ページ1に含まれる内容の要旨
G18Y07P-02
ページ2に含まれる内容の要旨
TABLE OF CONTENTS SECTION ONE SECTION FIVE Safety Instructions………………………………… 1-5 Exploded View…………………………………. 24 Placement of the Grill ……………………………. 5 Parts List………………………………………… 25-26 SECTION TWO SECTION SIX Side Shelf & Side Burner Assembly……………. 6 Grilling Hints……………………………………. 27 Side Shelf Handle Ass
ページ3に含まれる内容の要旨
SAFETY INSTRUCTIONS RECOGNIZED SAFETY SYMBOLS, WORDS AND LABELS WARNING WARNING Do not try lighting this appliance without first reading the “LIGHTING INSTRUCTIONS” section of this manual. WARNING – Hazards or unsafe practices which COULD result in severe personal injury or death. WARNING Spiders and insects can nest inside the burners of CAUTION the grill and disrupt gas flow. This very dangerous condition could cause a fire behind the valve panel
ページ4に含まれる内容の要旨
SAFETY INSTRUCTIONS WARNING WARNING Do not use the grill if the odor of gas is Failure to properly place the burner over the present. Contact customer service at 1-800- orifice could cause a fire to occur behind and 554-5799. beneath the valve panel, thereby damaging the grill and making it unsafe to operate. WARNING When lighting, keep your face and hands as far WARNING away from the grill as possible. Do not leave the grill unattended while cooking. WARNING
ページ5に含まれる内容の要旨
SAFETY INSTRUCTIONS USING THE SIDE BURNER WARNING Inspect the gas supply hose prior to turning on Do not attempt to light the grill if gas odor is the gas. If there is evidence of cuts, wear or present. Contact customer service at 1-800-554- abrasion, it must be replaced prior to use. Do not 5799. use the side burner if gas odor is present. When lighting, keep your face and body as far Keep a spray bottle of soapy water near the grill away from the burner as possible. and chec
ページ6に含まれる内容の要旨
SAFETY INSTRUCTIONS The grill is for outdoor use only. WARNING Do not try lighting this appliance without first reading The grill is not intended to be installed in or on the “LIGHTING INSTRUCTIONS” section of this recreational vehicles and/or boats. manual. Children should not be left alone or unattended in an area where the grill is being used. Do not allow TESTED IN ACCORDANCE WITH ANSI Z21.58 - children to sit, stand or play on or around the grill at 2007 LATEST STANDA
ページ7に含まれる内容の要旨
SAFETY INSTRUCTIONS When using the grill, do not touch the grill rack, Turn off all control knobs and make certain the grill burner grate or immediate surroundings as these is cool before using any type of aerosol cleaner on areas become extremely hot and could cause or around it. The chemical that produces the burns. Use only dry potholders. Moist or damp spraying action could, in the presence of heat, potholders on hot surfaces may cause steam burns. ignite or cause metal parts to corro
ページ8に含まれる内容の要旨
SIDE SHELF ASSEMBLY Estimated Assembly Time: Approximately 10 minutes Required Tools: Phillips Screwdriver (not included) 1. Remove side shelf from inside grill cart. 2. The screws used to attach the side shelf are already screwed into the side of the grill cart. Remove the screws from the side panels. 3. Align the holes of the left side shelf with those in the grill cart, insert the screws and tighten. Note: The top two screws insert from inside the fire box while th
ページ9に含まれる内容の要旨
SIDE SHELF HANDLE ASSEMBLY Estimated Assembly Time: Approximately 5-7 minutes Required Tools: Phillips Screwdriver (not included) 1. Remove the four side shelf handle screws from the side of the shelf. 2. Align the holes in the side shelf handle with the holes in the side shelf. 3. Insert the screws and tighten. 400 500 60 0 300 700 200 100 800 BATTERY INSTALLATION 1. Remove the ignition button housing. 2. Insert the battery into the housing with t
ページ10に含まれる内容の要旨
BRAKING SYSTEM OPERATIONS 1. Push to the right to lock. 2. Push to the left to unlock. 300 400 500 200 100 600 800 700 1 1 LIQUID PROPANE CYLINDER RETENTION SYSTEM 1. Set the liquid propane gas cylinder into the slide-out tray. Turn the retention screw clockwise to secure the gas cylinder. 2. Make sure tank is leveled with bottom panel for proper vapor withdraw. 300 400 500 600 700 20 0 100 800 Retention Screw 8 2 2
ページ11に含まれる内容の要旨
CLOSE SLIDE-OUT TRAY LOCKING SYSTEM 1. To lock the liquid propane gas cylinder tray, press the button located on the top of the slide-out tray (A). 2. To unlock, press the side button (B) as shown below. 400 500 60 0 300 700 200 100 800 A B A B PROPANE REGULATOR HOOK-UP 1. Attach the regulator to the propane cylinder by turning the regulator handle clockwise. 2. Turn off the gas supply at the cylinder when the appliance is not in use. 9 OPEN
ページ12に含まれる内容の要旨
GAS HOOK-UP Only the pressure regulator and hose assembly Manifold pressure: (operating) 10 inches water supplied with the grill should be used. Any column (W.C.), (non-operating) 11.2 inches water replacement pressure regulator and hose assembly column (W.C.). must be specified by the grill manufacturer. The liquid propane cylinder must be fitted with an This is a liquid propane configured grill. Do not Overfill Protection Device (OPD). attempt to use a natural gas supply unless th
ページ13に含まれる内容の要旨
3. Detach the regulator assembly from the tank provided with the cylinder valve. The use of valve by turning the quick coupling nut other caps or plugs may result in propane counterclockwise. leakage. 4. Place the dust cap on the liquid propane cylinder valve outlet when the cylinder is not in use. Only install the type of dust cap that is LEAK TESTING GENERAL 6. If it is evident there is excessive abrasion or Although gas connections on the grill are leak wear, or the h
ページ14に含まれる内容の要旨
The gas must be turned off at the supply cylinder If the appliance is stored indoors, the cylinder must when the unit is not in use. be disconnected and removed from the appliance. Cylinders must be stored outdoors in a well- ventilated area out of the reach of children. WARNING Cylinder must be stored outdoors out of the reach of children and must not be stored in a building, garage or any other enclosed area. INSTALLER FINAL CHECK Specifie
ページ15に含まれる内容の要旨
OPERATING INSTRUCTIONS GENERAL USE OF THE GRILL AND ROTISSERIE Each main burner is rated at 15,000 BTU/Hr. The local codes, with the National Electrical Code, main grill burners encompass the entire cooking ANSI/NFPA 70-1990. area and are side ported to minimize blockage from After its first use, the stainless steel adjacent to the falling grease and debris. Above the burners are rotisserie burner will most likely turn dark blue. This stainless steel flame tamers. The igniter knobs are
ページ16に含まれる内容の要旨
NOTE Adjust the counterbalance weight to balance the It is normal for the skewer to flex when larger cuts heavier side of the meat and avoid lopsided rotation of meat are being cooked. of the rotisserie motor. If the meat scrapes on the cooking grids during any CAUTION part of the rotation, the cooking grids must be When using the rotisserie burner, remove the removed. Test this clearance before lighting the grill warming rack. High heat from the burner may cause as the cooking g
ページ17に含まれる内容の要旨
LIGHTING ILLUSTRATIONS ROTISSERIE BURNER & SEARING MAIN BURNER LIGHTING SIDE BURNER LIGHTING 1. Open the top cover or lid. 1. Push and turn rear burner slowly to “INGITE / ON” setting; you should hear a “clicking sound if the electronic ignition system is working properly. The burner should ignite within 4 seconds (if burner does not ignite follow match lighting instructions on page 18).
ページ18に含まれる内容の要旨
TO MATCH LIGHT THE GRILL If the burner will not light after several attempts using the control knobs, the burner may be lit with a match. Main Burner 1. If you have already attempted to light the burner with the igniter, allow 5 minutes for any accumulated gas to dissipate. 2. Insert a match into the lighting rod. Ignite the match and insert through the cooking grids to the burner. 3. Press the control knob and rotate left to the “IGNITE/HI” setting, continue to press the k
ページ19に含まれる内容の要旨
Sear Burner 1. If you have already attempted to light the searing side burner with the igniter, allow 5 minutes for any accumulated gas to dissipate. 2. Insert a match into the lighting rod. Ignite the match and insert through the cooking grid to the burner. 3. Press the control knob and rotate left to the “IGNITE/HI” setting, continue to press the knob until the burner ignites. The burner should light immediately. 4. If the burner does not light within 4 seconds turn the knob
ページ20に含まれる内容の要旨
Rotisserie Burner Note: Remove the warming rack when using a match to light the rotisserie burner. 1. If you have already attempted to light the rotisserie burner with the igniter, allow 5 minutes for any accumulated gas to dissipate. 2. Insert a match into the lighting rod. Ignite the match and place near the rotisserie burner. 3. Press the control knob and rotate left to the “IGNITE/HI” setting, continue to press the knob until the burner ignites. The burner should light immedia
