ページ1に含まれる内容の要旨
FREESTANDING OUTDOOR GRILLS
Installation Instructions and Use & Care Guide
For questions about features, operation/performance, parts, accessories or service, call: 1-800-422-1230
or visit our website at www.kitchenaid.com
In Canada, for assistance, installation and service, call: 1-800-807-6777
or visit our website at www.KitchenAid.ca
GRILS D'EXTÉRIEUR AUTOPORTANTS
Instructions d’installation et Guide d’utilisation et d’entretien
Au Canada, pour assistance, installation ou service composez le
ページ2に含まれる内容の要旨
OUTDOOR GRILL SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.” These words mean: You can be killed or seriously injured if you don't immediate
ページ3に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of fire, electrical shock, ■ The LP gas supply cylinder to be used must be: injury to persons, or damage when using the outdoor cooking - constructed and marked in accordance with the gas appliance, follow basic precautions, including the Specification for LP Gas Cylinders of the U.S. Department following: of Transportation (DOT) or the National Standard of ■ Do not install portable or built-in outdoor cooking gas Canada, CAN/CSA-
ページ4に含まれる内容の要旨
TABLE OF CONTENTS TABLE DES MATIÈRES OUTDOOR GRILL SAFETY............................................................2 SÉCURITÉ DU GRIL D'EXTÉRIEUR ...........................................41 INSTALLATION REQUIREMENTS ................................................5 EXIGENCES D'INSTALLATION...................................................43 Tools and Parts ............................................................................5 Outillage et pièces.......................................
ページ5に含まれる内容の要旨
INSTALLATION REQUIREMENTS T ools and Parts Location Requirements Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed WARNING here. Tools Needed ■ Tape measure ■ Wrench or pliers ■ Small, flat-blade screwdriver ■ Pipe wrench ■ Flat-blade screwdriver ■ Scissors or cutting pliers (to remove tiedowns) Explosion Hazard ■ #2 and #3 Phillips screwdriver ■ Noncorrosive leak- Do not store fuel tank in a garage or indoors.
ページ6に含まれる内容の要旨
■ To avoid electrical shock, do not immerse cord or plugs in water or other liquid. Product Dimensions ■ Unplug from the outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts. A ■ Do not operate any outdoor cooking gas appliance with a damaged cord, damaged plug, or after the appliance 17¼" 17¼" (43.8 cm) C (43.8 cm) malfunctions or has been damaged in any manner. Contact B the manufacturer for repair. ■ Do not let the cord hang over the edge of a
ページ7に含まれる内容の要旨
Burner Requirements for High Altitude Gas Supply Requirements Input ratings shown on the model/serial rating plate are for elevations up to 2,000 ft (609.6 m). WARNING For elevations above 2,000 ft (609.6 m), ratings are reduced at a rate of 4% for each 1,000 ft (304.8 m) above sea level. Orifice conversion is required. See “Assistance or Service” section to order. Gas Supply Line Pressure Testing Explosion Hazard Testing above ½ psi (3.5 kPa) or 14" (35.5 cm) WCP (gauge): Use a new CSA Inte
ページ8に含まれる内容の要旨
Door Style Tank Tray Follow instructions for converting to local LP gas in the “Gas Conversions” section. 1. Open cabinet doors. 2. Press the locking tab on the tank tray and pull out the tray. A A A. 20 lb LP gas fuel tank tray locking tab B 3. Place the 20 lb LP gas fuel tank bottom collar into the mounting hole in the tank tray. C 4. Tighten the locking screw against the bottom collar of the 20 lb LP gas fuel tank to secure. A. New ANSI Z21.54 certified gray hose B. Rear of grill C. To loc
ページ9に含まれる内容の要旨
Natural Gas Conversion INSTALLATION Conversion must be made by a qualified gas technician. The qualified Natural gas technician shall provide the Natural gas INSTRUCTIONS supply to the selected grill location in accordance with the National Fuel Gas Code ANSI Z223.1/NFPA 54 - latest edition, and local codes. For conversion to Natural gas, the Natural Gas Freestanding Outdoor Grill Installation Conversion Kit supplied with the grill (on some models) or the Natural Gas Conversion Kit Part N
ページ10に含まれる内容の要旨
Attach Side Shelf (on some models) Attach Condiment Shelf (on some models) 1. Open doors below grill and remove carton. Unpack side 1. Open cabinet door. shelf. 2. Use a short Phillips screwdriver or a 90° screwdriver with a 2. Locate 4 screws. Install 2 screws in the top 2 holes on each Phillips screw bit to loosen the 2 mounting screws on the side of the grill. Leave screws away from side of grill about inner door panel. ¼" (0.64 cm). A 3. Install side shelf on left side of the grill. Positi
ページ11に含まれる内容の要旨
Make Gas Connection - To a 20 lb LP Gas Fuel Tank 4. Screw the gas pressure regulator/hose assembly to the 20 lb LP gas fuel tank as shown. (To disconnect, turn off the gas WARNING supply to the 20 lb LP gas fuel tank, then unscrew the gas pressure regulator/hose assembly from the 20 lb LP gas fuel tank as shown.) connect Explosion Hazard Securely tighten all gas connections. B disconnect If connected to LP, have a qualified person make sure gas pressure does not exceed 11” (28 cm) water c
ページ12に含まれる内容の要旨
4. Tighten the locking screw against the bottom collar of the Gas Connection to Natural Gas or Local LP Gas 20 lb LP gas fuel tank to secure. WARNING A Explosion Hazard B C Use a new CSA International approved “outdoor” A. Locking screw gas supply line. B. Mounting hole C. Bottom collar Securely tighten all gas connections. 5. Screw the gas pressure regulator/hose assembly to the 20 lb If connected to LP, have a qualified person make sure LP gas fuel tank as shown. (To disconnect, turn off th
ページ13に含まれる内容の要旨
■ Pipe-joint compounds suitable for use with LP gas must ®† be used. Do not use TEFLON tape. Plug in Grill A WARNING B Electrical Shock Hazard C Use only a UL listed, 14 gauge, 3 wire extension cord approved for outdoor use, marked W-A, with a maximum length of 50 ft. D Plug into a grounded 3 prong outlet. A. New ANSI Z21.54 certified gray hose Do not remove ground prong. B. Rear of grill Do not use an adapter. C. To Natural gas supply Failure to follow these instructions can result in death,
ページ14に含まれる内容の要旨
■ Do not let the cord hang over the edge of a table or touch NOTE: Check the circuit breaker on the back of the grill after hot surfaces. plugging the grill into a 3-prong polarized type outdoor GFI outlet if there is a loss of electrical power to the grill. Reset ■ Do not use an outdoor cooking appliance for purposes the circuit breaker if the button is in the tripped position. Push other than intended. in the rubber boot and button to reset. ■ When connecting, first connect plug to the ou
ページ15に含まれる内容の要旨
Conversion to a Local LP Gas Supply 9. Use pipe wrench to install the convertible regulator. Brass Installation of the regulator cap will be facing up when tight. 1. Turn off the main gas supply valve. 2. Unplug grill or disconnect power. A B 3. Disconnect 20 lb LP gas fuel tank (if present). 4. Turn off all burner control valves. 5. Remove rear cover and 2 screws. A. Brass connector B. Convertible regulator 10. To set the appliance regulator for LP gas, use adjustable wrench to remove the bra
ページ16に含まれる内容の要旨
Conversion from LP Gas to Natural Gas 9. Use pipe wrench to install the convertible regulator. Brass Installation of the regulator cap will be facing up when tight. 1. Turn off the main gas supply valve. 2. Unplug grill or disconnect power. A B 3. Disconnect 20 lb LP gas fuel tank (if present). 4. Turn off all burner control valves. 5. Remove rear cover and 2 screws. A. Brass elbow B. Convertible regulator 10. To make sure the regulator is set for Natural gas, use adjustable wrench to remove b
ページ17に含まれる内容の要旨
3. Use 6 mm socket and wrench or 6 mm nut driver to remove Change the Rotisserie-infrared burner orifice(s) the brass orifices from the end of the gas valves. 1. Remove the access cover and screw at the back of the grill hood with a Phillips screwdriver. A 2. Use Phillips screwdriver to remove 2 screws holding the A. Grill burner orifice spider guard to the burner. 4. Install new 2.34 mm orifices supplied with this kit to the end of the gas valve. Use 6 mm socket and wrench or 6 mm nut driv
ページ18に含まれる内容の要旨
4. Use 10 mm socket and wrench or 10 mm nut driver to install 4. Remove the sear burner mounting screws. the new 2.1 mm orifices supplied with this kit. A NOTE: The number 2.1 is stamped on the orifice for identification. 5. Repeat the procedure for the other burner. 6. Replace the burner top and caps. Align the notches in the bottom of the burner top with the tabs on the burner base and twist until the burner top is seated on the burner base. A. Sear burner mounting screws You will feel it
ページ19に含まれる内容の要旨
Check and Adjust the Burners The burners are tested and factory-set for most efficient 5. Remove the 2 screws that hold the burner in place. Remove operation. However, variations in gas supply and other conditions gas burner from the grill. may make minor adjustments to air shutter or low flame setting necessary. It is recommended that a qualified person make burner adjustments. NOTE: The rotisserie burner cannot be adjusted. Checking and adjusting the grill burner flames requires removing
ページ20に含まれる内容の要旨
OUTDOOR GRILL USE This manual covers several different models. The grill you have purchased may have some or all of the features listed. The locations and appearances of the features shown here may not match those of your model. Control Panel E A B C D F G H I A. Left rotisserie burner control knob D. Right grill burner control knob G. Right rotisserie burner control knob B. Left grill burner control knob E. Electronic grill display (on some models) H. Front side burner control knob Light switc
