ページ1に含まれる内容の要旨
15-1117a.fm Page 1 Thursday, July 15, 1999 11:15 AM
Cat. No.
15-1117A
OWNER’S MANUAL
Please read before using this equipment.
10 DB Coaxial
In-Line Amplifier
ページ2に含まれる内容の要旨
15-1117a.fm Page 2 Thursday, July 15, 1999 11:15 AM This symbol is intended to alert you to Warning: To reduce the risk of fire the presence of uninsulated danger- or shock hazard, do not expose ous voltage within the product’s enclo- sure that might be of sufficient this product to rain or moisture. magnitude to constitute a risk of elec- tric shock. Do not open the product’s case. CAUTION RISK OF ELECTRIC SHOCK. ! This symbol is intended to inform you DO NOT OPEN. that important operating a
ページ3に含まれる内容の要旨
15-1117a.fm Page 3 Thursday, July 15, 1999 11:15 AM The RadioShack 10 dB Coaxial In-Line Amplifier brings to your home video system the same technology that is used in commercial cable systems: a single, standard coaxial cable carries both the TV/radio signal and the power necessary for the in-line amplifier. The In-Line Amplifier reduces or eliminates the signal losses caused by signal transformers, signal splitters, other in-line devices or extremely long cable runs between the antenna and
ページ4に含まれる内容の要旨
15-1117a.fm Page 4 Thursday, July 15, 1999 11:15 AM Caution: Because the In-Line Amplifier uses the coaxial cable to carry the TV/radio signal from the DC power supply, proper connections are crucial. Failure to exactly follow the connection instructions in this manual can result in damage to your amplifier or your TV/radio receiver. ILLUSTRATION Note: The amplifier and DC block are sealed together by a plastic tube. In most installations, they must remain together. Read all connection instru
ページ5に含まれる内容の要旨
15-1117a.fm Page 5 Thursday, July 15, 1999 11:15 AM ONE ANTENNA/ONE RECEIVER SYSTEMS If you are using a single antenna with a single TV/radio receiver, “Installation A” shows the proper connections. To avoid damage to your TV/radio receiver and/or the amplifier power in- jector, carefully check all the points listed below. • Do not separate the amplifier from the DC block. The DC block must be between the amplifier and the 300-to-75 ohm transformer (Cat. No. 15-1140) at the antenna. • Follow
ページ6に含まれる内容の要旨
15-1117a.fm Page 6 Thursday, July 15, 1999 11:15 AM Installation A ILLUSTRATION Do not plug in the power injector until all connections have been double-checked. 6
ページ7に含まれる内容の要旨
15-1117a.fm Page 7 Thursday, July 15, 1999 11:15 AM ONE ANTENNA/TWO RECEIVER SYSTEMS If you are using a single antenna with two TV/radio receivers, “Installation B” shows the proper connections. To avoid damage to your TV/radio receivers and/or the amplifier power injector, carefully check all the points listed below. • For the first antenna and TV/radio receiver (#1), follow all instructions on Page 5 for “One Antenna/One Receiver Systems.” • Make sure the power injector is between the ampli
ページ8に含まれる内容の要旨
15-1117a.fm Page 8 Thursday, July 15, 1999 11:15 AM Installation B ILLUSTRATION Do not plug in the power injector until all connections have been double-checked. 8
ページ9に含まれる内容の要旨
15-1117a.fm Page 9 Thursday, July 15, 1999 11:15 AM Additional Amplification If additional amplification is needed, you can connect another amplifier in line with the first am- plifier. Remove the DC block from the optional second amplifier. One power injector will supply enough power for both amplifiers. Note: The In-Line Coaxial Amplifier can only be purchased as a kit, with the Power Injector and DC Block. If you want to use a second amplifier in your system, retain the extra parts for fu
ページ10に含まれる内容の要旨
15-1117a.fm Page 10 Thursday, July 15, 1999 11:15 AM AMATEUR TV SYSTEMS You can use the In-Line Amplifier with 2.4 GHz, amateur TV (ATV) systems, as shown in “In- stallation C.” If the power supply provided with your ATV antenna provides a center-positive power supply, it can be used to power the In-Line Amplifier as well; you do not need the amplifier’s power injec- tor. Caution: The In-Line Amplifier cannot be used if the ATV power supply is center negative. In this case only, you should re
ページ11に含まれる内容の要旨
15-1117a.fm Page 11 Thursday, July 15, 1999 11:15 AM Installation C ILLUSTRATION 11
ページ12に含まれる内容の要旨
15-1117a.fm Page 12 Thursday, July 15, 1999 11:15 AM PROBLEM SOLVING If the TV/radio receiver does not operate correctly after installation of the In-Line Ampli- fier: • Immediately unplug the power injector. • Check all connections and compare them with the appropriate installation drawing(s) in this manual. If no problems are found in the connections: Plug in the power injector and try the TV/radio receiver again. If possible, try a different TV/radio receiver with the system or try the TV/
ページ13に含まれる内容の要旨
15-1117a.fm Page 13 Thursday, July 15, 1999 11:15 AM SPECIFICATIONS Amplifier: Frequency: 5–900 MHz Gain: 5–50 MHz 8 dB MIN 50–300 MHz 10 dB MIN 300–900 MHz 9 dB MIN (7 CHANNEL INPUTS) Input Capability.................................................................83dB μV MIN Max Input for –60dB Third Order Distortion............................... 90dB μV MIN (Tested AT CH.3) Noise Figure: 5–400 MHz 6 dB MAX 400–900 MHz 6.5 dB MAX Power Injector: Input.....................................
ページ14に含まれる内容の要旨
15-1117a.fm Page 14 Thursday, July 15, 1999 11:15 AM NOTES 14
ページ15に含まれる内容の要旨
15-1117a.fm Page 15 Thursday, July 15, 1999 11:15 AM 15
ページ16に含まれる内容の要旨
15-1117a.fm Page 16 Thursday, July 15, 1999 11:15 AM Limited Ninety-Day Warranty This product is warranted by RadioShack against manufacturing defects in material and workmanship under normal use for ninety (90) days from the date of purchase from RadioShack company-owned stores and authorized RadioShack franchisees and dealers. EX- CEPT AS PROVIDED HEREIN, RadioShack MAKES NO EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES, INCLUDING THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOS
