ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Contents Remote Control Buttons ..............................................................................................................................2 LCD TV .......................................................................................................................................................2 Preparation ................................................................................................................................................. 3 Safety Precautions .
ページ4に含まれる内容の要旨
Remote Control Buttons = Stand By =Reveal 1 32 = Cursor Up = Expand / 31 = Cursor Right /WIDE = Image Size 30 2 3 = Info (Program Table) 29 M = Mix, 4 28 SELECT INFO 0 - 9 = Direct Program = No function OK ABC DEF GHI -/-- / EXIT = No Function = Teletext 5 1 2 3 JKL MNO PQR P + = Programme Up = Time 4 5 6 STU VWX YZ 27 = Volume Up 7 8 9 Red button = Sound Menu + TV DTV 6 PP 0 -/-- = TV / Quit Menu Green button = Picture Menu EXIT 7 AV SOURCE = External Source P
ページ5に含まれる内容の要旨
Preparation Safety Precautions For ventilation, leave a space of at least 10 cm free all Please read the following recommended safety pre- cautions carefully for your safety around the set. To prevent any fault and unsafe situ- ations, please do not place any objects on top of the 1. Power Source set. The set should be operated only from a 220-240V AC, Use this apparatus in moderate climates. 50 Hz. outlet. Ensure you select the correct voltage setting for your convenience. 2. Power Cord Do not
ページ6に含まれる内容の要旨
8. Replacement Part When replacement parts are required, be sure the ser- vice technician has used replacement parts which are specified by the manufacturer or have the same speci- fications as the original one. Unauthorised substitutions may result in fire, electrical shock, or other hazards. 9. Servicing Please refer all servicing to qualified personnel. Do not remove the cover yourself as this may result in an electric shock. WARNING: When the device is not in use for a long time, disconnect
ページ7に含まれる内容の要旨
Note: Remove the battery from remote control hand- Before Switching On Your TV set when it is not to be used for a long period. Other- wise it can be damaged due to any leakage of bat- Power Connection tery. IMPORTANT: The TV set is designed to operate on 220-240V AC, 50 Hz. Switching The TV ON/OFF • After unpacking, allow the TV set to reach the ambi- To switch the TV on: ent room temperature before you connect the set to the mains. Your TV will switch on in two steps: 1- Connect the power supp
ページ8に含まれる内容の要旨
Press / button to set the level. Navigating the Menu System Hint: Hue is displayed in picture menu when the TV For navigation receives an NTSC signal. Colour Temp For displaying menu options • By pressing / button select Colour Temp. M T o confirm choices • Press / to choose from one of these options: Cool, Normal and Warm. SELECT INFO OK Noise Reduction 1- Press M to display the menu. By pressing / button select Noise Reduction. Press / to choose from one of these options: 2- Pre
ページ9に含まれる内容の要旨
Volume Dynamic Bass Dynamic Bass is used to increase bass effect of the By pressing / select Volume . Press / TV set. button to change the level of the Volume. By pressing / button, select Dynamic Bass. By Equalizer pressing / button set Dynamic bass to Low, High By pressing / select Equalizer.Press / or Off. It is not recommended to select High if listening button to change the Equalizer setting. In equalizer at high volume levels. There is a subwoofer output menu, the m
ページ10に含まれる内容の要旨
Press / button to set the Child Lock on or off.When Install Menu on is selected, the TV can only be controlled by the remote control handset. In this case the control panel buttons will not work. Hence, if one of these buttons is pressed, “Child Lock On” will be displayed on the screen when the Menu screen is not visible. INSTALL Language By pressing / button, select Language.Use Program Table / button to select the language. Program EXT2 Out Band By pressing / select EXT2 Output.U
ページ11に含まれる内容の要旨
Insert: Select the programme which you want to insert by APS is running... navigation buttons. Press the GREEN button. By navi- gation buttons move the selected programme to the decided programme space and press the GREEN but- ton again. Delete: UK 63.75 MHz To delete a programme, press the YELLOW button. Pressing the YELLOW button again erases the se- 6% lected programme from the programme list, and the programmes below shift one up. 63.75 MHz P 03 - C 04 APS (Auto Programming System) When you
ページ12に含まれる内容の要旨
Search By pressing / button, select Search. Press “ ” / “ ” button to start program searching.You can also enter the desired frequency via digit buttons when SOURCE search item is highlighted. Store TV By pressing / button, select Store. Press EXT-1 “ ”or “OK” button to store the adjustments. “Stored...” will be displayed on the screen. EXT-2 EXT-2 S Install menu in AV modes The following screen appears in the install menu: FAV INSTALL In source menu, highlight a source by pressing /
ページ13に含まれる内容の要旨
Zoom Modes Zoom mode can be changed by pressing the WIDE button. You can change the screen size according to the picture aspect ratio. Select the optimum one from the following ZOOM modes. 4:3 Note: Use to view a normal picture (4:3 aspect ratio) as this • In YPBPR and HDMI modes, while in 720p-1080i is its original shape. resolutions, only FULL mode is available. Auto: When a WSS (Wide Screen Signalling) signal, which shows the aspect ratio of the picture, is in- cluded in the broadcast signal
ページ14に含まれる内容の要旨
Fastext Teletext Your TV supports the 500 page Teletext system. When You can display Teletext information on your TV. Each the page number of any of the 500 pages in memory channel which broadcasts teletext, transmits a page is entered, the system will not search for the re- with information on how to use its teletext system quested page; instead it will display the page auto- (usually page 100). Depending on the TV channel, matically. If the requested page is not in memory, the teletext is tran
ページ15に含まれる内容の要旨
Then, press the “AV” button to select EXT1 or EXT2. Connect Peripheral Equipment Copy Facility High Definition Source selection for VCR recording. Your LCD Television is capable of displaying High • Select Feature menu. Definition pictures from devices such as a High Defi- nition Satellite Receiver or DVD Player. These devices • Select SCART 2 Out by pressing / button. must be connected via the HDMI socket or Compo- • For copying the picture that comes from the tuner, nent Socket. These sock
ページ16に含まれる内容の要旨
Tips Specifications Care Of The Screen TV BROADCASTING Clean the screen with a slightly damp, soft cloth. Do PAL/SECAM B/G D/K K' I/I' L/L' not use abrasive solvents as they may damage the TV screen coating layer. RECEIVING CHANNELS Poor Picture VHF(BAND I/III) UHF (BAND U) Have you selected the correct TV system? Is your TV HYPERBAND set or house aerial located too close to non-earthed CABLE TV (S1-S20/ S21-S41) audio equipment or neon lights, etc.? Mountains or high buildings can cause double
ページ17に含まれる内容の要旨
Appendix A: Aerial Connection Outdoor Aerial Connection Round 75 ohm coaxial cable 75 VHF/UHF Rear of TV Appendix B: Connect Peripheral Equipment HEADPHONE AUDIO AUDIO IN VIDEO IN (L) (R) VIDEO IN OUT IN OUT ANT.IN CAMCORDER SATELLITE RECEIVER ANTENNA English - 15 - ENG-26781W-1050UK-26 INCH 17MB22-(WO1 P 5C-WO PIP)-50103275.p65 02.04.2007, 12:42
ページ18に含まれる内容の要旨
Peripheral Equipment Connections S-VHS Input HDMI Input Video Input SCART 2 Audio Inputs s SCART 1 Headphone Component Audio Inputs s Audio Line Outs s Component Video Inputs (YBPbr) Power Cord Input RF Power On/Off Switch PCAudio Input Subwoofer out For Service Use Only 220V-240V AC~50 Hz POWER Note: Because FAV CVBS and SVHS Y are connected parallelly, the picture may blend if the two peripherals are used at the same time. Likewise, because SVHS C and SCART II R are connected parallelly, the p
ページ19に含まれる内容の要旨
Important Instruction For your own safety read following instruction carefully before attempting to connect this unit to the mains supply. MAINS (AC) OPERATION The wires in the mains lead are coloured in accordance with the following code : GREEN FUSE & YELLOW (Earth) (if there is earth cable) BROWN BLUE (Live) (Neutral) IMPORTANT As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follow
ページ20に含まれる内容の要旨
