ページ1に含まれる内容の要旨
Responder LC Model 951
Remote Start Keyless Entry
Owner’s Guide
© 2008 Directed Electronics, Vista, CA
G4702P 2008-08
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Contents Government regulations .....................................................................................4 Warning! Safety first .........................................................................................5 What’s included ................................................................................................8 Important information ........................................................................................8 Your warranty.............................
ページ4に含まれる内容の要旨
Government regulations This device complies with Part 15 of FCC rules. Operation is subject to the fol- lowing two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection aga
ページ5に含まれる内容の要旨
Control Center must maintain a separation distance of 20 cm or more from the person’s body, Warning: compliance could void the user’s authority to operate this device. © 2008 Directed Electronics. All rights reserved. 5
ページ6に含まれる内容の要旨
Warning! Safety first The following safety warnings must be observed at all times: performed by an authorized Directed dealer. When properly installed, this system can start the vehicle via a command signal from the remote control transmitter. Therefore, never operate the system in an enclosed area or partially enclosed area without ventilation (such as a garage). When parking in an enclosed or partially enclosed area or when having the vehicle serviced, the remote start system
ページ7に含まれる内容の要旨
cy brake properly functions. Failure to do so can result in personal injury or prop- system inspected and adjusted by a qualified automotive shop bi-annually. Use of this product in a manner contrary to its intended mode of operation may result in property damage, personal injury, or death. (1) Never remotely start the vehicle with the vehicle in gear, and (2) Never remotely start the vehicle with the keys in the ignition. The user must also have the neutral safety feature of the vehicle
ページ8に含まれる内容の要旨
This product should not be installed in any convertible vehicles, soft or hard top with a manual transmission. Installation in such vehicles may pose certain risk. © 2008 Directed Electronics. All rights reserved. 8
ページ9に含まれる内容の要旨
What’s included The control module A remote start defeat toggle switch Window decals Your warranty registration Important information Congratulations on the purchase of your state-of-the-art remote start system. Due Installation of this product by anyone other than an authorized dealer voids the warranty. All dealers are provided with a preprinted dealer certificate to verify authorization. - ditional or replacement copies of this manua
ページ10に含まれる内容の要旨
Out of range notification If a command is issued from the remote, but the remote is beyond the range of the vehicle to receive the command, the remote will respond with an out-of range notification. If this occurs, the out-of-range icon displays on the LCD and the remote emits an error tones. Since conditions will vary in different areas (ie: Weather, RF interference, etc) range may be affected and require you to be closer to the vehicle for successful transmission. System maintenance The
ページ11に含まれる内容の要旨
outline stops flashing and the remote becomes operational while still displaying Warning! The temperature range over which the battery can be charged is 0ºC TO 45ºC (32ºF TO 113ºF). Charging the battery at temperatures outside this range may cause severe damage to the battery or reduce bat- Low battery indicator When the batteries are low on the 2-way remote it will emit two groups of beeps, the battery icon flashes and low battery is indicated on the screen. The remote then emits an a
ページ12に含まれる内容の要旨
Multi-car control capability You can use the Responder LC 2-way remote control system for two cars, with full command capability for both vehicles. To change the car to be operated: 1. button for 3 seconds or until the remote beeps. The car or 2. Change Car: While in car selection mode, press and release the button to scroll between car and . The car icon flashes to indicate the car that can be operated. 3. Select the car number you want to operate, and then pres
ページ13に含まれる内容の要旨
Responder LC 2-way 1 4
5
6 7 2 3 8 Feature Description 1 LCD (2-way) 2 Lock button Press for one second to arm. 3 Unlock button Press for one second to disarm. 4 Press and hold for 1.5 second to activate optional trunk release. 5 Remote start button Press for one second to activate remote start. 6 Function button Allows access to programming and modi- fies operation of the other buttons. 7 Charge Port (2-way) Plug in the battery
ページ14に含まれる内容の要旨
LC 1-way companion 10 8 2 9 3 5 4 6 See call out table for 2-way Transmitter configuration Direct Access Level Button Lock Silent Lock Unlock Silent Unlock Car Finder Remote Start Reset Timer Mode Smart Start Rear Runtime Defogger Trunk Release AUX 1 AUX 2 AUX 3 A U X Function Shift Cabin Runtime Temperature Check request (2-way only) (2-way only) © 2008 Directed Electronics. All rights reserved. 14
ページ15に含まれる内容の要旨
Using the system Please note the screen shot to the right of a feature indicates what the display looks like when this feature is activated. Lock Command: Press one time to Lock Feedback: Lock Icon appears, and parking lights flash once. Notes: system and activate the panic feature. Details: - tion is installed), and the parking lights flash one time. If the power door locks have been connected, the doors lock. When panic is activated the horn horns if connected an
ページ16に含まれる内容の要旨
Unlock Command: Press one time to Unlock Feedback: Unlock icon appears. Notes: The vehicle horn, honks two-times and the parking lights flash two-times. The door locks (if connected) unlock, the 2-way remote beeps two-times and the LCD displays the icon. Unlocking without the honk (Silent Lock) Press the button on the remote once, and then press the button. The system unlocks without the confirmation honk. The parking lights flash once. The 2-way remote displays the icon. If no unl
ページ17に含まれる内容の要旨
Points to remember: If the hood is open or if the brake pedal is pressed, the vehicle will not remote start. The remote start shuts down: When the brake pedal is pressed. The hood is opened. When the remote start command is sent again from a remote control. To drive your vehicle after it has been remote started: 1. 2. Insert the ignition key and turn it to the ON position. 3. Now, step on the brake. The remote control will play the remote start shutdown tone. You have now taken direct
ページ18に含まれる内容の要旨
A U X Aux Command: Press and hold for 1.5 seconds to acti- vate the Trunk Release. Feedback: The trunk icon appears and the remote plays a short tone. Notes: This is an optional feature. See your default screen displays the trunk icon and installer using the Bitwriter programming tool. Function shift Command: Press 1 to 4 times. (See Transmitter configuration table) Feedback: - mand received. Notes: Each Press then release, shifts the function of th
ページ19に含まれる内容の要旨
Valet mode Command: Press two-times and then . Feedback: - Notes: If the system is already locked the remote - is displayed but the doors stay locked. Turn the ignition key on and then off. Note: © 2008 Directed Electronics. All rights reserved. 19
ページ20に含まれる内容の要旨
Car finder Command: Press three-times and then . Feedback: Remote beeps 1 short beep, the vehicle emits 1 long horn honk (if connected), and the parking lights flash 10 times. Notes Cabin temperature Command: Press one time, then Hold for 1.5 seconds. Feedback: Screen will display current in cabin tem- perature. Notes: Cabin temperature is displayed on the remote. Silent Lock Command: Press one- time and then press Feedback: Screen changes to the loc
