ページ1に含まれる内容の要旨
VKE-103
REMOTE KEYLESS ENTRY
OWNER’S MANUAL
© 2006 Astroflex Electronics, Inc. - All rights reserved
®
2006 ASTROFLEX ELECTRONICS
ページ2に含まれる内容の要旨
Table of contents What is included...................................................................................................................................................................... 1 Important information............................................................................................................................................................ 1 System maintenance ...........................................................................................
ページ3に含まれる内容の要旨
What is included The control module Super heterodyne receiver Two three-button transmitters A status LED indicator light ® A push-button Valet switch Important information Congratulations on the purchase of your keyless entry system. Due to the complexity of this system, it must be installed by an authorized dealer only. Installation of this product by anyone other than an authorized dealer voids the warranty. By carefully reading this Owner's Guide prior to using your system, you
ページ4に含まれる内容の要旨
Transmitter functions The receiver uses a computer-based learn routine to learn the transmitter buttons. This makes it possible to assign any specific transmitter button, or combination of buttons, to any receiver function. The transmitter initially comes programmed with the Standard Configuration, but may also be customized by an authorized dealer. The transmitter buttons indicated in all of the instructions in this manual correspond to a Standard Configuration transmitter. STANDARD CONFI
ページ5に含まれる内容の要旨
off. After the ignition has been turned off, the status LED flashes slowly to indicate that the AED will be activated then, the LED flashes normally when AED has been activated. ® Note: For AED to be effective, the Failsafe Starter Kill relay must be installed. UNLOCKING Pressing for one second unlocks the doors (if connected). The horn will honk twice (if connected) and the parking lights will flash twice to confirm reception of the command. The ® optional Failsafe Starter Kill will b
ページ6に含まれる内容の要旨
® To enter or exit Valet Mode: 1. Turn the ignition on. 2. Turn the ignition off. ® 3. Press and release the Valet switch within 10 seconds. The status LED will light steadily if you are entering ® ® Valet Mode and will turn off if you are exiting Valet Mode. PANIC MODE If you are threatened in or near your vehicle, you can attract attention by triggering the system with your transmitter. Just press or for more then five seconds to enter Panic Mode. In Panic Mo
ページ7に含まれる内容の要旨
Dome light Supervision Activated or Deactivated: The dome light will illuminate for 30-seconds after turning the ignition off or when disarming the system with the remote transmitter. Glossary of terms Control Unit: The “brain” of your system. Usually hidden under the dash area of the vehicle. It houses the microprocessor that monitors your vehicle and controls all system functions. LED: A light mounted at a discretionary location inside the vehicle. It is used to indicate the status of
ページ8に含まれる内容の要旨
QUICK REFERENCE GUIDE To lock the system press for one second. The doors will lock (if connected). The LED will begin to flash. The Failsafe® Starter Kill will prevent the vehicle’s starter from cranking if it has been installed. Locking (1) The vehicle’s horn (if connected) will honk and the parking lights will flash once to confirm locking of the system. To unlock the system press for one second. The doors will unlock (if connected). The Failsafe® Starter Kill will be deactivated
