ページ1に含まれる内容の要旨
Rear Observation System Package
Model RVMPKG3
Installation Manual
1 2
Features:
• Rearview Mirror with 4” LCD
• 2 Built in Speakers
• Rearview Camera Input
• Auxiliary Video Input
ページ2に含まれる内容の要旨
TABLE OF CONTENTS Cautions!…………………………………………. .……… 3 Preface………………………………………….……..…… 4 WARNING…………………………………….….…….. 4 Backing up vehicle……………………………….….….. 4 Packing list………………………………………….… 4 1. Installation Instructions….….…………………..…5 2. Signal Inputs…………………………………….… 6 3. Controls and Indicators……………………………6 SW1 and SW2…………………………………….……8 Specifications………………………………………………. 8 General……………………………………………….. 8 Maintenance………………………………………………... 9 Troubleshooting……………………………
ページ3に含まれる内容の要旨
Cautions! The product is intended to assist in safe driving and to allow the driver to have a broader rearview while the vehicle is in reverse. You, as the driver, are solely responsible for the safe operation of your vehicle and the safety of your passengers according to the country and their local traffic regulations. Do not use any features of this system to the extent it distracts you from safe driving. Your first priority while driving should always be the safe operation of your
ページ4に含まれる内容の要旨
Yellow Black Preface There is a blind spot that exists at the back of a vehicle while the vehicle is in reverse. Equipped with a camera, this electronic rearview mirror ensures safety by providing the driver with a clear and wide image of the area behind the vehicle whenever SW1 is pressed. WARNING: Backing up vehicle Do not back up vehicle while watching the mirror/monitor screen. Always look in the direction of vehicle motion. Use the mirror/monitor as an aid in safety confir
ページ5に含まれる内容の要旨
3 Adapter 4 Fastening Belts 5 Rearview Camera 6 Camera Cable 1. Installation Instructions (1) Mount the mirror/monitor onto the existing rearview mirror. a) Take the two belts and slide them into the slots on the top rear of the mirror with grooved side of the belt facing down.. Figure 1 b) Take the buckles and slide them into the lower slots on the rear of the mirror with the buckle facing down toward the strap. Figure 2 NOTE: The large opened rectangle on the buc
ページ6に含まれる内容の要旨
the rearview mirror onto the existing mirror from one side with one fixed belt. Then fasten the other belt on the other side of the mirror. To prevent the mirror from falling off, tighten the belts until secure to the factory rearview mirror on both sides. Figure 3 d) Cut off excess part of straps. (2) Wiring the System. 1. RED FUSED WIRE: +12 VDC ACCESSORY SOURCE Connect this wire to a source that is 12 volts when the Ignition key switch is turned on, and 0 volts when the ignit
ページ7に含まれる内容の要旨
end of the Main Cable. (2) Audio/Video Input Plugs (RCA) are located at the end of the Main Cable. By connecting video and audio signals with these plugs, the user can enjoy watching video, only while the parking brake is on. Figure 5 3. Controls and Indicators A B 1 2 H F G C D E Figure 6
ページ8に含まれる内容の要旨
Figure 6 illustrates the controls and indicators of the (RVMPKG3) rear view mirror: A: Rearview mirror B: 4” LCD panel C: Brightness Control knob D: Power indicator (Red when power is on) E: Volume Control Knob F: Switch 1 (see below) G: Switch 2 (see below) H: Speakers SW1 and SW2: SW1: Used to turn the LCD on/off . SW2: Used to toggle display image between rearview camera and DVD/VCR. Specifications General Power Supply 12VDC Power Consumption <10W Current Draw <500 mA
ページ9に含まれる内容の要旨
Contrast ratio 150:1 ° ° ° LCD Viewing Angle Top-10 , Bottom 30 , Left 45 , ° Right 45 Resolution 480×234 Video Format NTSC Display Format 4 : 3 Maintenance Your rearview mirror requires little care, however to maintain it in optimum condition follow the procedures below: 1. Keep your system away from excessive moisture, extreme heat or cold and magnetic fields. 2. Keep liquids away from the display. 3. Do not place external devices or other objects on the top o
ページ10に含まれる内容の要旨
No video signal appears while 1. Check the LCD Contrast (Brightness) reversing the car? control knob whether the contrast knob is set too low. 2. Check the rearview Camera lens. 3. Check the rearview Camera wiring and connection. 4. Check the cable from the rearview mirror is connected properly . Video image is not sharp enough? Clean the lens of the camera.
ページ11に含まれる内容の要旨
Figure 7
ページ12に含まれる内容の要旨
© 2003 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y. 11788 128-6927
