ページ1に含まれる内容の要旨
Performer-Plus
Camshaft/Lifters/Lube Kit
®
CATALOG #3712
MODEL: 307, 330, 350, & 403 c.i.d. Oldsmobile V8, 1967 to 1985
Instructions
• PLEASE study these instructions carefully before installing your new camshaft. If you have any questions or problems, do not hesitate to call our
Technical Hotline at: 1-800-416-8628.
� CAMSHAFT: Edelbrock Performer-Plus camshafts are ground specifically for use with the corresponding Performer manifold #3711 on engines
operating from idle to 5500 rpm. The Perfo
ページ2に含まれる内容の要旨
INSTRUCTIONS FOR ENGINE PARTS REMOVAL � LIFTERS � BEFORE CAMSHAFT INSTALLATION 1. New lifters must be used with a new camshaft. Use only the lifters 1. Disconnect battery. supplied with this kit. 2. For ease of installation, keep all parts in some sort of order. 2. Check to be sure that all lifters fit freely in the lifter bores. WARNING: Do not remove radiator cap or radiator hose if engine is hot. � INSTALLATION INSTRUCTIONS 3. Drain radiator coolant, move fan shroud back and remove fan and 1.
ページ3に含まれる内容の要旨
� INSTALLING DISTRIBUTOR AND TIMING ENGINE � IGNITION TIMING NOTE: Before installing your distributor, check the gear drive on the Ignition timing for this package may vary with each application. A distributor and oil pump for any signs of wear. If worn, be sure to good starting figure would be between 10 degrees to 14 degrees ini- replace with new or you may wear out your camshaft prematurely. tial timing at idle with vacuum advance disconnected. Total advance Edelbrock camshafts are designed t
ページ4に含まれる内容の要旨
� CAMSHAFT: Performer-Plus Olds 350 � CAMSHAFT: Performer-Plus Olds 350 ® ® � CATALOG #3712 � CATALOG #3712 � ENGINE: Oldsmobile 307/330/350/403 c.i.d. V8 � ENGINE: Oldsmobile 307/330/350/403 c.i.d. V8 � RPM RANGE: idle-5500 � RPM RANGE: idle-5500 � CAUTION: Use only recommended Edelbrock Sure Seat � CAUTION: Use only recommended Edelbrock Sure Seat Valve Springs #5812 or original equipment equivalent. Valve Springs #5812 or original equipment equivalent. Duration at .006” Lift: Intake 280° Exh
