ページ1に含まれる内容の要旨
N
461644604
USE & CARE MANUAL
THIS GRILL IS FOR
OUTDOOR USE ONLY
CAUTION: Read and follow all safety
statements, assembly instructions, and use
and care directions before attempting to
assemble and cook.
INSTALLER/ASSEMBLER: Leave these
instructions with consumer.
CONSUMER: Keep this manual for future
reference.
WARNING
Read this manual before cooking on grill. Failure to follow all manufacturer’s
instructions could result in fire or explosion which could cause property damage,
personal injury o
ページ2に含まれる内容の要旨
Installation Safety Precautions WARNING • Use grill only with LP (propane) gas and the regulator/valve assembly supplied. FOR YOUR SAFETY Grill installation must conform with local codes, or in their 1. Do not store or use gasoline or other absence with National Fuel Gas Code, NFPA 54 / ANSI flammable vapors and liquids in the Z223.1 or CAN/CGA-B149.2 Propane Installation Code. vicinity of this or any other appliance. Handling and storage of LP cylinders must conform to LP Gas 2. An LP tank no
ページ3に含まれる内容の要旨
WARRANTY Manufacturer warrants to the original consumer-purchaser that this product shall be free from defects in workmanship and materials under normal and reasonable use and correct assembly (if assembled by consumer-purchaser), for a period of one (1) year from date of purchase. Manufacturer will, at its option, replace any product or part found to be defective during the warranty period. Manufacturer will require you to return the part(s) claimed to be defective, for its inspection, freight
ページ4に含まれる内容の要旨
LP Tank USE AND CARE The LP tank used with your grill must meet the following requirements: DANGER Use LP tanks only with these required measurements: 12" (30.5cm) (diameter) x 18" (45.7 cm) (tall) with 20 lb. (9 kg.) capacity maximum. Never fill the cylinder beyond 80% full. An overfilled spare LP tank is hazardous due to possible gas LP tanks must be constructed and marked in accordance with released from the safety relief valve. specifications for LP tank of the U.S. Department of Tra
ページ5に含まれる内容の要旨
e s i w k LP Tank Exchange Connecting Regulator To The LP Tank Many retailers that sell grills offer you the option of replacing 1. LP tank must be properly secured onto grill. (Refer to your empty LP tank through an exchange service. Use only assembly section.) those reputable exchange companies that inspect, precision fill, 2. Turn all control knobs, including sideburner, to the OFF test and certify their cylinders. Exchange your tank only for position. an OPD safety feature-equipped tank as
ページ6に含まれる内容の要旨
Straight Hold coupling nut and regulator as shown for proper connection to LP tank valve. 6. Turn the coupling nut clockwise and tighten to a full stop. The regulator will seal on the back-check feature in the LP tank valve, resulting in some resistance. An additional one-half to three-quarters turn is required to complete the connection. Tighten by hand only – do not use tools. NOTE: If you cannot complete the connection, disconnect regulator and repeat steps 5 and 6. If you are still unable to
ページ7に含まれる内容の要旨
Safety Tips WARNING Before opening LP tank valve, check the coupling nut for tightness. For Safe Use Of Your Grill And To Avoid Serious When grill is not in use, turn off all control knobs and LP tank Injury: valve. Do not let children operate or play near grill. Never move grill while in operation or still hot. Keep grill area clear and free from materials that burn. Use long-handled barbecue utensils and oven mitts to avoid Do not block holes in bottom or back of grill. burns and
ページ8に含まれる内容の要旨
Burner Flame Check Remove cooking grate and VapoRISER Bar. Light burner, CAUTION rotate knobs from (High) to (Low). You should see a smaller flame in Low position than seen on High. Always check If burner does not light, turn knobs to OFF , wait 5 flame prior to each use. Perform flame check on sideburner. If minutes, and try again. If the burner does not ignite with only low flame is seen refer to "Sudden drop or low flame" in the valve open, gas will continue to flow out of the burner the Tr
ページ9に含まれる内容の要旨
Cleaning The Burner Assembly CAUTION Follow these instructions to clean and/or replace parts of burner assembly or if you have trouble igniting grill. NATURAL HAZARD • SPIDERS 1. Turn gas off at control knobs and LP tank. 2. Remove cooking grate, VapoRISER Bar, and grease cup. FACT: Sometimes spiders and other small insects climb into 3. Disconnect ignitor wire from burner electrode and remove the burner tubes attached to the burners. The spiders spin webs, build nests and lay eggs. The webs or
ページ10に含まれる内容の要旨
Food Safety How To Tell If Meat Is Grilled Thoroughly Food safety is a very important part of enjoying the outdoor Meat and poultry cooked on a grill often browns very fast on the cooking experience. To keep food safe from harmful bacteria, outside. Use a meat thermometer to be sure food has reached follow these four basic steps: a safe internal temperature, and cut into food to check for visual signs of doneness. Clean: Wash hands, utensils, and surfaces with hot soapy water before and after
ページ11に含まれる内容の要旨
Troubleshooting Problem Possible Cause Prevention/Solution Burner(s) will not light Wire and/or electrode covered with Clean wire and/or electrode with rubbing alcohol and clean swab. using ignitor. cooking residue. Electrode and burner are wet. Wipe dry with cloth. Electrode cracked or broken "sparks at Replace electrode. crack”. Wire is loose or disconnected. Reconnect wire. Wires are shorting (sparking) between Replace ignitor wire/electrode assembly. ignitor and electrode
ページ12に含まれる内容の要旨
A Division of W.C. Bradley Co. Columbus, GA 31902
