Extron electronic sVM 700Tの取扱説明書

ページ1に含まれる内容の要旨

VM 700T Mounting Kit Installation Guide
Overview
®
75mm The Extron VM 700T is
2.95”
an adapter that provides a
VESA‑mounting option for the
™
TLP 700TV TouchLink panel.
Four holes, one in each corner
allow the adapter to fit any third‑party VESA Type D 75 mm mounting kit.
75mm
This guide provides basic instructions for an experienced installer to mount and
2.95”
perform initial configuration on the TLP 700TV.



Using the VM 700T mounting kit
The TLP 700TV comes assembled with a stand

ページ2に含まれる内容の要旨

VM 700T Mounting Kit Installation Guide, Continued 7. Remove the back cover to reveal the metal stand and the cables connecting the circuit board in the base to the touch panel screen. 7 Remove back cover. 8. Cut the plastic tie holding the cables to the metal stand. 9. Disconnect the power, LAN, audio, LED, and two Remove Snake-skin Cover BNC cables from the circuit board in the base. 10 10. Remove the snakeskin cover pr ‑ otecting the Remove (cut) Plastic Tie 8 cables. Remove a

ページ3に含まれる内容の要旨

V 13. Remove and save the three Phillips head screws holding the plastic molding to the back of the screen. 13 Remove (3) Screws 14. Disconnect the audio, LED, and power cables from the back panel of the screen. • The audio cables are the black and white pair, wound around a ferrite core. • The power cables are the red and black pair, terminated with a blue, 2‑pole captive screw connector. • The LED cables are the black and white pair, without a ferrite core. None of the cables that are

ページ4に含まれる内容の要旨

VM 700T Mounting Kit Installation Guide, Continued 18. Hold the remaining cables towards the bottom of the recess in the plastic moulding. 19. Holding the VM 700T mounting plate at a slight angle, slide the center bar under the cables and into the recess, so 19 that it sits firmly at the bottom of the recess. 18 20. Secure the bracket to the screen, using the two screws saved from step 11. 21. Attach the mounting plate to the bracket that was wall‑mounted in step