ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
www .H2OAudio .com Deep Dive Waterproof Case & Speakers Depth Rating 300ft/90m For updated manuals please visit our web site www.h2oaudio.com iDV1-75 20080819
ページ3に含まれる内容の要旨
O-ring Mask Clip Lanyard Hole Speaker ® iPod Control Buttons Insert Holes & Height Adjuster Holes LED lights Battery Cover Cam Knob Depth Rating 300ft / 90m Connector Cable Cam Knob Lock 1 2
ページ4に含まれる内容の要旨
Quickstart: Instructions: I. Getting Familiar with the iDive300 Before using the iDive300 for the fi rst time, it is highly recommended that you become familiar with opening and closing the case to ensure the case is sealed properly during use. To verify that you have I. Read “Getting Familiar with the iDive 300” sealed the case properly we recommend that you test the product without an iPod inside before initial use. Please follow the instructions below: II. Unlock and open case 1. Read the
ページ5に含まれる内容の要旨
IT IS EXTREMELY IMPORTANT YOU ENSURE THE O-RING IS PROPERLY SEATED IN ITS TRACK AND IS FREE OF DEBRIS BEFORE EACH USE. FAILURE TO DO SO MAY CAUSE DAMAGE TO OR DESTROY YOUR IPOD. 4. Install O-ring into the lid ensuring it is aligned properly with the round side of the O-ring facing out. 5. Apply a thin layer of the supplied silicone grease to the O-ring. Prior to use verify: 1. The O-ring is lightly lubricated and seated within the track in the lid. 2. The O-ring and contact surface are fre
ページ6に含まれる内容の要旨
To Close Case V. Install iPod specifi c inserts and height adjusters 1. Close lid The inserts and height adjusters are used to securely hold your iPod in the correct location inside the case. 2. Rotate the cam knob clockwise 180° 3. Close the cam knob lock Consult the following chart to determine which inserts and height adjusters should be used with your iPod model. Please note some iPod models will not require height adjusters. Height Adjuster iPod Model Upper Insert Letter Lower Insert Let
ページ7に含まれる内容の要旨
Included insert and height adjusters Insert and height adjuster reference A B Inserts and height adjusters are labeled to aid identifi cation. A 1 2 1 2 B B A th iPod touch iPhone & iPhone 3G iPod 5 Gen (30 Gb) B B B 4 3 3 4 B B B Insert A Insert B Height Adjuster 1 Height Adjuster 2 th iPod 5 Gen (60/80 Gb) iPod classic (80 Gb) iPod classic (160 Gb) C C D D C C st nd rd Insert C Insert D Height Adjuster 3 Height Adjuster 4 iPod nano 1 Gen iPod nano 2 Gen iPod nano 3 Gen As new iPods become ava
ページ8に含まれる内容の要旨
Power On/Off VI. Insert iPod 1. Ensure the correct inserts and height adjusters are installed for your iPod Press and hold the power button for 2 seconds to turn the iDive300 on/off. (PLEASE NOTE: If the correct insert and height adjusters are not used After turning the iDive300 on, all 3 LEDs on the back of the case should illuminate within a few seconds. you may damage or destroy your iPod and the iDive300) If connected successfully only the Green LED should remain lit. 2. Place iPod in
ページ9に含まれる内容の要旨
In case of a Steady Red LED For Mask Strap Mounting: To Remove Mask Clip: 1. Ensure you are using a supported iPod model. 2. Ensure the iPod is fully charged. 3. Ensure the iPod is turned on. Feed mask strap 4. Disconnect & reconnect the connector cable. through the slits in each slot of the clip. In case of a Flashing Red LED 1. Batteries of the iDive300 case are running low – change or recharge them soon. Mode Button Note: The current fi rmware release does not support the “Photo” mode on iP
ページ10に含まれる内容の要旨
CAUTION: Do not store case in the following environments: XI. FCC Certifi cation: * Solvents or other chemical fumes This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) * High humidity This device may not cause harmful interference and (2) This device must accept any interference, received, * High Ozone including interference that may cause undesired operation. * Extreme temperature fl uctuations Note: This equipment has been tested and
ページ11に含まれる内容の要旨
been neglected, altered, abused, used for a purpose other than the one for which they were manufactured, Improper use of this system may cause the user to make mistakes or decisions that may lead to serious injury or death. repaired by customer or any party without H2O Audio’s written authorization, or used in any manner inconsistent with H2O Audio’s instructions. Please refer to the care and maintenance instructions for more details. Product Manuals are available for download on the H2O Aud
ページ12に含まれる内容の要旨
To Obtain Service: FAQ’s: Please go to support section of our website or contact customer support at Customer Support Hours and Contact Information: Q: Will this product work with the original iPhone or 3G iPhone? Monday through Friday 9AM to 5PM PT Tel: 858.623.0339 A: Yes, however, the user will experience interference with phone functions. Toll Free: 800-708-6080 support@h2oaudio.com Q: Why does the volume turn low when I install my iPod? PLEASE NOTE: No service returns will be accepted witho
ページ13に含まれる内容の要旨
Q: Why is the Red LED fl ashing? A: The iDive300 is designed to measure battery-life of the 3-AA batteries that are used to power the “Made for iPod” connection electronics and the power amplifi er. The Red LED will start to fl ash when the batteries have approximately 25% charge remaining. Note, the battery indicator of the iPod does not refl ect the power remaining in the 3-AA batteries. Notes: - “Made for iPod” means that an electronic accessory has been designed to connect specifi cally to
ページ14に含まれる内容の要旨
www .H2OAudio .com 11010 Roselle St. Suite 150, San Diego CA, 92121 Phone: 1.800.708.6080 or 858.623.0339 Email: support@h2oaudio.com Copyright Notice: This owner’s manual is copyrighted, all rights reserved. It may not, in whole or in part, be copied, photocopied, reproduced, translated, or formed into any electronic format without prior consent in writing. H2O Audio is a registered trademark of H2O Audio, Inc. Apple and iPod are registered trademarks of Apple Inc. Patents 6396769, 6614722, 69
