ページ1に含まれる内容の要旨
Register your product and get support at
www.philips.com/welcome
22PFL4505D
19PFL4505D
EN: For further assistance, call the customer support service in your country.
• To obtain assistance in the U.S.A., Canada, Puerto Rico, or the U.S. Virgin Islands, contact Philips
EN User manual Customer Care Center at 1-866-309-0841
• To obtain assistance in Mexico, contact Philips Customer Care Center at 01 800 504 62 00
Enter below the model and serial numbers located on the back and right side of the TV
ページ2に含まれる内容の要旨
Contents 9 Connect devices 27 1 Notice 4 Connection overview 27 Selecting your connection quality 28 2 Important 5 Connecting your devices 29 Product information 5 Screen care 5 10 Troubleshooting 31 Environmental care 5 Downloading an electronic copy 31 Regulatory notices 5 Contact us 31 3 Your TV 6 11 Notes for the use of USB devices 32 Side controls and indicators 6 Remote control 6 12 Specifi cations 33 4 Get started 8 Supplied accessories 8 13 Warranty 34 Mounting stand
ページ3に含まれる内容の要旨
Return your Product Registration Card or register online at www.philips.com/welcome today to get the very most from your purchase. Registering your model with PHILIPS makes you eligible for all of the valuable benefits listed below, so don't miss out. Complete and return your Product Registration Card at once, or register online at www.philips.com/welcome to ensure: *Proof of Purchase *Product Safety *Additional Benefits Notification Returning the enclosed card guarantees By registering your
ページ4に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 1. Read these instructions. C. The appliance has been exposed to rain; or 2. Keep these instructions. D. The appliance does not appear to operate normally or exhibits a 3. Heed all warnings. marked change in performance; or 4. Follow all instructions. E. The appliance has been dropped, or the enclosure damaged. 5. Do not use this apparatus near water. 17. Tilt/Stability - All televisions must comply with recommended 6.
ページ5に含まれる内容の要旨
Cables 1 Notice Connections to this device must be made with shielded cables with metallic RFI / EMI connector hoods to maintain compliance with FCC Rules and Regulations. 2010 © Koninklijke Philips Electronics N.V. All rights reserved. Canadian notice Specifi cations are subject to change without notice. Trademarks are Standard Television Receiving Apparatus, Canada BETS-7 / NTMR-7. the property of Koninklijke Philips Electronics N.V. or their respective owners. Philips reserves the right
ページ6に含まれる内容の要旨
Environmental care 2 Important Registering your model with Philips makes you eligible for all of the valuable benefi ts listed below, so don’t miss out. Complete and return your Product Registration Card at once, or register online at www.philips.com/welcome to ensure: • Proof of Purchase Returning the enclosed card guarantees that your date of purchase is on fi le, so no additional paperwork is required from you to The packaging of this product is intended to be recycled. Contact your ob
ページ7に含まれる内容の要旨
Remote control 3 Y our TV Congratulations on your purchase, and welcome to Philips! To fully benefi t from the support that Philips offers, register your product at a www.philips.com/welcome b Side controls and indicators s c * r d q f p e e f g d o h c b a a Standby indicator / remote control sensor n i b Ambient light sensor When in [Home] mode, this TV will automatically adjust the brightness based on the ambient light. If there is a sudden change j in TV brightness, it may be due to chan
ページ8に含まれる内容の要旨
c FORMAT Selects a picture format (see ‘Changing picture format’ on page 16). d SAP Digital Mode (DTV) • Press to select the audio language. Analog Mode (TV) • Press to select the audio mode. e FREEZE Press to pause screen image. f OK Activates a selection or accesses the menu. g Î ï Í Æ (Navigation buttons) Navigates through the menus. h INFO Displays information about the TV channel or accessory device. The quality and accuracy of the information depends on the broadcaster. You might see a
ページ9に含まれる内容の要旨
Tilt stand 4 Get started You can adjust the stand to change the angle of the unit (-2° to 10°). -2° 10° Supplied accessories • Remote control • 2 x AAA, 1.5V batteries • M4 x 10 double sems screw x 2 • AC Power cord • Cable management tie • User Manual • Quick Start Guide Mounting stand onto TV Applicable to TVs without mounted stands. P osition the TV 1 Warning • Do not insert the AC power cord into the power socket outlet before all the connections are made. • Large screen TVs are he
ページ10に含まれる内容の要旨
If you connect a set-top box through RF IN / OUT Connecting the antenna or cable If the TV is connected to a cable box or satellite set-top box via a coaxial connection, set the TV to channel 3 or 4, or to the channel specifi ed by the service provider. Cable If you connect to an antenna Any DTV programs that are broadcast in your area can be received for If you connect a set-top box through HDMI free through an antenna connection. If the TV is connected to a cable box or satellite set-top box
ページ11に含まれる内容の要旨
Managing cables Plugging in the AC power cord Route your antenna cable and all other cables through the cable holder W arning at the back of the TV. The holder helps keep your cables tidy and easily manageable. • V erify that your power voltage corresponds with the voltage printed at the back of the TV. Do not insert the AC power cord if the voltage is different. 1 Attach the cable holder as illustrated below. 1 Locate the power connector at the back of the TV. The location of the power con
ページ12に含まれる内容の要旨
Press Í or Æ 5 times to select the side of the pictures that is the most Switching on and initial setup pleasing to you. then press OK. Before you switch on the TV, check that the AC power cord is properly . . connected. Press POWER at the right side of the TV, or press on Left side Right side the remote control. The TV normally takes 25-30 seconds to start up and the following screen appears the fi rst time you turn on the TV. Initial Setup Initial Setup English Select your menu languag
ページ13に含まれる内容の要旨
Switching channels 5 Use your TV This section helps you perform basic TV operations. Switching your TV on / off or to standby Press CHANNEL + / − on the side of the TV. For digital channels, press a number (1 to 135) followed by a dot “ ” and then the corresponding • sub channel number (1 to 135). e.g. 108.30. • Press CH + / − or enter a number on the remote control. • Press PREV CH to return to the previously viewed channel. To switch on • Press . POWER at the side of the TV or press . (St
ページ14に含まれる内容の要旨
Adjusting v olume Still mode You can pause the image shown on the TV screen. Press FREEZE to pause the image shown on the TV screen. FREEZE • The sound output will not be paused. • If no signal is detected or protected signal is received during still mode, the image remains paused and the sound output will be muted. • The still function will be released after 5 minutes. To cancel still mode, press any button except . (Standby-On). Watching channels from a set-top box To watch channels from
ページ15に含まれる内容の要旨
Watching a Blu-ray disc Switching audio mode To watch a Blu-ray Disc This section describes how to switch the audio language in the digital mode and how to switch the audio in the analog mode. 1 Insert a Blu-ray Disc into your player. 2 Press ► (play) on the remote control of the Blu-ray Disc player. DTV » The Blu-ray Disc might automatically play on the TV. If the picture does not appear 1 Press SAP to display the currently selected language and the number of available languages. 11.1 Eng
ページ16に含まれる内容の要旨
PC settings 6 Use more of your TV This function lets you adjust the PC screen position, clock and phase during PC input. 1 Press MENU on the remote control and select [Features] > Changing picture and sound settings [PC Settings]. Y ou must set [Home] in [Location] (refer to page 21). 2 Adjust the setting. Otherwise, personalized picture and sound settings will not be [Auto Adjustment] memorized after you turn off the unit. Î ï Press or to select [Adjust], then press OK. • The horizonta
ページ17に含まれる内容の要旨
For 4:3 video signal Changing pictur e format 1 Press FORMAT on the remote control. [][ ] Normal 16:9 Î ï 2 Press or to select a picture format and press OK to confi rm your choice. [ ] Movie Expand Summary of picture formats 5 types of display modes can be selected when the broadcasting station is sending 16:9 or 4:3 video signal. And 3 types of display modes can be selected for PC input signal. For 16:9 video signal [ ] [ ] Wide Zoom Normal Display a 4:3 picture at its original size. Sid
ページ18に含まれる内容の要旨
[ ] TV Speakers Using your TV as a PC monitor This option will allow you to select the audio output from the Use a VGA connector to connect a PC to your TV. For sound, add an unit’s speakers. If you have an amplifi er which is compatible with audio cable with a stereo mini jack. the HDMI CEC function connected to this unit using an HDMI cable, some sound operations such as volume up can be used with Caution this unit’s remote control. Î ï • Before you connect your PC, set the PC monitor
ページ19に含まれる内容の要旨
Sleeptimer Sleeptimer switches the TV to standby after a pre-defi ned period of time. Picture You can always switch off your TV earlier or reset the sleeptimer during Video Sound the countdown. Component Setup HDMI 1 Press SLEEP to set the sleep timer. Features HDMI 2 Sleep Off Language PC USB Sleep timer display appears on the TV screen. 40.1 DTV Press SLEEP repeatedly to change the amount of time until shut off. BACK OK Back Select View / Block Sleep 120min. 3 Press Î or ï and then press O
ページ20に含まれる内容の要旨
Summary of TV ratings Summary of US movie ratings Rating Description Age rating Content rating TV -Y : Appropriate for children of all ages None NR Not rated. with themes and elements suitable for G Movies with a mild content, suitable for all ages. children aged 2-6. PG Mo vies for which parental guidance is recommended. TV -Y7 : Programs designed for children age 7 [FV] (Fantasy Violence) They may contain a few racy or violent scenes or and older. maybe some bad language. TV -
