Edelbrock PERFORMER-PLUS 2167の取扱説明書

ページ1に含まれる内容の要旨

PERFORMER-PLUS
Camshaft/Lifters/Lube Kit
CATALOG #2167
MODEL: 429/460 c.i.d. Ford V8
• PLEASE study these instructions carefully before installing your new camshaft. If you have any questions or problems, do not hesitate to call our
Technical Hotline at: 1-800-416-8628.
� CAMSHAFT: Edelbrock Performer-Plus camshafts are ground specifically for use with the corresponding Performer manifold. The Performer mani-
fold #2166 or #3766, and Performer-Plus camshaft #2167, are designed to work as a team

ページ2に含まれる内容の要旨

� VALVE SPRINGS 2. Turn the engine over again until the intake lifter just stops coming CAUTION: WARNINGS ABOUT YOUR WARRANTY down. At this point install pushrod and adjusting nut on exhaust In order for this Performer-Plus cam and lifter kit to be covered rocker arm and repeat the same procedure as above. under ANY WARRANTY you MUST use the correct Edelbrock Sure 3. The above procedure assures correct hydraulic lifter pre-load. Seat Valve Springs or original equipment springs. Failure to instal

ページ3に含まれる内容の要旨

� CAM GEARS AND CAMSHAFT END PLAY- If cam gear becomes � CARBURETION AND IGNITION TIMING loose, the cam will slide back in the block, causing the lifters to hit Best carburetor results were with the Edelbrock Performer Series the lobes next to them and also the cam bearing journals. If the carburetors #1405 (600 cfm with manual choke), #1406 (600 cfm engine is run after this happens, the bottom of the lifters and the with electric choke), or #1407 (750 cfm with manual choke). sides of the lobes

ページ4に含まれる内容の要旨

CAMSHAFT: Performer-Plus Hydraulic CAMSHAFT: Performer-Plus Hydraulic CATALOG #2167 CATALOG #2167 ENGINE: Ford 429/460 c.i.d. V8 ENGINE: Ford 429/460 c.i.d. V8 RPM RANGE: Idle-5500 RPM RANGE: Idle-5500 CAUTION: Do not use dual valve springs. CAUTION: Do not use dual valve springs. Use only recommended stock or Edelbrock Sure Seat Valve Springs Use only recommended stock or Edelbrock Sure Seat Valve Springs #5867 #5867 Use stock ratio rocker arms only. Use stock ratio rocker arms only. Duration