ページ1に含まれる内容の要旨
26 inch Digital / Analog
LCD TV
Owner’s Manual
6626LCT
INPUT
POWER SLEEP SELECT
1 2 3
4 5 6
AUDIO
7 8 9
STILL
- 0
SCREEN
SETUP MODE
ENTER
BACK INFO
CH RETURN
VOL. CH
MUTE
STANDBY POWER ON
HIGH-DEFINITION TELEVISION
TO RECEIVE DIGITAL/ANALOG SIGNAL,
YOU MUST CONNECT ANTENNA.
IF YOU NEED ADDITIONAL ASSISTANCE WITH SET-UP OR OPERATING AFTER
READING OWNER’S MANUAL, PLEASE CALL TOLL FREE 1-800-605-8453,OR
VISIT OUR WEB SITE AT http://www.SylvaniaConsumerElectronics.com
ページ2に含まれる内容の要旨
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLI- ANCE TO RAIN OR MOISTURE. THIS SYMBOL INDICATES THAT DANGER- CAUTION OUS VOLTAGE CONSTITUTING A RISK OF RISK OF ELECTRIC SHOCK ELECTRIC SHOCK IS PRESENT WITHIN DO NOT OPEN THIS UNIT. CAUTION: TO REDUCE THE RISK OF ELEC- THIS SYMBOL INDICATES THAT THERE TRIC SHOCK, DO NOT REMOVE COVER (OR BACK). ARE IMPORTANT OPERATING AND MAIN- NO USER SERVICEABLE PARTS INSIDE. REFER TENANCE INSTRUCTIONS IN THE LITERA- SERVICING TO
ページ3に含まれる内容の要旨
where it can fall into such power lines or circuits. When installing an out- d. If the TV does not operate normally by following the operating instruc- side antenna system, extreme care should be taken to keep from touching tions. Adjust only those controls that are covered by the operating such power lines or circuits as contact with them might be fatal. instructions, as improper adjustment of other controls may result in damage and will often require extensive work by a qualified techni- 16. O
ページ4に含まれる内容の要旨
SUPPLIED ACCESSORIES • Owner’s Manual • Remote control unit • Batteries (1EMN21350) (NF000UD) (“AA” x 2) • If you need to replace these accessories, please refer to the PART NO, with the illustrations and call our help line mentioned on the front page. • Depending on your antenna system, you may need different types of Combiners (Mixer) or Separator (Splitter). Contact your local electronics store for these items. FEATURES • DTV/TV/CATV This TV lets you easily switch TV(NTSC) and DTV(ATSC) with
ページ5に含まれる内容の要旨
ONTENTS C IMPORTANT SAFEGUARDS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SUPPLIED ACCESSORIES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 FEATURES . . . . . . . . . . . . . . . . . . . .
ページ6に含まれる内容の要旨
UNCTIONS F REMOTE CONTROL, TOP AND REAR PANEL FUNCTION SLEEP button (p23) INPUT SELECT button (p20) To turn the power off automatically at To select TV or external input mode (to INPUT preset time access DVD, VCR, etc.) POWER SLEEP SELECT POWER button (p12) AUDIO button (p19) To turn TV on/off • Analog mode (TV) 1 2 3 To select audio mode Channel number buttons (p15) • Digital mode (DTV) To select channels 4 5 6 To select audio language AUDIO SETUP button (p14) 7 8 9 To display on-screen menu ST
ページ7に含まれる内容の要旨
ANT. IN jack AUDIO OUT jacks Connect your antenna or cable Connect the supplied audio cable box here. here through the audio in jacks of audio equipment. DIGITAL AUDIO OUT ANT. IN (COAXIAL) jack L L HDMI IN jacks AUDIO OUT AUDIO Connect an optional coaxial digi- Connect HDMI cable and audio DIGITAL HDMI IN AUDIO OUT R R tal audio cable here through the (COAXIAL) cable coming from the HDMI and HDMI coaxial digital audio in jack of a audio out jack of external devices. from underneath decoder or
ページ8に含まれる内容の要旨
REPARATION FOR USE P CONNECTION This section describes how to connect this TV to reception and other sources. MAKE SURE YOU HAVE AN ANTENNA As DTV is only available over the air, you need an antenna to receive digital signal. NOTE: Be sure that antenna or cable is connected properly before plugging the power cord. [ANTENNA CABLE CONNECTION] 1) When connecting TV to antenna Connect the RF cable or antenna cable on your home outlet to the ANT. IN jack of this TV. 2) When connecting TV to RF/Incomi
ページ9に含まれる内容の要旨
EXTERNAL CONNECTION [HDMI CONNECTION] 1) This is the best method to connect this TV to video devices with the HDMI output jack, such as DVD play- er with HDMI output jack, etc. It can minimize the deterioration of image quality. Use the HDMI cable (commercially available) for connection. To HDMI INPUT jack HDMI OUT ANT. IN L L AUDIO OUT AUDIO DIGITAL To HDMI output jack HDMI IN AUDIO OUT R R (COAXIAL) DVD Player with the HDMI output jack HDMI Cables not included Rear of this TV NOTE: This TV acc
ページ10に含まれる内容の要旨
[COMPONENT CONNECTION] 1) This is a better method to connect this TV to video devices with the Component output jack, such as DVD player, etc. Use the Component cable (commercially available) for connection. If you connect component output jack to COMPONENT1 input jack, connect an audio cable to AUDIO L/R jacks of COMPONENT1. If you connect component output jack to COMPONENT2 input jack, connect an audio cable to AUDIO L/R jacks of COMPONENT2. To component video To COMPONENT1 output jacks INPUT
ページ11に含まれる内容の要旨
[ANALOG AUDIO/VIDEO CONNECTION] 1) This is the general method to connect this TV to video devices with the video and audio output jacks, such as VCR, Camcorder, Video Game, etc.. When the audio jack of video devices is monaural, connect this TV to the Audio L jack. To VIDEO1 INPUT jack To video output Y Y VIDEO VIDEO jack AUDIO VIDEO Pb Pb OUT OUT L L L L Camcorder Video Game S-VIDEO1 AUDIO Pr AUDIO Pr AUDIO AUDIO R R R R To audio output S-VIDEO2 jacks COMPONENT2 COMPONENT1 VIDEO2 VIDEO1 VCR Rea
ページ12に含まれる内容の要旨
NITIAL SETTINGS I Hint: Before starting initial setup you must connect antenna. INITIAL SETTINGS K L 3 Select your language using [ / ], press [ENTER]. This section describes the initial settings when you When you first turn on the power, the following first turn on the power after purchase. The initial screen is displayed. setting items are shown below. Initial Setup Initial Setup • LANGUAGE SELECTION Select the language used for setup. English You can select the menu language displayed on Elij
ページ13に含まれる内容の要旨
HANNEL SETTINGS C AUTOSCAN K L 3 For TV channels, using [ / ], select “Air”. If you switch wires (e.g. between antenna and For CATV channels, select “Cable”. CATV) or if you move the TV to a different area A Autoscan utoscan after the initial setting, you need to perform Back Autoscan will rescan all channels. This may take a while to complete. Autoscan again. This function lets you easily select Air Select the destination of "ANT.IN" jack. Cable K L the receivable channels with [CH / ] and the
ページ14に含まれる内容の要旨
CHANNEL LIST 3 Select the channel you want to skip. K L The Channel List function lets you skip the unnec- • Using [ / ], select the channel. essary channels from the Channel registration list. Channel List Channel List STILL Highlight channels for DTV DTV 6 6 - 0 Ch Up/Down key selection. DTV DTV 8 8 SCREEN 9 SETUP SETUP MODE 9 27 DTV DTV 48 48 58 58 DTV 67 ENTER ENTER BACK ENTER Ch Select Watch/Skip Back INFO BACK CH RETURN • Press [ENTER], and the highlight on the selected channel disappears,
ページ15に含まれる内容の要旨
MANUAL REGISTER 3 Select the channel you want to add. • Using Channel number buttons, select your You can register shortage of channels that were not desired channel. scanned by the Autoscan function due to the bad reception status at the initial setting. 11 INPUT Manual Register Manual Register POWER SLEEP SELECT For Analog channels, Register select a channel to register using number keys. For Digital channels, 1 1 2 2 3 3 you must perform Autoscan function. 4 4 5 5 6 6 AUDIO BACK 7 7 8 8 9 9
ページ16に含まれる内容の要旨
• If the channel is set to external input, you can- ANTENNA CONFIRMATION not confirm the antenna situation. You can verify the signal strength of each channel Video1 to get a clearer picture. Antenna Antenna Back INPUT POWER SLEEP SELECT Indicator is available for antenna signal only. 1 1 2 2 3 3 4 4 5 5 6 6 CH Ch Change AUDIO 7 7 8 8 9 9 STILL 4 To exit the setup, press [SETUP]. - - 0 0 SCREEN SETUP SETUP MODE ENTER ENTER INFO BACK CH RETURN VOL. CH CH MUTE 1 Display the setup screen. • Press
ページ17に含まれる内容の要旨
LANGUAGE SELECTION You can choose your on screen language from one of the following English, Spanish or French. STILL - 0 SCREEN SETUP SETUP MODE ENTER ENTER INFO BACK CH RETURN VOL. CH MUTE 1 Display the setup screen. • Press [SETUP]. The following setup screen is displayed. 2 Select “LANGUAGE” and press [ENTER] to con- firm. K L • Using [ / ], select “English/Español/Français”. Language Language Select the language for setup display. English Elija idioma de preparacion. Espanol Selectionner la
ページ18に含まれる内容の要旨
ATCHING TV W NTSC ATSC 18:00 CHANNEL SELECTION CH4-1 No signal No signal K L You can select the channel by using either [CH / ] 18:30 or Channel number buttons. How to select the CH4-1 CH4-2 CH4-3 channel in each way is shown below. CH4 19:00 INPUT POWER SLEEP SELECT CH4-1 No signal CH4-3 19:30 1 1 2 2 3 3 CH4-1 CH4-2 No signal 4 4 5 5 6 6 20:00 AUDIO : changes automatically 7 7 8 8 9 9 STILL : change manually by pressing [CH / ] - - 0 0 on your remote control. SCREEN SETUP MODE NOTE: “
ページ19に含まれる内容の要旨
SAP / MONO SAP / MONO STILL MODE When the broadcasting is having only monaural You can freeze the image shown on the screen. audio... 1 2 3 MONO (cannot be switched.) 4 5 6 AUDIO 7 8 9 6 STILL STILL - 0 SAP / STEREO SCREEN SETUP MODE STEREO : Outputs stereo-audio SAP : Outputs second audio program MONO : Outputs mono-audio 1 Pausing image. DTV • Press [STILL], the image shown on the screen is paused. 1 Switch the audio language. Still • When you press [AUDIO], the currently selected language and
ページ20に含まれる内容の要旨
SWITCHING EXTERNAL INPUT • When you press [INFO], the current external input mode, the type of resolutions for video When you connect external devices including a signal, TV aspect ratio CC and TV rating will be video cassette recorder and home audio system, displayed at the top-right of the screen. you can easily switch the input mode with the remote control. 1) When using VIDEO1 or S-VIDEO1 INPUT jack INPUT INPUT POWER SLEEP SELECT SELECT Video1 480i SD 480i SD 1 2 3 TV-PG DLSV CC CC 4 5 6 AUD
