Chamberlain 40の取扱説明書

ページ1に含まれる内容の要旨

®
Keyless Entry System
Models 40 and 65
WARNING WARNING
To avoid SERIOUS INJURY or DEATH from electrocution, disconnect
power to opener BEFORE proceeding.
CAUTION WARNING
KEYBOARD
CONSOLE
The Keyless Entry System consists of a keyboard and a console. The keyboard sends a coded signal from outside the garage. The
console fastens to an inside garage wall. It receives the 4-digit programmed coded signal and starts the door opener.
The Keyless Entry System will work with most Genie “Push Twice to Op

ページ2に含まれる内容の要旨

NOTE: If your garage has a built up jamb, drill the hole 2" deep. STEP 4: Position console on an interior garage wall Then, on inside edge of jamb, drill a second hole into first hole to approximately one foot from outside edge of door. Fasten complete access. with (2) screws provided. Run bell wire up wall and across ceiling to garage door opener terminals. Use insulated staples to secure wire. On current line Chamberlain models, connect wire to red and 1/8" Pilot Hole white opener terminals. O