ページ1に含まれる内容の要旨
INSTALLATION INSTRUCTIONS
MODEL 780-95
“PLASMA FRIENDLY” J-BOX INFRARED RECEIVER
TABLE OF CONTENTS
Introduction...................................................................................................................................................................... 1
Features ...................................................................................................................................................................... 1
Specifications .....................
ページ2に含まれる内容の要旨
Page 2 Model 780-95
!"#$!# Figure 1 – 780-95: Front & Rear View SPECIFICATIONS • Infrared modulation frequency bandwidth: 30 - 100 kHz • Reception range: up to 50 feet (18M), depending on local conditions • Reception angle: 45 degrees off axis at 50% range reduction • Cable requirements: 3-conductor. Use 24-gauge up to 200' (61M), 22 gauge up to 600' (180M), 20-gauge up to 2000' (600M), 18- g
ページ3に含まれる内容の要旨
++ %% )** * . ) = , , ++ ,%% 0 9 )** * . ) = 0 0 , ,
Model 780-95 Page 3 APPLICATION WIRING A typical system, with a 780-95, 781RG Power Supply and 283M Emitters plugged into a 789-44 Connecting Block, is shown in Figure 3: 1. Wire the appropriate leads of the 3 or 4-conductor cable from the 780-95 to the +12VDC, GND, STATUS (if applicable), and IR IN terminals
ページ4に含まれる内容の要旨
++ %% )** * . ) = , ,
Page 4 Model 780-95 USING THE STATUS LED INDICATOR The 780-95 Plasma Friendly IR Receiver includes a Status LED located just below the Talkback LED (See Fig. 1). This permits the system to have a visible power ON/OFF indicator in the remote room. When used with any of Xantech’s Whole-house Audio Video Entertainment systems such as the MRC-88, MRC-44 (MRC44CB1 required) or the ZPR68-10 Pre-Amp as part
