ページ1に含まれる内容の要旨
XP SBC HC 300 12-06-2001 12:56 Pagina 1
HC300
Wireless FM Stereo Headphone
ページ2に含まれる内容の要旨
XP SBC HC 300 12-06-2001 12:56 Pagina 2 3
ページ3に含まれる内容の要旨
XP SBC HC 300 12-06-2001 12:56 Pagina 3 Index ______________________________________________ English 4 _____________________________________________ Italiano 11 _____________________________________________ Español 18 ___________________________________________ 25 2 Español Italiano English
ページ4に含まれる内容の要旨
English XP SBC HC 300 12-06-2001 12:56 Pagina 4 Introduction General information Congratulations! IMPORTANT Before using the FM headphone for the You have just bought the most first time, please ensure that the sophisticated FM wireless stereo sound batteries are fully charged for about system.This system uses the latest FM 16 hours.This will guarantee a longer wireless technology, which gives you operating lifetime of the batteries. complete freedom of movement while enjoying your favorite mu
ページ5に含まれる内容の要旨
XP SBC HC 300 12-06-2001 12:56 Pagina 5 General information Controls Multiple headphones with one Transmitter (figure 1) transmitter 1 Power indicator – lights up when audio An additional number of headphones signals are detected at the audio input. and/or wireless speakers can be used with a 2 DC power – connect to the 12 Volt/ single transmitter if they: 200 mA AC/DC adapter. - operate in the 433 MHz band - can detect a 19 kHz pilot tone. 3 3.5 mm stereo headphone audio input – the audio cab
ページ6に含まれる内容の要旨
English XP SBC HC 300 12-06-2001 12:56 Pagina 6 Installation Transmitter power supply Headphone power supply IMPORTANT IMPORTANT Use only Philips SBC CS030/00 Use only rechargeable LR03/AAA 12 Volt/200 mA AC/DC adapter. NiMH batteries (preferably Philips). (For UK, use only Philips SBC CS030/05) Do not use NiCd batteries or alkaline batteries as these may damage 1 Make sure the adapter’s rated voltage your FM wireless system! corresponds to the mains socket voltage. 1 Check if the power button
ページ7に含まれる内容の要旨
XP SBC HC 300 12-06-2001 12:56 Pagina 7 Installation Audio Connections 2 Switch on your audio source and carefully Headphone battery increase the volume of the audio source. replacement (figure 3) The red power indication LED of the IMPORTANT transmitter lights up if receiving an audio Use only rechargeable LR03/AAA signal. NiMH batteries (preferably Philips). 3 Switch on the headphone.You may hear a Do not use NiCd batteries or hissing sound through the headphone if the alkaline batteries as t
ページ8に含まれる内容の要旨
English XP SBC HC 300 12-06-2001 12:56 Pagina 8 Troubleshooting If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the warranty. Problem Remedy No sound – Check if the AC/DC adapter is fully inserted into the AC outlet and that its DC connector is properly i
ページ9に含まれる内容の要旨
XP SBC HC 300 12-06-2001 12:56 Pagina 9 Specifications Regulations System: Radio Frequency (RF) Carrier Frequency: Channel 1: 433.5 MHz (Transmitter HC332) Channel 2: 434.5 MHz Carrier Frequency: 433.0 to 435.0 MHz (Manual tuning) (Headphone HC305) Modulation: Frequency Modulation (FM) Radiated Output Power: <10m Watt Effective Transmission Range: up to100 meters, omni directional (360º) Input level: 500 mVrms (1 kHz sine wave) Power supply – transmitter: 12Volt / 200 mA DC, centre positive Pow
ページ10に含まれる内容の要旨
English Español Español XP SBC HC 300 12-06-2001 12:56 Pagina 10 Meet Philips at the Internet http://www.philips.com SBC HC 300 Printed in China /CMM RM 0126