlight
92061
ASSEMBLY AND OPERATING INSTRUCTIONS
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
®
Copyright © 2004 by Harbor Freight Flashlights . All rights reserved. No portion of
this manual or any artwork contained herein may be reproduced in any shape or form
without the express written consent of Harbor Freight Flashlights.
For technical questions and re
ページ2に含まれる内容の要旨
Specifications Builtincompass (2) 2.4 VDC "AA" batteries Features: Power Source: (4) interchangeable lenses (notincluded) Hs ead Angle:9: 0 degree N. etWeight 0.2 lbs Ws ater Resistant:R: ubber coated withrubber sealB. ulb Required Krypton2.4 VDC 7.75 amp This flashlight is ideal for camping and outdoor use. The 90 degree head angle makes it easy to shine the light ahead while holding the flashlight at a natural angle. The four interchangeable colored lenses allow you to suit the flashlight to y
ページ3に含まれる内容の要旨
6. Maintain flashlights with care. Keep flashlights maintained and clean for better and safer performance. Follow instructions for maintenance and changing accessories. The handles must be kept clean, dry, and free from oil and grease at all times. 7. Disconnect power. Turn off flashlight when not in use. Remove batteries if flashlight is not going to be used for a long period of time. 8. Avoid unintentional starting. Be sure the switch is in the Off position when not in use and before replac
ページ4に含まれる内容の要旨
cur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. Unpacking When unpacking, check to make sure the following parts are included. Flashlight 4 filters stored in the filter compartment Spare Krypton bulb, stored in the spare bulb compartment If any parts are missing or broken, please call Harbor Freight Flashlights at the number on the cover of this manual. NOTE: Warranty replacement p
ページ5に含まれる内容の要旨
Select and install the desired lense. 1. The lenses are stored in a compartment at the bottom of the flashlight, under the compass. Open this compartment by turning the cap counterclockwise. 2. Select the desired lense. NOTE: Your preference may vary, but suggested lens application is: RED for very low light output, GREEN for low light output, YELLOW for contrast in haze or fog, FROSTED for diffused light. 3. To change or install the lense, remove the lense cover by turning counterclockwise. Rep
ページ6に含まれる内容の要旨
3. In case the bulb burns out, a spare battery is stored in a container at the bottom of the flashlight. Remove the battery by turning the storage container counterclockwise. 4. Remove the Lantern Head by turning it counterclockwise. Please refer to the photo at left. Remove the Bulb Holder from the Lantern Head by turning it counterclockwise. 6. Remove the old bulb from the Bulb Holder by pulling it straight out. Place the new bulb in the Bulb Holder, and replace the Bulb Holder in the Lantern
