ページ1に含まれる内容の要旨
Life Fitness Model TR9700, TR9500, TR9100 Treadmills
How To...Replace or Install Rear Roller Guards
Tools Required: Philips Screwdriver
NOTE: The following steps are applicable to units with Configuration No. 1, Rear Roller Guards.
1. Remove the Screws securing the Rear Roller Guard Assembly to the Frame.
Screw
Cover Guard
Grommet
Roller Guard, RT
Roller Guard, LT
Grommet
Screw
Configuration No. 1
2. Remove the old Grommets from the Rear Roller Welded Guard Tab and Base Frame (model
specific).
ページ2に含まれる内容の要旨
Life Fitness Model TR9700, TR9500, TR9100 Treadmills How To...Replace or Install Rear Roller Guards 5. Install Screws and fasten securely. Approx. 22-37 in/lbs. Secure Mounting Screws 6. Repeat steps for opposite side. After completion run treadmill and check for interference or binding. If needed loosen Mounting Screws, re-align Guard, and refasten securely.
ページ3に含まれる内容の要旨
Life Fitness Model 97Ti, 95Ti, 93T Treadmills How To...Replace or Install Rear Roller Guards Tools Required: Philips Screwdriver, Flat Blade Screwdriver NOTE: The following steps are applicable to units with Configuration No. 2, Rear Roller Guards. 1. Remove existing Roller Guard by unscrewing mounting screws on top and base of frame. Mounting Screws 2. With flat blade screwdriver, remove Grommet and Washer, discard old washer and re-install the grommet. Use caution to prevent injury or damage
ページ4に含まれる内容の要旨
Life Fitness Model 97Ti, 95Ti, 93T Treadmills How To...Replace or Install Rear Roller Guards (Continued) 4. Place new Roller Guard in position shown with top surface under walking belt. Align mounting holes. Roller Guard to be Align mounting holes located between belt with grommet holes and deck 5. Install Screws and fasten securely. Approx. 22-37 in/lbs. 6. Repeat steps for opposite side. After completion run treadmill and check for interference or binding. If needed loosen Mounting Screws, re-
