ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
Important Safety Instructions ， CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USE-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric to perso
ページ3に含まれる内容の要旨
Important Safety Instructions NOTES 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with a damp cloth. 7) Do not block any of the ventilation openings. Install in accordance with the manufacturer's instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9) Do not defe
ページ4に含まれる内容の要旨
Important Safety Instructions Warning Failure to avoid the following potentially hazardous situations may result in injury or property damage. The unit is designed to provide you with route suggestions. It does not reflect road closures or road conditions, traffic congestion, weather conditions, or other factors that may affect safety or timing while driving. Use the unit only as a navigational aid. Do not attempt to use the unit for any purpose requiring precise measurement of dire
ページ5に含まれる内容の要旨
Important Safety Instructions Note: This equipment has been tested and found to comply with limits for Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception, whi
ページ6に含まれる内容の要旨
Accessories Accessories List ITEM NAME QTY Instruction Manual 2 Car Adaptor 1 Mounting Bracket 1 USB Cable 1 Mounting Cradle 1 Stylus 1 Dashboard Mount Disk 1 SD Card 1 Pouch 1 NOTE Accessories and their parts numbers are subject to modification without prior notice due to improvements. 5
ページ7に含まれる内容の要旨
Contents …………………………………..………..1 Important Safety Instructions ……………………………….…………...5 Accessories ……………………………….…………...7 View of Main Unit ……………………………….……….…..8 System Connections Power Supply Preparation …………………………….……….….….10 General Setup ……………………………….…………..11 Playing Music …………………………….……………..15 Photo Viewer ……………………………….…………..17 ……………………………….…………..19 Use of the Mount Accessories ……………………………….…………..20 Troubles
ページ8に含まれる内容の要旨
View of Main Unit 1. POWER Button Press for a longer time to enter or exit the standby mode. 2. Card Slot Insert the SD card into the slot. 3. Earphone Jack Used to connect earphones for private listening. When the earphones are connected to this jack, the speaker will be turned off automatically. 4. DC 5V Input Jack Used to connect to the supplied adaptor. 5. LCD Screen 6. USB Port Used to connect to the USB device. 7. RESET Button Press to res
ページ9に含まれる内容の要旨
System Connections Always ensure that the unit and any other external device connected to the unit are switched off and unplugged from the power supply before you attempt to connect the unit to any external device. Connecting to PC The unit is designed with a USB port which allows you to connect the unit to a PC for map updating. See the figure below for details: System requirements: -Windows 98SE, ME, 2000, and XP (Driver required for Windows 98S
ページ10に含まれる内容の要旨
System Connections Inserting SD Card The unit is designed with SD Card jack which allows you to insert the SD card into the unit as shown below: To remove the card, gently press the card in with your fingernail. The card unlocks and protrudes slightly. Then remove the card. Connecting to Earphones Connect the earphones to the right side of the unit for private listening. When earphone is connected, the speakers will automatically turn
ページ11に含まれる内容の要旨
Power Supply Preparation Using the Car Adaptor The unit is supplied with a Car Adaptor for powering it while in a vehicle. Connect the Car Adaptor Power Plug to the unit’s power jack and plug the other end to the vehicle’s 5V accessory/ cigarette socket, as shown on the right figure. Attention Place the unit in a proper position for viewing. Disconnect the unit from the Car Adaptor when starting the vehicle. Your portable GPS unit comes with a built-in
ページ12に含まれる内容の要旨
General Setup System Main Menu When in navigation mode, tap MENU button, and then choose SETTINGS. In the SETTINGS menu, tap EXIT, a confirmation message appears. Tap Exit in the confirmation message to return to the system main menu, as shown below. In the main menu, there are four items for selecting. Touch the corresponding item to enter. Tap to enter navigation mode; tap to enter the MP3 player; tap to enter the Photo View
ページ13に含まれる内容の要旨
General Setup Language Tap in the setting menu to enter Language setting menu for language selecting, as shown below: Tap the buttons to select language. Then tap to confirm or tap to cancel. Backlight Tap in the settings menu to enter Backlight setting menu for backlight adjusting, as shown below: Tap the buttons to adjust the backlight level. After setting, tap to confirm or tap to cancel. 12
ページ14に含まれる内容の要旨
General Setup Date & Time Tap in the settings menu to enter Date & Time setting menu for changing to the current time zone, as shown below: Tap the buttons to select the proper Time Zone. Tap the buttons of Date group to change the corresponding date and tap the buttons of Time group to change the corresponding time. Tap to return. Power Tap in the settings menu to enter Power menu for the current battery status, as shown below: The pow
ページ15に含まれる内容の要旨
General Setup Calibrate Tap in the settings menu to calibrate, the screen will display as below: This item is used to calibrate the sensitivity of the touch screen. Tap the center of “+” as it moves around the screen. If you touch the center of “+” every time, it will disappear after having moved through a cycle (center→top left→bottom left→bottom right→top right). Tap the screen to return to the settings menu. Note: If “+” doesn’t disappear, you should calibr
ページ16に含まれる内容の要旨
Playing Music The unit is designed with SD card slot and supports MP3 and WMA format files playback. To use the MP3 player, you will need to have an SD card with your MP3 music files preloaded. Please note you cannot use the navigation function of the device at the same time as using the MP3 player. Remove the mapping software SD card that comes with the device from the SD card slot on the side of the unit. Then insert your SD card with your MP3 or WMA music files. Note: Ple
ページ17に含まれる内容の要旨
Playing Music In the screen, tap the MENU button to enter the MP3 play list menu, as shown below: When you open the play list, the system will look for audio files on its SD memory card and create a play list automatically. If the play list consists of more than one screen, tap the up arrow for the previous page and the down arrow for the next page. In the play list, double tap the songs to start playback. Tap ; when the button changes to orange, the pla
ページ18に含まれる内容の要旨
Photo Viewer The unit is designed with SD card slot and supports JPEG format files playback. To use the Photo Viewer, you will need to have an SD card with your JPEG picture files preloaded. Please note you cannot use the navigation function of the device at the same time as using the Photo Viewer. Remove the mapping software SD card that comes with the device from the SD card slot on the side of the unit. Then insert your SD card with your JPEG picture files. Note: Please t
ページ19に含まれる内容の要旨
Photo Viewer In the folder menu, double tap the memory card icon to open it, the pictures stored in the memory card will be listed on the screen. If the pictures list consists of more than one screen, tap the up arrow for the previous page and the down arrow for the next page. Tap to return to previous menu. Tap a picture to select it and tap to confirm your selection. In the pictures list, double tap a picture to play it on screen, as shown below.
ページ20に含まれる内容の要旨
Use of the Mount Accessories When using the unit in vehicle, you can use the supplied mount accessories (mount bracket, mount cradle and dashboard mount disk) to mount the unit in the vehicle. Take the following steps to operate: Fig. 1 Fig. 2 Fig. 3 1. See Fig. 1. According to the arrow to slide the mount cradle to fix it to the mount bracket. 2. See Fig. 2. First, set the bottom edge of the unit onto the mount cradle. Then press the two buttons in arrow ① direction
