ページ1に含まれる内容の要旨
Installation Guide
NOTICE OF INTENDED INSTALLATION AND USE E
THE ROSEN MULTI-MEDIA NAVIGATION SYSTEMS CONTAIN AN INTERNAL VIDEO PLAYER, WHICH IS
NOT INTENDED FOR VIEWING BY THE DRIVER. THE VIDEO PLAYER IS DISABLED WHEN THE
VEHICLE IS IN MOTION THROUGH A CONNECTION TO THE PARKING BRAKE. THE INSTALLER OF
THIS PRODUCT MUST INSURE THE VIDEO DISABLE CONNECTION IS WORKING PROPERLY PRIOR TO
DELIVERY OF THE VEHI
ページ2に含まれる内容の要旨
Installation Guide Toyota Corolla 2 - Inspect the vehicle and plan your work CHECK THE BATTERY Test the battery voltage to make sure it’s fully charged and inspect battery terminals for tightness and any corrosion. This only takes seconds and can save hours of troubleshooting later. New Vehicles RARELY have a fully charged battery. This can cause many system malfunctions. 3 – Turn the Vehicle OFF or Disconnect the Battery TURN THE VEHICLE OFF
ページ3に含まれる内容の要旨
Installation Guide Toyota Corolla 5 - Remove the Factory Radio You will need to remove the Factory Radio and prepare the Rosen Multi-Media unit for installation. The following steps will help guide you through this process. Note: Be sure to inspect all brackets and clips to ensure they were not damaged during the removal process. If any brackets or clips were damaged, replace them prior to installation of the Rosen unit. Step 1: Remove the Mounting Step 2: Unplug the Electric
ページ4に含まれる内容の要旨
Installation Guide Toyota Corolla 7 – Connect and Install the Rosen Unit You will need to make the Electrical Connections and install the Rosen Unit. The following steps will help guide you through this process. Note: Connect BRAKE WIRE (blue w/ white) to Emergency brake switch wire (ground when E-brake is engaged). This insures video is disabled while vehicle is in motion. Note: Use caution when locating the wire harnesses to be sure they will not be damaged when the Rosen
ページ5に含まれる内容の要旨
Installation Guide Toyota Corolla 9 – Touch Screen Calibration and Installer Settings The system was calibrated at the factory, however re-calibrate the system if the touch screen positions do not appear to align with the buttons or icons. Calibrate the Primary Touch Screen – Note: There are TWO Calibrations for the Touch Screen in the Rosen unit. To Calibrate the Primary Touch Screen Operation of the unit (Radio, DVD, BT etc) follow these steps: Step 1: Select Main from any S
ページ6に含まれる内容の要旨
Installation Guide Toyota Corolla 10 – Pre-Delivery Test You will need to fully test the system to ensure it is working and connected to the vehicle properly. The following steps will guide you through this process. Step 1: Initial Test a. Reconnect the vehicle battery if needed b. Start the vehicle (ensure that it is safe to do so) c. Perform the following steps on the Multi-Media Systems to ensure proper operation: Turn the unit ON • Select all available sources • o Sele
ページ7に含まれる内容の要旨
Installation Guide Toyota Corolla Wiring diagram Rosen Entertainment Systems Copyright 2007 all rights reserved Installation Guide DP-TY0824 Rev A Page 7
ページ8に含まれる内容の要旨
Installation Guide Toyota Corolla www.RosenEntertainment.com Rosen Entertainment Systems Copyright 2007 all rights reserved Installation Guide DP-TY0824 Rev A Page 8
