ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
Welcome & Congratulations Congratulations on your purchase of a new gas grill! At Electrolux Home Products, we are very proud of our product and are completely committed to providing you with the best service possible. Your satisfaction is our number one priority. We know you’ll enjoy your new gas grill and Thank You for choosing our product. We hope you consider us for future purchases. PLEASE CAREFULLY READ AND SAVE THESE INSTRUCTIONS This Use & Care Manual provides specific operating instr
ページ3に含まれる内容の要旨
General Safety Instructions IMPORTANT SAFETY INFORMATION - Read this manual carefully before using your grill to reduce the risk of fire, burn hazard or other injury. - Extreme care should be used because of the high temperatures produced by this appliance. CHILDREN SHOULD NOT BE LEFT UNATTENDED IN AN AREA WHERE THE GRILL IS BEING OPERATED. - This appliance must be kept clear from combustible materials, gasoline or other flammable vapors and liquids. Do not allow flammable materials to come
ページ4に含まれる内容の要旨
Grill Features: FD26 6 1 7 2 3 8 4 9 5 1. Roll top grill hood 6. Handle 2. Grilling/Cooking surface 7. Warming shelf 3. Electronic ignitor: main burners 8. Side shelf 4. Control knobs: main burners 9. Pedestal base 5. Convection vents 3
ページ5に含まれる内容の要旨
Grill Components List Cart Parts Part #’s 13 sided pedestal base WIP-192-326071 1 Base WIP-191-326070 2 Wheel channels WIP-192-326365 Grill Parts Grill Parts 1 Stainless steel grill head WIP-122-HDFA26 2 Stainless steel side shelves WIP-192-326393 1 Electronic ignitor RMP-122-00648 1 Flavor grid WIP-192-326313 2 Porcelain bar grates RMP-122-00688 1 Stainless steel warming rack WIP-192-326009 1 Drip pan RMP-122-00005 1 Hose and regulator (LP models only) RMP-122-00820 1 Black plastic plug for r
ページ6に含まれる内容の要旨
Grill Assembly Note: Prior to assembly remove protective film from stainless steel parts Assembly requires: 6 tools and a Friend Tools required: Power screwdriver Screw Holes Screwdriver extension 1/4” socket wrench Wheel Channel 1/2” socket wrench holes adjustable wrench scissors Fig. 1 Screw Holes Caution: Gas regulator is not flush with bottom. Key hole DO NOT let the Grill head sit flat without placing slots support around regulator to prevent damage to the regulator prior to installing on
ページ7に含まれる内容の要旨
Grill Assembly Ignitor Attachment Battery Mounting 1. Remove the ignitor cap, spring assembly, Bracket battery and lock nut from ignitor. (See Fig. 5) 2. Insert the threaded section of the ignitor into Fig. 5 Cap the U-shaped cut out of the ignitor mounting Spring bracket. (See Fig. 6) Locking Assembly Cylinder Nut 3. Insert the threaded section of the ignitor through the hole in either shelf and secure to shelf using the lock nut. Tighten Securely. (See Fig. 7) 4. Re-insert the battery,
ページ8に含まれる内容の要旨
Grill Assembly Interior parts installation 1. Insert the Flavor Grid into the bottom of the grill with the ridges facing up by angling it down and in. Be sure the middle Fig. 12 sections solid area is covering the front ignitor. (See Fig. 12) Solid area 2. Install cooking grates on the ledges provided over ignitor on the grill to create your cooking surface. (See Fig. 13) 3. Place warming shelf on support brackets by setting it flat across brackets allowing the two holes to line up wi
ページ9に含まれる内容の要旨
Built-In Instructions The Frigidaire Grill can be installed as a built-in Grill. If installed as a built-in Grill, the Grill surround must be constructed of Non-combustible material. Planning and Design Start by identifying the number and size of components you want to include: Grill, side burner, access doors for storage or other items you may wish to furnish such as: refrigerator, sink, warming drawer. Countertops must be constructed with non-combustible, outdoor-safe materials. Consider
ページ10に含まれる内容の要旨
Built-In Instructions Side cutout is needed on left side to feed ignitor wire Note: Make sure to use a to the ignitor plate (26” model only) non-combustible base and sides for the structure (Size: 10” high x 5” long, set 1” back from front edge) 1 27 /2” Min. GFI Electrical outlet for rotisserie motor A (6.5 amp min.) *Gas Cutout C Floor Support B 2” area for grill 1 35 /2” Max. Opening for IGNITOR PLATE access door(s) INSTALLATION D *Required Ignitor cutout counter top for front or side mou
ページ11に含まれる内容の要旨
Gas Requirements General Information Verify the type of gas supply to be used, either Natural Gas (NG) or Liquid Propane (L.P)., and make sure the marking plate (located on the back of the unit) agrees with that of the supply. Note: Never attach an unregulated gas line to the appliance. For Natural Gas installations, an installer must supply a gas shutoff valve that is easily accessible to the grill. All installer supplied parts must conform to local codes, or in the absence of local codes, wi
ページ12に含まれる内容の要旨
Gas Requirements L.P. Gas Installation Frigidaire Gas Grills that are set to operate with L.P. gas come with a high capacity hose and regulator assembly. (Note: Only use the pressure regulator and hose assembly supplied with the grill or a replacement pressure regulator and hose assemblies specified by Frigidaire). This assembly is designed to connect directly to a standard 20 lb. L.P. cylinder. Attach the gas hose assembly to the brass 3/8 flared fitting on the under side of the grill. Tig
ページ13に含まれる内容の要旨
Leak Testing General Information Although all gas connections on the grill are leaked tested at the factory prior to shipment, a complete gas tightness check must be performed at the installation site due to possible mishandling in shipment, or excessive pressure unknowingly being applied to the unit. Periodically check the whole system for leaks, or immediately check if the smell of gas is detected. Before Testing Do Not smoke while leak testing. Extinguish all open flames. Never leak test
ページ14に含まれる内容の要旨
Using the Grill Grill Location Do not use the grill in garages, breezeway, sheds or any enclosed area. Never operate the grill in enclosed areas as this could lead to a carbon monoxide buildup, which could result in injury or death. Place the grill on a level surface. Avoid moving the grill while it is operation. Note: The grill will operate best if it is not facing directly into the wind. Clearance to combustible construction - A minimum of 12” from the sides and back must be maintained fr
ページ15に含まれる内容の要旨
Lighting the Grill Before Lighting Warning: Important! Before Lighting... Check the gas supply line for cuts, wear or abrasion. Do not attempt to Always keep your face and body as far away from the “Light” the grill if the grill as possible when lighting. odor of gas is present!! Grill Burner Lighting Lighting the Grill with electronic ignitor Always open the lid before attempting lighting. Push and turn one of the control knobs counter clock- wise to the “HIGH” position and immediately pre
ページ16に含まれる内容の要旨
Care and Maintenance General Maintenance (performed on a periodic basis, depending on usage) Check to make sure ventilation openings on the LP cylinder enclosure are not obstructed Check to make sure the flow of combustion and ventilation air is not obstructed. Check for proper burner flame Drip Tray The drip tray located below the grill, inside the cart, should be cleaned periodically to prevent heavy buildup of debris. Note: Allow the drip tray to cool before attempting to clean. Cooking Gra
ページ17に含まれる内容の要旨
Trouble Shooting General Trouble Shooting You should inspect the burners at least once a year or immediately if any of the following conditions occur: The smell of gas in conjunction with the burner flames appearing yellow. The Grill does not reach temperature. The burners make a popping noise. The Grill heats unevenly. Before calling customer service If the Grill does not function properly, use the following checklist. Solution Problem After opening tank valve, be sure one of the Grill contro
ページ18に含まれる内容の要旨
Trouble Shooting Problem Solution Check gas connection. Flame is erratic Fuel level may be low. Grill may be in need of cleaning. Check flavor grids and cooking grates for excess build-up. Flare-Ups Ensure Grill is not placed directly in path of wind. Be sure the drip tray is clean. (do not use aluminum foil in drip tray) Check the burner inlet for obstructions. Burner flame is yellow or orange, in conjunction with the odor of gas. Grill may be in a windy area. Move to a less windy area
ページ19に含まれる内容の要旨
Warranty LIMITED LIFETIME WARRANTY Frigidaire Grills have a Lifetime Warranty on all stainless steel parts, 15 years on stainless burners and a 5 year warranty on all other parts. IMPORTANT: We recommend you return the warranty registration card so that you can be contacted with any questions of safety arise that could affect you. The return of the warranty registration card is not a condition for warranty coverage. LIMITED WARRANTY If the Frigidaire Grill does not operate properly, first th
