ページ1に含まれる内容の要旨
OWNER’S MANUAL
26/32” TFT LCD DIGITAL TV WITH DVD PLAYER
L26HD35D
L32HD35D
ATTENTION
If you purchase a universal remote control from your local retailer, please contact the remote manufacturer for the
required programming code.
AIR/CABLE MODE SELECTION
When shipped from the factory, the Signal Type option is set to the “Cable” (Cable Television) mode.
If not using Cable TV, set this menu option to the “Air” position.
Before operating the unit, please read this manual thoroughly.
5 52K0101A_eng.
ページ2に含まれる内容の要旨
The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. C AUTION: TO REDUCE THE RISK OF ELECTRIC The exclamation point within an equilateral triangle is intended to SHOCK, DO NOT REMOVE COVER alert the user to the presence of (OR BACK). NO USER-SERVICEABLE important operating and mai
ページ3に含まれる内容の要旨
15) Apparatus should not be exposed to dripping or splashing, and objects filled with liquids, such as vases, should not be placed on the apparatus. 16) An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits, as contact with them might be fa
ページ4に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS (continued) 23) When you connect the product to other equipment, turn off the power and unplug all of the equipment from the wall outlet. Failure to do so may cause an electric shock and serious personal injury. Read the owner's manual of the other equipment carefully and follow the instructions when making any connections. 24) Reduce the volume to the minimum level before you turn on the product. Otherwise, sudden high volume sound may cause hearing or speaker
ページ5に含まれる内容の要旨
SAFETY PRECAUTIONS The unit emits heat when in operation. Do not place any covers or blankets on the unit, this may cause overheating. Do not block ventilation holes, or set up near radiators. Do not place in direct sunshine. When placing on a shelf leave 10 cm (4 inches) free space around the entire unit. 10cm 10cm Notes when mounting the LCD TV/DVD on a wall If the unit is to be mounted on the wall, contact the retailer where you purchased the LCD TV/DVD for advice, and have the equipment
ページ6に含まれる内容の要旨
Features LCD color TV With DVD/CD player Unique space saving design combines a 26/32” LCD color TV and a DVD/CD player. A DVD disc has much more capacity, but is the same size as an audio CD disc. The Picture/Audio quality of a DVD exceeds other software. The picture quality is higher than Super VHS video cassettes. The audio quality is higher than an audio CD. The DVD also has special options; audio language selection, subtitle language selection, or multi-angle, etc. The DVD PLAYER can play
ページ7に含まれる内容の要旨
Contents Before using your unit DVD operation Preparation .....................................................26 IMPORTANT SAFETY INSTRUCTIONS ...........3 Status display of disc ......................................26 SAFETY PRECAUTIONS .................................5 Playback procedure ........................................26 IMPORTANT NOTICE .......................................5 Special playback .............................................27 F eatures .............................
ページ8に含まれる内容の要旨
Disc Playable discs CAUTION: Disc type and logo mark content • Only the left types of discs can be played on this unit. DVD-ROM, CD-ROM, SVCD, CVD, VCD, etc. Audio cannot be played. + • 8cm discs can be played directly. If an 8cm disc DVD Video Video adapter is used it will cause errors. (moving • If you insert an irregular shaped disc, it may get pictures) stuck and cause a malfunction. • The use of a ring protector or other disc CD-DA Audio accessories will cause errors. • This unit is to
ページ9に含まれる内容の要旨
Location of controls Front Remote sensor POWER indicator Left side DISC slot EJECT button VOLUME +/– buttons CHANNEL /1 (PLAY) button CHANNEL /3 (STOP) button MENU button INPUT/ENTER button POWER button To display the menu screen. Press MENU button to display the menu screen. CHANNEL / buttons, VOLUME +/– buttons and INPUT/ENTER button can be used to select the desired setting during the menu screen operations. 9 52K0101A_eng.indd 9 52K0101A_eng.indd 9 3/12/09 3:10:45 PM 3/12/09 3:10:
ページ10に含まれる内容の要旨
Location of controls (continued) Rear side PC MONITOR IN jack VAR (VARIABLE) AUDIO OUT jack COAXIAL DIGITAL AUDIO OUT jack RF (ANT) IN jack AC INPUT jack HDMI 1/DVI IN jack COMPONENT IN jacks HDMI 2 IN jack LINE 2 VIDEO IN jack PC/DVI AUDIO IN jack LINE 1 IN jacks (VIDEO/S-VIDEO/AUDIO (L/R)) AUDIO (L/R) jacks (for COMPONENT IN and LINE 2 VIDEO IN) 10 52K0101A_eng.indd 10 52K0101A_eng.indd 10 3/12/09 3:10:48 PM 3/12/09 3:10:48 PM
ページ11に含まれる内容の要旨
Remote control POWER Power On/Off DISPLAY/– Call TV information Call DVD information Input “–” for digital channels TV/DVD Switch between TV/AV and DVD (EJECT) Eject a disc 0-9 Direct channel selection of TV Input setting Enter a password VOL +/– Adjust volume of TV MUTE Switch off the sound SLEEP Sleep timer SETUP/ TV mode - Display menu of TV TV MENU DVD mode - Call up initial setup mode DVD MENU Display DVD menu CH / Select channel of TV ▲▼◀▶ Cursor buttons ENTER Enter information in the me
ページ12に含まれる内容の要旨
Remote control (continued) Inserting Batteries Open the battery compartment Install two “AAA” batteries, Replace the compartment cover. 1 2 3 cover in the direction of the arrow. paying attention to the polarity diagram in the battery compartment. Operation • Aim the remote control at the remote sensor and press control buttons to operate. • Operate the remote control within a 30° angle on either side of Approximately 15 feet the remote sensor, up to a distance of approximately 15 feet. NOTE
ページ13に含まれる内容の要旨
Antenna connections If you are using an indoor or outdoor antenna, follow the instructions below that correspond to your antenna system. If you are using a Cable TV service, see page 14 for Cable TV connections. Combination VHF/UHF Antenna (Single 75 ohm cable or 300 ohm twin-lead wire) Connect the 75 ohm cable from the combination Antenna Antenna VHF/UHF antenna to the antenna jack. Jack Jack If your combination VHF/UHF antenna has a 300 ohm twin-lead wire, the use of the 300-75 ohm matchin
ページ14に含まれる内容の要旨
Cable TV connections This TV has an extended tuning range and can tune most cable channels without using a Cable TV Converter box. Some cable companies offer “premium pay channels” where the signal is scrambled. Descrambling these signals for normal viewing requires the use of a descrambler device which is generally provided by the Cable TV company. For subscribers to basic Cable TV service For basic Cable TV service not requiring a Converter/ Descrambler box, connect the 75 ohm Coaxial Cable
ページ15に含まれる内容の要旨
Main Menu Starting setup Picture >> Audio Channel Lock The Starting Setup menu appears the first time Setup you turn on the TV, and assists you to select the menu language, specify the Air/Cable setting, : Select ENTER:Set and program your channels automatically. 4 Press ▲ or ▼ to select “Setup”, then press ▶ or IMPORTANT: Make sure that the antenna or cable ENTER. TV system connection is made! 5 Press ▲ or ▼ to select “Language”. To turn on the TV, press POWER (POWER 1 Setup indicator on
ページ16に含まれる内容の要旨
CABLE CHART Press ▲ or ▼ to select “Add/Delete”, then press ▶ 4 The chart below is typical of many cable system or ENTER. channel allocations. Add/Delete Adding Channel >> Add/Delete >> Clear All >> : Select ENTER:Set Press ▲ or ▼ to select “Adding Channel”, then 5 press ▶ or ENTER. The new channel will be added into the channel memory. NOTE: 6 Press EXIT/CANCEL to return to the normal • It may take a few seconds for a digital channel screen. picture to appear on screen after being selecte
ページ17に含まれる内容の要旨
To select the video input source TV operation To view a signal from another device connected to your LCD TV, such as a VCR player, press INPUT SELECT, then press ▲/▼ or corresponding Number To turn on the TV, press POWER. 1 buttons (0-7), then press ENTER. You can select TV, (POWER indicator on the front of the unit Video 1, Video 2, Component, HDMI1, HDMI2, PC changes green. It may take approx. 10 seconds or DVD depending on which input jacks you used to for a picture to appear on scree
ページ18に含まれる内容の要旨
MUTE If the character which you desire appears, press Press MUTE to switch off the sound. The TV’s sound ENTER. will be silenced and “Mute” will appear on the screen. Repeat this step to enter the rest of the The sound can be switched back on by pressing this characters. button again or the VOL + or –. If you would like a blank space in the label name, you must choose the empty space from the list of SLEEP characters. To set the TV to turn off after a preset amount of time, When you fini
ページ19に含まれる内容の要旨
To register a password Genre: ALL : All Press SETUP/TV MENU in the TV mode. The TV 1 D : Dialogue menu screen will appear. L : Language S : Sex Press ▲ or ▼ to select “Lock”, then press ▶ or 2 V : Violence ENTER. FV : Fantasy Violence Select and enter your password (4 digits) using 3 Movie Rating Number buttons (0-9), then press ENTER. Movie Rating Lock G PG New Password _ * * * PG-13 R NC-17 X : Select ENTER:Set [0-9] : Select ENTER:Set G : All ages “ ” appears instead of the number.
ページ20に含まれる内容の要旨
To download the additional V-Chip rating system Closed Caption (when available) WHAT IS CLOSED CAPTIONING? 1 Press SETUP/TV MENU while on a digital This television has the capability to decode and channel. display Closed Captioned television programs. Closed Press ▲ or ▼ to select “Lock”, then press ▶ or 2 Captioning will display text on the screen for hearing ENTER. impaired viewers or it will translate and display text in another language. Use Number buttons (0-9) to enter your passwor
