ページ1に含まれる内容の要旨
8289676000
(525714)
ページ2に含まれる内容の要旨
The lightning flash with arrowhead sym- bol, within an equilateral triangle, is in- CAUTION tended to alert the user to the presence RISK OF ELECTRIC SHOCK of uninsulated “dangerous voltage” within DO NOT OPEN the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, The exclamation point within an equilater- DO NOT REMOVE COVER (OR BACK). al triangle is intended to alert the user to NO USE
ページ3に含まれる内容の要旨
FCC (U.S.A.) & ICES-003 (Canada) INFORMATION Table of contents 1. IMPORTANT NOTICE Safety instructions ......................................... E-2 This product, when installed as indicated in the Table of contents ........................................... E-3 instructions contained in this manual, meets FCC and ICES-003 requirements. Changes or modifica- Introduction ................................................... E-4 tions not expressly approved by Fostex Company Overview ...........
ページ4に含まれる内容の要旨
Introduction Power supply Thank you very much for purchasing the Fostex The HP-P1 runs on the lithium-ion battery integrat- HP-P1. ed with in the unit. To ensure the best performance, read this manual You can charge the battery from your personal thoroughly before using the unit. Keep this manual computer that is USB-connected to the unit. handy for future reference. When you purchase the unit, the battery is not fully-charged. Therefore, it is recommended to fully charge the battery bef
ページ5に含まれる内容の要旨
Names and functions Front panel Top panel ❶ ❷ ❸ ❹ ❺ ❻ Status indicator When the internal battery is being charged (i.e. a person- al computer is connected to the [DC-IN] port and a power is supplied from it), this indi- cator lights in green. When the power is on and an iPod or iPhone is connected, the indicator lights in red. ❶ U S B c o n n e c t o r ( t y p e A ) f o r D o c k When the internal battery is Connector to USB cable being charged and an iPod or iPhone is connected, the Co
ページ6に含まれる内容の要旨
Connecting a sound source Connecting an iPod/iPhone : • When the HP-P1 is turned on, the headphone jack of the connected iPod/iPhone is dis- abled. Connectable iPod/iPhone models • When the analog input jack is plugged in, The following are the iPod/iPhone models con- the iPod/iPhone signal is not output from the nectable to the HP-P1 (as of January 2011 ). HP-P1 (the analog input signal takes priority :The “connectable models” means the over the iPod/iPhone signal). models t
ページ7に含まれる内容の要旨
Connecting a general audio source Connecting a recorder or audio amplifier By connecting an audio device that provides the In addition to the headphone output, the HP-P1 analog line output to the analog input jack of the also provides the [LINE OUT] jack that feeds the HP-P1, you can monitor high quality audio sound analog signal as well as the [S/PDIF] output jack via headphones. that feeds the S/PDIF digital signal. Audio.device By connecting a recorder or audio amplifier to ei- Analog
ページ8に含まれる内容の要旨
Turning on or off the power Various settings When you enjoy music via headphones, make the Turning on the power following settings appropriately depending on the circumstance or your preference. To turn on the power, follow the procedure below. 1. Make sure that all the connections between the Adjusting the volume HP-P1 and external devices are made. You can adjust the headphone volume using the power switch/volume control. 2. Make sure that the internal battery is charged or the [DC-IN]
ページ9に含まれる内容の要旨
Setting the filter Specifications You can select the digital filter type using the [FIL- • Headphone output jack (stereo mini jack) TER] switch depending on your preference. Maximum output power: 80 mW + 80 mW Applicable load impedance: 16 ohms or more Frequency response: 20 Hz to 20 kHz +/- 0.3 dB (at 32 ohm load, 80 mW output power) • [LINE OUT] jack (stereo mini jack) Nominal output level: -10 dBV • Analog input jack (stereo mini jack) Maximum input: Approx. 3.0 Vrms There are two switch
ページ10に含まれる内容の要旨
Declaration of EC Directive This equipment is compatible with the EMC Directive (2004/108/EC) - Directive on approximation of member nation's ordinance concerning the electromagnetic compatibility and with the Low Voltage Directive (73/23/EEC) - Directive on approximation of member nation's ordinance concerning electric equipment designed to be used within the specified voltage range. The Affect of Immunity on This Equipment The affect of the European Specification EN61000-6-1 (coexistence of
