ページ1に含まれる内容の要旨
PN 72700
12-Volt 10-lb./15-lb. Nitrous Bottle Heater
Installation Instructions
Features:
Durable, Long-Lasting Heating Element
Velcro® Straps for Easy Installation
Dual Thermostat Cartridges for Reliability
All Electrical Hardware Included
Please read these instructions carefully before you begin installation.
1. Secure the Edelbrock bottle heater around the bottle using the Velcro straps. Mount the heater
around the bottom section in a manner so that the end gap is at
ページ2に含まれる内容の要旨
10. Connect terminal #1 from the toggle switch to an “ignition-switched” +12 volt source. We recommend that you connect this wire to the switched-on power of the vehicle’s nitrous system arming switch. This ensures that the heater can only be activated when the nitrous system is armed. 11. Connect terminal #2 from the toggle switch to the white wire on the relay. 12. Connect terminal #3 to a good chassis ground. Wiring Diagram Hardware Includes: Item Qty. Description 1
ページ3に含まれる内容の要旨
IMPORTANT WARNING This Edelbrock heater should never be used with the thermostats installed. The thermostats must always be in contact with the surface of the bottle in order for the thermostats to properly sense the bottle temperature. The thermostats have a cut-in and cut-out setting at 85º F +/- 5º F. Failure to follow this important warning will result in the temperature of the bottle to rise to unsafe temperatures and the pressure within the bottle to rise to level
ページ4に含まれる内容の要旨
Caution 1. The bottle heater surface can achieve temperatures in excess of 400 degrees. Do not attempt to handle, adjust, or remove from the bottle while the heater is in operation. 2. Do not touch heater surface while in operation. Severe burns to the skin can result. 3. Do not rest or lie heating element against flammable or temperature sensitive materials, objects, paints, or coatings as they could be caused to ignite due to the excessively high temperatures. 4. Do not operate this
