ページ1に含まれる内容の要旨
Model APS-45N
Owner's Manual
4 Button Remote Keyless Entry System
With Two Auxiliary Outputs
FEATURES:
2 Four Button, RF Transmitters
Four Channel Code Learning Receiver
Remote Panic In All Modes
Built-In Parking Light Output
LED Status Indicator
Ignition Door Locking/Unlocking
Horn Output
OPTIONS:
Remote Trunk Release
Remote Power Window Control
Remote Garage Door Interface
Remote Engine Starter
Starter Interrupt
Siren
Access Guard / 2 Step Unlock
Illuminated Entry
ページ2に含まれる内容の要旨
Your Keyless Entry System has many features and available options some of which must be selected at time of installation. For your reference, the list on the back page of this manual shows what features and options have been installed with this particular sys- tem. Consult your installing dealer for options that may have been installed and are not listed. REMOTE DOOR LOCKING - ACTIVE 1. Turn the engine off, exit the vehicle, and close all doors. 2. Press and release the lock button of your key
ページ3に含まれる内容の要旨
Note: If the passive arming mode was selected at time of installation, the dash mounted LED will start flashing rapidly indicating that the system is rearming. Opening any door will suspend the automatic arming. OPTIONAL ACCESS GUARD ( Two Step Unlock ) If the optional 2-step unlock feature was installed, then only the driver's door will unlock after the first press of the unlock button. If you want to unlock all doors, you can simply press the unlock button of the keychain transmitter a secon
ページ4に含まれる内容の要旨
To disengage the panic feature before the 30 seconds are up, press and hold either the lock or unlock button of your keychain transmitter for 3 seconds or press the option button momentarily. The doors can be unlocked or locked while in "panic" mode by momentarily pressing the lock or unlock button respectively. ADDITIONAL REMOTE FUNCTION CHANNEL 2 The system has an additional output, (Channel 2) , that can be connected to a number of different optional accessories. Some of the more common use
ページ5に含まれる内容の要旨
PROGRAMMING TRANSMITTERS: At times it may become necessary to program replacement or additional transmitters for use with your system. To do this: 1) With the system unlocked or disarmed, turn the ignition key to the on position. 2) Press and release the Program/Override push-button switch three times The unit will flash the parking lights and or beep the horn once to indicate that the system is in the transmitter program mode. The LED will also flash one time pause, one time pause, etc... ind
ページ6に含まれる内容の要旨
DELETING TRANSMITTERS FROM YOUR SYSTEM: It may be necessary to delete a lost transmitter or to reprioritize a transmitter that is programmed to your system. To remove a transmitter that has been programmed in your system: 1) Enter the transmitter program mode of channel 1 as indicated above. 2) Press and hold any transmitter button that has not been programmed into channel 1 until you hear a chirp, then release and immediately press the same button a second time until you hear a long chirp foll
ページ7に含まれる内容の要旨
ORDER FORM FOR 91P Attention: Transmitter Ordering Department Important: To help us expedite your order, please print all of the information legibly and mail this form and your payment according to the instructions below. Note: Transmitter model number found on back of case. 1) Transmitter Model Number_____________________ 2) Name: _______________________________________ 3) Address: ______________________________________ 4) City: ________________ State: _____ Zip Code: ________ 5) Telephone
ページ8に含まれる内容の要旨
Unlock 2 Option Button Lock 1 Option Button Unlock 2 Lock 1 Unlock 2 Option Button Lock 1 Unlock 2 Option Button Lock 1 Unlock 2 Option Button Lock 1 Option Button Unlock 2 Lock 1 APS-45N SYSTEM FUNCTIONS AT A GLANCE LED INDICATORS: RAPID FLASHING = PASSIVE ARMING SLOW FLASHING = ARMED OFF = DISARMED ON SOLID = VALET MODE OPTIONAL VEHICLE HORN OR SIREN CHIRP INDICATION: 1 CHIRP = LOCK / ARM 2 CHIRPS = UNLOCK / DISARMED CONTINUOUS = PANIC MODE ALARM PARKING LAMP INDICATIONS: 1 FLASH = LOCK / ARM
