Havis-Shields C-VS-1300-TBZの取扱説明書

ページ1に含まれる内容の要旨

4
INSTALL INSTRUCTIONS C-VS-1300-TBZ
VEHICLE SPECIFIC CONSOLE
2006-2008 CHEVROLET TRAILBLAZER

TOOLS REQUIRED:
Phillips screwdriver 15mm socket
T-15 Torx driver Jig Saw or plastic cutting tool
T-20 Torx driver Eye goggles
7/16 wrench
Ratchet wrench
7/16” socket

HARDWARE:
QTY DESCRIPTION PART #
1 Trailblazer vehicle specific console C-VS-1300-TBZ-H
1 Bail bracket C-B1
1 Rear hump bracket set C-B27
1 Duct block off plate CM001516
2 Side “L” brackets CM93594
1 Con

ページ2に含まれる内容の要旨

Remove six phillips screws that hold Remove main console screws. Unplug wires for rear controls. inner storage pocket. Remove storage pocket and arm rest assembly. Remove shift lever “T” knob. Measure approximately 3 ½” back Mark Measurement with tape. (T15 Torx) from shift lever boot. Position shift lever in drive or Note: In order to remove console, Remove front trim to aid in running further back. Remove entire you must reach up inside the shifter additional wi

ページ3に含まれる内容の要旨

Extend cut line on console sides. Carefully reinstall front console Reattach shift lever “T” handle. Carefully cut off back console section. section. (Jig saw, Air saw, Dremel (Reattach Traction Control Plug) or Air drill) Remove inboard rear seat nuts. Attach bail bracket onto rear hump Place duct block off plate in duct (15mm) Place new rear hump brackets with ¼ x ¾ bolts. opening and screw down with #10 x brackets on seat studs under seat Note: You may need to bend hump

ページ4に含まれる内容の要旨

Finish wiring and complete installation C-VS-1300-TBZ_INST_9-07 4