ページ1に含まれる内容の要旨
®
Gas Go Anywhere
55014 02/23/01
ページ2に含まれる内容の要旨
FOR OUTDOOR USE ONLY This grill does not include an LP fuel tank. Check Package Contents You should have received the parts listed below. While we give much attention to out product, unfortunately an occasional error may occur. If a part is missing, do not go back to the store. Call Weber- Stephen Products Customer Service Center toll free 1-800-446-1071 to receive immediate assistance. 1 - Bottom unit assembly 1 - Lid assembly 1 - Cooking grate 1 - Flavorizer Bar 1 - Burner tube 1 - Regulator
ページ3に含まれる内容の要旨
1 - Leg Lock 1 - 1/4-20 wing nut 1 - 5/16” Washer 1 - 1/4-20 x 1/2 bolt 2 - 10-24 screws 2 - 10-24 wing nuts 6 - 1/4” Flat washers 1 - Igniter 3
ページ4に含まれる内容の要旨
Install Legs Place washers on leg ends and insert ends into holes in bottom unit. Be careful not to scratch the porcelain finish while installing the legs. Repeat with other leg. Install Leg Lock Position curved end of leg lock at corner of the straight portion of the leg, as shown. Push until it snaps on. 1 2 3 Position legs and secure leg lock Swing legs around so that the rounded part sets on the ground and the bottom of the cooking box rests on the straight part of the legs. To lock the legs
ページ5に含まれる内容の要旨
Install Burner Tube From the inside, insert burner tube through the large hole in the side of the bottom unit. Line up the other end of the tube with the hole. Insert the 1/2 inch bolt. Add the washer and wing nut. Tighten. Install Regulator Remove the retaining clip from the regulator. Attach regulator assembly by inserting the brass fitting into the end of the burner tube.. Secure regulator assembly by installing the retaining clip in the square openings on both sides of the burner tube. 5
ページ6に含まれる内容の要旨
Install Igniter Insert the igniter electrode and two 10-24 screws through the igniter bracket and the holes in the bottom unit on the side opposite the regulator. Add washers and wing nuts, making sure that the wing nuts are secured in a vertical position. The igniter electrode has been pre-bent. It may need to be adjusted so the tip is approximately 1/8 inch from the holes in the burner tube. DANGER Make sure the tip of the igniter wire is adjusted to the holes in the burner tube. If it is not
ページ7に含まれる内容の要旨
Install Flavorizer Bar Place the Flavorizer Bar in bottom unit, covering the burner. Install Cooking Grate Set the cooking grate onto the recessed edge of the bottom unit. To Secure for Transport Put the lid on the bottom unit unlock legs and pivot them into the locked position up over the projections on the lid. 7
ページ8に含まれる内容の要旨
® ® ® ® To Use Pivot legs under grill and lock legs. The hooks on the inside of the lid allow it to rest on the edge of the bottom unit. Read important DANGERS, WARNINGS and CAUTIONS in Owner’s Guide before operating this barbecue. Connecting the Cylinder 1. Lubricate the threads of the regulator assembly with petroleum jelly. 2. Make sure the burner control valve is in the LOCK/OFF position before attaching the propane cylinder. Valve closes by turning the knob clock- wise to the LOCK/OFF posit
ページ9に含まれる内容の要旨
Check for Gas Leaks DANGER Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. This will result in a fire or explosion which can cause serious bod- ily injury or death, and damage to property. 1. Check the connection between the tank and the regulator for gas leaks. Mix a couple of tablespoons of liquid detergent with an equal amount of water. 2. Be sure to leave the burner control valve in the LOCK/OFF position. Wet
ページ10に含まれる内容の要旨
Manual Lighting 1. Light a match and hold it in one of the four holes in the bottom of the grill. 2. Push down burner control valve and turn counter-clockwise to HIGH. 3. Check to see if the burner is lit by looking through the viewing hole in the Flavorizer Bar. WARNING: If burner does not light, turn burner control valve OFF, wait 5 minutes for the gas to clear, then try again. Gas Grill Care While lid is warm, wipe inside with paper towels to prevent grease build-up. After cooking, burn gre
ページ11に含まれる内容の要旨
1 2 3 8 9 10 11 12 13 4 14 15 5 16 17 18 19 6 7 1-3. Handle 12. 5/16” Flat Washer 4. 10-24 Wing Nuts 13. 1/4-20 Wing Nut 5. Retaining Clip 14. Machine Screw 6. Regulator Assembly 15. Burner Tube 7. Leg Lock 16. Igniter 8. Lid 17. Legs 9. Cooking Grate 18. Flat Washer 10. Flavorizer Bar 19. Bottom unit 11. Bolt 11
ページ12に含まれる内容の要旨
® © 1999 Weber-Stephen Products Co., Weber, the silhouette, and the kettle configuration are registered trademarks of Weber- Stephen Products Co., 200 East Daniels Road, Palatine, IL, 60067-6266, U.S.A. This product is covered by one or more United States patents and patents in other nations globally. Printed in the U.S.A.
