ページ1に含まれる内容の要旨
26” /27”/32”/37” LCD Television
KF SERIES
USER MANUAL
KF271
50 .5mm
13 .8mm
5mm 5mm
10mm
丝 印430C
VOL . VOL . CH . CH . MENU SOURCE
2006060706
ページ2に含まれる内容の要旨
ENGLISH ENGLISH FCC Federal Communications Commission Statement This equipment has been tested and found to comply with the limits of a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
ページ3に含まれる内容の要旨
Warnings and Precautions Warnings and Precautions To prevent any injuries, the following safety precautions should be observed in the installation, use, servicing and maintenance of this equipment. Before operating this equipment, please read this manual completely, and keep it nearby for future reference. This symbol is intended to alert the user to avoid the risk of electric shock. This equipment must not be disassembled by anyone except qualified service personnel. WARNING This symbol is i
ページ4に含まれる内容の要旨
ENGLISH ENGLISH Warnings and Precautions ▪ Use and handle the power cord with care. Do not place any heavy objects on the AC power cord. ▪ Do not pull the AC power cord. Do not handle the AC power cord with a wet hand. ▪ Do not touch the power cord and antenna cable during lightning. ▪ Remove the plug from the wall outlet, if the equipment will not be used for a long period of time. ▪ Do not place, use or handle this equipment near water. ▪ Never expose the equipment to liquid, rain, or mois
ページ5に含まれる内容の要旨
Warnings and Precautions Outdoor Antenna Safety Instructions If an outdoor antenna is connected, follow the precautions below: ▪ An outdoor antenna should not be located in any area where it could come in contact with overhead power lines, or any other electric light or power circuits. ▪ When installing an outdoor antenna system, extreme caution should be taken to prevent contact with power lines. Direct contact with power lines may be fatal and should be avoided at all costs. Section 810 o
ページ6に含まれる内容の要旨
ENGLISH ENGLISH TABLE OF CONTENTS Federal Communications Commission Statement .......................... 1 Warnings and Precautions Important Safety Instructions ....................................................................................... 2 Antenna Safety Instructions ......................................................................................... 4 Chapter Introducing the LCD TV Key Features .............................................................................
ページ7に含まれる内容の要旨
Chapter Introducing the LCD TV Chapter 1 Introducing the LCD TV Key Features Various Audio/Video terminals for external equipment connection ▪ 2 set of composite A/V input terminals ▪ 1 set of S-VIDEO terminals ▪ 2 set of component Video input terminals ▪ 1 VGA/ Audio input terminal ▪ 1 HDMI/Auido input terminal ▪ 1 sets of Audio(L/R) output terminals ▪ 2 SPDIF output terminal (Optical x 1 /Coaxial x 1) ▪ 1 Headphone terminal The built-in TV tuner to receive HD ATSC ▪ This function allows t
ページ8に含まれる内容の要旨
ENGLISH Chapter Introducing the LCD TV Package Contents Make sure all of the following contents are included. LCD TV Bottom Stand / Screw Driver and 6 Screws KF271 50 .5mm 13 .8mm 5mm 5mm 10mm 丝 印430C VOL . VOL . CH . CH . MENU SOURCE Remote Control/ VIDEO Cable AAA Batteries x 2 POWER P.MODE SWAP PIP S.MODE MTS MUTE CAPTION SLEEP P.SIZE 1 2 3 4 5 6 7 8 9 JUMP 0 . AIR/CABLE VOL. CH. SOURCE GUIDE EXIT OK INFO MENU LIST FAV.CH TIMER FREEZE Power Cord AUDIO Cable Warranty Card P
ページ9に含まれる内容の要旨
Chapter Introducing the LCD TV Setting Up Your LCD TV How to install the TV Stand Follow the instructions below to install the TV stand: Open the box, and make sure all necessary parts are in the box. The package contains: KF271 50 .5mm 13 .8mm 5mm 5mm 10mm 丝 印430C VOL . VOL . CH . CH . MENU SOURCE Screw Driver Stand and 6 Screws LCD TV Cover an even stable surface with a soft cloth. Place the LCD TV unit face-down on the cloth.
ページ10に含まれる内容の要旨
ENGLISH Chapter Introducing the LCD TV Hold the TV stand and place it on the six screw holes on the back of the unit as shown. Use the screwdriver to tighten the six screws on the rear of the until the screw is firmly fixed in place. completed KF271 50 .5mm 13 .8mm 5mm 5mm 10mm 丝 印430C VOL . VOL . CH . CH . MENU SOURCE If you prefer to mount your LCD TV on a wall instead of attaching it to the stand, please reference the instructions included in the wall mounting kit (not included).
ページ11に含まれる内容の要旨
Chapter Introducing the LCD TV Use a supplied antenna cable to connect the VHF/UHF signal to the LCD TV’s ANT. terminal (refer to page17). Connect the AC power cord at the back of the TV and connect the power cord to wall outlet. Insert the 2 batteries supplied in remote control. Step Slide the back cover up to open the battery compartment of the remote control. Step Insert two AAA size batteries. Make sure to match the (+) and ( - ) ends of the batteries with the (+) and ( -
ページ12に含まれる内容の要旨
ENGLISH Chapter Introducing the LCD TV Your LCD TV Front/Right Side View and Controls LED The LED light indicates when the LCD TV is activated. KF271 50 .5mm 13 .8mm 5mm 5mm 10mm 丝 印430C VOL . VOL . CH . CH . MENU SOURCE IR Infrared Receiver VOLUME ▲▼ Adjusts the volume up and down. Selects the main-menu item and change values for items when in the OSD mode. VIDEO IN Connects to the composite VIDEO Video and Audio output jacks CHANNEL ▲▼ on external video equipment. Scans up and down
ページ13に含まれる内容の要旨
Chapter Introducing the LCD TV Rear View and Jacks VIDEO IN Connects to the composite VIDEO and AUDIO(L/R) output jacks on external video equipment. HDMI IN Connects the all digital AV equipment with HDMI connector.HDMI supports enhanced, high-definition video and two-channel digital audio. The AUDIO(L/R) of HDMI IN is for DVI connection. S-VIDEO IN Connects to the S-VIDEO and AUDIO(L/R) output jacks on external video equipment. VGA IN Connects the PC, or other AV equipment with VGA and
ページ14に含まれる内容の要旨
ENGLISH Chapter Introducing the LCD TV Your Remote Control This package includes a Polaroid remote that enables control of up to four devices. To select a device, simply select one of the following device mode controls: TV, CBL/SAT, DVD/VCR, or AUDIO. POWER Turns the LCD TV on and off SWAP Swaps between the main and sub window in PIP/POP mode P.MODE Selects picture mode: Vivid/Standard/ POWER Cinema/Sport/User/High-Bright PIP Turns PIP/POP on and off P.MODE SWAP PIP MTS
ページ15に含まれる内容の要旨
Chapter Installing the LCD TV GUIDE In HDTV mode, pressing GUIDE display the Program Guide on the screen EXIT Exits the OSD menu POWER ▲▼►◄ Cycles through OSD options and OK selects individual menu items. OK P.MODE SWAP PIP confirms option settings S.MODE MTS MUTE INFO Pressing once displays a variety of 0 information such as the current channel CAPTION SLEEP P.SIZE and the input source MENU Displays the OSD menu on the screen 1 2 3 For European TV system only 4 5 6
ページ16に含まれる内容の要旨
ENGLISH Chapter Installing the LCD TV Chapter 2 Installing the LCD TV Refer to the owner’s manual of any external equipment to be connected. When connecting any external equipment, do not connect any AC power cords to wall outlets until all other connections are completed. Connecting a TV Cable or an Antenna Antenna Connection The antenna requirements for good color TV reception are more important than those for a black & white TV reception. For this reason, a good quality outdoor antenna
ページ17に含まれる内容の要旨
Chapter Installing the LCD TV Use one of the following two diagrams when connecting an outdoor antenna. A: Shows how to use a VHF/UHF combination outdoor antenna. B: Shows how to use a separate VHF and/or UHF outdoor antenna. A. Combination VHF/UHF antenna VHF/UHF Antenna 300/75-ohm adapter (not included) VHF/UHF Antenna 300-ohm twin- lead cable 75-ohm coaxial cable B. Separate VHF and/or UHF antennas UHF Antenna Combiner 300-ohm twin- (not included) lead cable OUT IN 75-ohm VHF coaxial cabl
ページ18に含まれる内容の要旨
ENGLISH Chapter Installing the LCD TV Cable TV (CATV) Connection This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the National Electrical Code (NEC) that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building accurately, or as close to the point of cable entry as possible. Use of this TV for other than private viewing of programs broadcasted on UHF,
ページ19に含まれる内容の要旨
Chapter Installing the LCD TV METHOD A: Use a supplied antenna cable to connect the NTSC signal to the LCD TV’s TV CABLE terminal. TV HDTV CABLE AIR VHF/UHF IN B A METHOD B: Use a supplied antenna cable to connect the ATSC signal to the LCD TV’s HDTV AIR terminal. Connect the AC power cord at the back of the TV and connect the power cord to wall outlet. TV HDTV CABLE AIR VHF/UHF IN Press the button on the remote to turn on the LCD TV. Always disconnect the LCD TV from the main
ページ20に含まれる内容の要旨
ENGLISH Chapter Installing the LCD TV Connecting a VCR Rear of TV HDMI IN VGA IN AUDIO OUT YPbPr IN DIGITAL STEREO AUDIO AUDIO Y Pb Pr AUDIO OPTICAL TV HDTV CABLE AIR L R L R L R L COAXIAL Y Pb Pr AUDIO VHF/UHF IN L R L R L R R VIDEO AUDIO S-VIDEO AUDIO YPbPr IN VIDEO IN S-VIDEO IN AUDIO Cable S-VIDEO Cable AV Cable A B METHOD A: Use a composite cable to connect the VCR’s composite video/audio jacks to the LCD TV’s VIDEO2 IN jacks. METHOD B: Use an audio cable to connect the VCR
