Edelbrock 6607の取扱説明書

ページ1に含まれる内容の要旨

TUBULAR EXHAUST SYSTEM
For 1995-1998 Toyota Tacoma, 4-Runner
with 3.4L V6, Auto & Standard Transmissions
Catalog #6607
INSTALLATION INSTRUCTION
Please study these instructions carefully before installing your new Tubular Exhaust System (TES). If you have any
questions or problems, please contact our Technical Hotline at : 1-800-416-8628 from 7 am - 5pm, Monday-Friday,
Pacific Standard Time or e-mail us at edelbrock@edelbrock.com.
TUBULAR EXHAUST SYSTEM: This stainless steel Tubular Exhaust Sys

ページ2に含まれる内容の要旨

INSTALLATION INSTRUCTIONS Disassembly 4. Use the 1/2” long spacer tube 8mm bolt and lock washer supplied to hold dipstick tube bracket to 1. Disconnect negative battery cable. cylinder head, (Automatic transmission only). 2. Remove O2 sensor in front of catalytic converter. Be 5. From under the vehicle, install new T.E.S. crossover careful not to damage. and Y-pipe assembly using exhaust donut and bolts 3. Remove extension pipe. This is the pipe between supplied. Before tightening bolts, alig

ページ3に含まれる内容の要旨

CUTTING INSTRUCTIONS: WELDING INSTRUCTIONS: Tacoma: No cutting of catalytic converter inlet is After aligning Y-pipe assembly up with catalytic necessary. converter in stock location, bolt the catalytic converter 4-Runner: Cut inlet end of catalytic converter flange supplied to the new Y-pipe flange, then weld approximately 1 inch in front of weld on inlet. You may flange to inlet. need to do additional trimming when fitting Y-pipe to NOTE: Top of Y-pipe flange should be 1-3/4” from the cataly